. For the network in Fig. 14.86 and the applied source: a. Determine the source voltage vs. b. Find the currents i₁ and 2. i, = √2 24 sin (10³t + 30°) i₁ i2 + is (1) Us 120 mH 5 4₁ ell 60 mH L

Q: 1. A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is…

A:

Q: 04 Find the P.Q. E ands of the given systent when delivers its rated land. The otion is decrease by…

A: Solution- I = 1∠-cos-10.8I = 1∠-36.87° puE = V+jIXsE = 1∠0°+j0.7×1∠-36.87°E = 1.526∠21.523° pu E =…

Q: QUESTION 5 An electron and a mystery charge 5.3 x 10^-11 m apart attracts each other with a force of…

A: Given: Electron charge, q1=1.6×10-19 C Unknown charge, q2=? Force between charges, F=2.61×1012 N…

Q: The minimum sampling period of the signal m(t)=5cos(300πt)cos(500πt)is

A:

Q: A power amplifier has an input of 90mV across 10K ohm. The output is 7.8V across an 8 ohm speaker.…

A:

Q: We need a three-stage space-division switch with N = 100. We use 10 crossbars at the  first and…

A: The Given is three- stage space- division  The N is 100, At the first and third stages, use 10…

Q: In the transverse electromagnetic TEM mode....... ********** Ez = 0, Hz #0 Ez #0, Hz = 0 Ez = 0,…

A: We need to select correct option for TEM mode .

Q: . Determine the Fourier series of full wave rectified signal whose amplitude is Vm and period is π

A:

Q: In a rectifier diode labeled as IN4003, What designate the digit "400" as matter of technical…

A: INC4003 diode is general purpose diode which is mainly used in rectifier circuit where AD voltage…

Q: 6. You have a complicated wire structure with an area of 1 cm², and an average interior magnetic…

A: Given data, Area, A=1 cm2 Magnetic field, B=10-9 T

Q: To prevent mal-operation of differentially connected relay while energising a transformer, the relay…

A: To prevent mal-operation of differentially connected relay while energising a transformer, the relay…

Q: A resultant current is made of two components: a 10 A D.C. component and a sinusoidal component of…

A:

Q: a) For the Circuit shown calculate the value of C if the resonant frequency is 5000 vad /sec 5 0-6…

A: a) To find the value of C if the resonant frequency is w = 5000 rad /sec

Q: Provide at least 3 Examples of Control Systems Models or Representations and its corresponding…

A: Following control system models are mostly used- Differential equation model Transfer function…

Q: Ex. 1: Determine the PSM (plug setting multiplier) of a 5A, 2.2 sec over current relay having a plug…

A:

Q: A 3-phase, star-connected alternator generates 6,360 V per phase and supplies 500 kW at a p.f. 0.9…

A: Delta Connected system VLine= VphaseIline=3 ×Iphase Star connected system VLine=3 VphaseIline=Iphase

Q: • Construct 4-to-16 line decoder with 3-40-8 a line decoders with enable and external gates.

A: We need to design the given decoder.

Q: 10-A heater is rated as 230 V, 10 KW, A.C. What is the value 230 V referring to? 11- Sine wave…

A:

Q: The radial component of the radiated power density of an antenna is given by Wrad = Wr ar= A0…

A: (a) Radiated power can be calculated as,

Q: 12/60° V 592 € j2 52 j3 92 12.12 For Practice Prob. 13.2. j692 =-449

A:

Q: * If X= (1100101)excess-3 X=(110000)gray O X=(65)decimal O X=(1000001)binay O X=(101)octal O none of…

A:

Q: What is the correct relation between the functions f1, f2 and f3? if f₁(a, b, c) = Σm(0,1,5,6),…

A:

Q: A transformer has 1200 primary turns and 200 secondary turns. The primary and secondary resistances…

A: It is given that: N1=1200N2=200R1=0.2ohmR2=0.02ohmX1=1.20hmX2=0.05ohm

Q: 3- A car travels 200 km in- velocity in: 61.

A:

Q: Q31 27, and draw the impedance diagram. I, VVV in the phaser domain, and draw the phaser diagram.…

A: Series combination of impedances: Z=Z1+Z2+Z3

Q: The main difference between a register and a counter is a register has no specific sequence of…

A: In this questions we need to tell about the main difference between register and counter.

Q: The first flip-flop of a ripple counter is clocked by none of the mentioned logic 1 O the Q' of the…

A:

Q: unctions

A:

Q: Q1/ For the circuit of Fig. (1) a. Determine V2 using Kirchhoff's voltage law. b. Determine I. c.…

A:

Q: . Which of the following conditions limit the alysis of quiscent point (Q-point)? A. The circuit…

A: Quiescent point or Q- point- When a line is drawn joining the saturation and cut off points, such a…

Q: Construct the TT-model of the transistor with all parameters labelled and evaluated.

A: The Given Transistor parameters of β=130 and VBE=0.7V The Given Network diagram is

Q: We need a three-stage space-division switch with N = 100. We use 10 crossbars at the  first and…

A:

Q: 2. Current is defined as the rate of charge. .flow. If a charge of 0.0065 colombs passes a given…

A: This question belongs to circuit theory . It is based on the concept of formula of current . Problem…

Q: Q.5: Correct any five sentences using suitable scientific phrases. 1. At any resonant circuit the…

A: Z parameterV1=Z11 I1 + Z12 I2V2=Z21I1+Z22 I2Y parameterI1=Y11 V1 + Y12 V2I2=Y21V1+Y22 V2

Q: A fluid system has two sensors, a pressure sensor and a flow sensor. The pressure sensor has two…

A: Since it is asked to solve only subparts (3-c) and (3-d),so we are solving those two subparts only.…

Q: a) For the Circuit shown calculate the value of C if the resonant frequency. is 5000 vad /sec

A:

Q: b) For the Circuit shown the switch has been in position for along time, at t-o the switch is moved…

A: This question belongs to circuit theory . It is based on the concept of transient and steady state…

Q: Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…

A: Given circuit:-

Q: * The register is a type of combinational circuit O sequential circuit O latches O CPU O none of the…

A:

Q: List the reasons why the modulation is desired in a wireless communication system considering the…

A: Modulation is a technique that is used in carrier wave to transmit some information at low…

Q: For the circuit shown in figure (2): Calculate the current and voltage for the resistor R using…

A:

Q: In the circuit shown below, the operating point is chosen such that Ic = 2mA, VCE=3V. If Re=2.2 k2,…

A: Given data : Collector resistance RC=2.2kΩ Supply voltage VCC=9V Current gain β=50 Base collector…

Q: فرق الطور بين إشارات الجهد والتيار في الشكل *

A:

Q: If a summing point is placed before a take off point, they will be represented ___ a. one branch…

A:

Q: The first flip-flop of a ripple counter is clocked by the Q of the last flip-flop O external clock O…

A: Ripple counter is also know as asynchronous counter.

Q: Fig (2) B-Determine the resistance if 4-10¹6 electrons pass through the imaginary surface, the time…

A: B. The charge due to the given number of elections is, Q=nee=1.6×10-19 n=4×1016Q=4×1016×1.6×10-19…

Q: PRACT Determine the phasor currents I, and I2 in the circuit of Fig 1.G. 12. 2

A:

Q: А [02] ja A resistance R₁ of 5kr. is shunted by Conductance G. of 50 μS. The combinator draws. a…

A:

Q: The open loop transfer function for unity feedback system G(s) = (8 (s+9) (s+10)) / ((s+11) (s+12)…

A: Given: Open loop transfer function Gs=8s+9s+10s+11s+12s+13 Unity feedback, Hs=1 Step input, Rs=100s…

Q: (2). Current is defined as the rate of charge flow. If a charge of 0.00651 colombs passes a given…

A: