. Use Kirchhoff's Laws to find the branch currents indicated in the following networks:

Q: Consider a pulse function f(x) = 1 for −1 ≤ x ≤ 1 and f(x) = 0 elsewhere. Show that the Fourier tran...

A:

Q: For the circuit in the figure obtain the contribution of the sources of (Y)V and (X)V to vz. Note: V...

A: This problem comes under electrical network theory . It is related to super position theorem . In th...

Q: 1. Use Kirchhoff's Laws to find the branch currents indicated in the following networks:

A: In this question,  Find the all unknown current as shown in the circuit using the KCL and KVL.   

Q: Find the branch current at both capacitors and find Io

A: Conductor-Materials which have free electrons in valence which can flow when comes under any externa...

Q: A capacitor branch having a ratio of xC to RC of 5 ohms is paralleled with an impedance consisting o...

A:

Q: Summary of instrumentation amplifier

A: We need give the summary of an instrumentation amplifier.

Q: Please draw an 8 Bit adder using the Sum and Carry.

A:

Q: DFT

A:

Q: x(1) = 4(t + 2)u(t + 2) – 4tu(1) – 4u(t – 2) – 4(1 – 4)u(1 – 4) + 4(t – 5)u(t – 5). %3D find and ske...

A:

Q: What is the value of the current (lo) across the capacitor? 12 ww + 10/0° V + -jl 2 V. a. 42-0° A b....

A: Note :  Please note that all the given options are incorrect, even I have verified it by calculating...

Q: Use R1 = 330Ω, R2 = R3 = 1kΩ Construct the circuit below using Proteus Simulation Software and meas...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: 70 30

A:

Q: A 7.5 hp, 220 V, 19 amp, 4-pole, Y-connected, Design Class C, three-phase induction motor was tested...

A: Given information about a three-phase 7.5 HP, 220 V, 19 amp, 4-pole, Y-connected, Class C, induction...

Q: A circuit consisting of a resistor in series with a capacitor takes 100 watts at a power factor of 0...

A: Resistance: It is a property of a material that resists the flow of the current and its unit is the ...

Q: Based on your understanding of resolution, why do you think laser radar (lidar) is more popular than...

A: Optical fibers are used for the communication purpose. Optical fiber have better bandwidth and give ...

Q: 70- 50 30 -30 -50 -70

A:

Q: Hey, please reply as soon as posible. Please read what is asked. 1) For the circuit in Figure and u...

A:

Q: Problem 2 Draw the waveform of vo of the op-amp circuit shown for the given waveform of vi. Label al...

A:

Q: 4. Determine the output waveform of the network for the input indicated (USE 1ST APPROXIMATION) *

A:

Q: Discussion: 1. Compute the Band Width and Power of AM-SSB? 2. Which side the filter is select (upper...

A: We need to tell about amplitude SSB modulation

Q: 2. For the following circuit assume r 8.7 I6 V a. Draw the small signal equivalent circuit. b. Find ...

A: Brief description :  Here they have mentioned a common collector amplifier circuit. The characterist...

Q: For the circuit in Figure 1, set up the supernode equation. Response format: Ava ± Bvb ± Cvx = D 2)...

A:

Q: 7. 4. 20 40 60 80 100 120 140 160 1

A:

Q: Analyze AC network using Norton's Theorem. Find V0 indicated in the following networks. PS: Show com...

A:

Q: 13. To ensure an adequate factor of safety in the of a shaft with standard keyway, the key width I b...

A: Key : It is a piece of mild steel inserted between the shaft and hub or boss of the pulley to connec...

Q: 4. Given (a) x(t) = 6t² ; (b) x(t) = t³/4 ; (c) x(t) = 4/ (s²+16). Obtain the Laplace transforms.

A: It is given that: a)xt=6t2b)xt=t34c)xt=4s2+16

Q: Dout Select

A:

Q: A 400V, 3-phase Induction motor has input power of 12 KW and operates at power factor of 0.87 laggin...

A: Given: Pin=12 kWcosϕ=0.87 laggingη=96%  

Q: Voice information with a frequency range of 0.3 ~ 4 kHz is sampled according to Nyquist requirements...

A: Given, Frequency range, fm=0.3 kHz-4 kHz Quantization level, L = 256 Modulation used, M = 16 Factor ...

Q: Example: A 3-6 transmission line 250 km long has the following constants: Resistance/phase/km 0-16 2...

A: Answer -

Q: 4. Let A = (Q, E, 8, qo, F) be the DFA given by the state diagram: Construct an NFA that accepts the...

A: Introduction -  NFA - It stands for non-deterministic finite automata. At every transition stage, th...

Q: Following the analysis applied to the half-wave rectifier with capacitor filter, show how to arrive ...

A: A rectifier circuit is used to rectify the AC power generated by this source to the DC  power that i...

Q: positive clipper circuit

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is revers...

Q: If the midrange voltage gain of a certain amplifier is 100 dB, what is the gain at cutoff frequency?...

A:

Q: +120 V ... 2:1 ideal diodes C = 10 uF RL= 10 kohms -120 V fin = 60 Hz Power-supply filter Determine ...

A:

Q: ) For the circuit in Figure 1, set up the supernode equation. Response format: Ava ± Bvb ± Cvx = D ...

A:

Q: A si diode has reverse saturation current of 2.5 micro amp at 300k find forward voltage for a forwar...

A: The equation of current and voltage in forward biad condition is given as: ID=I0eVηVT The value of d...

Q: Vx (V) | Lx (сm) 21 22 0.4 10 23 1 30 24 1.5 50 25 1.8 60 26 2.1 70 27 2.7 90 28 29 2. Using Table 6...

A:

Q: 50V 10 N Va 30 V 102. 2i 102. GA

A: The solution is given below

Q: 9.16. A continuous-time signal x(t) is sampled at a 10-Hz rate, with the resulting discrete-time sig...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 2. Prove the following continuous time Fourier transform relationship. [1 -7<N< T Continuous Time si...

A:

Q: Determine all the roots of ?^8 − 2?^4 + 1 = 0

A: Given, We have polynomial. We have to find the roots. Please find the below attachments for the clea...

Q: Determine the source voltage and write the answer in polar form.

A:

Q: Determine the total resistance and the current along 3 ohms in downward direction. 50V

A: The electrical circuits have different ways of representation. T-network and pi-networks are the dif...

Q: Determine a.  total impedance     b.,. current Ip   and  c. total power drawn by the circuit

A:

Q: 1. How can you draw the spectrum of EM?

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Determine I, using Norton Theorem. 4 12 ele In -j30 ww 82 ww 10/0° V 2/-90 A 10 2

A: The solution is given below 

Q: 50V 52 Ve 10N Va I+ GA 10Ω. 30 V 10Ω.

A: Kcl states that algebraic sum of currents at any node is equal to zero

Q: A capacitor has a charge of 20.5 C when connected with a 24V battery. Determine the capacitance.

A:

Q: Two loads are connected in parallel to a source of emf whose voltage is (110 + j63.5). If the branch...

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.