018. An AC waveform is shown in figure B3. 4 3 1 10 20 40 50 60 70 do 100 110 Time (ms) -1 -2 -3 -4 -5 Figure B3 i) For the above waveform, determine a. Peak-to-peak voltage b. Time period c. Frequency ii) For the above waveform, determine a. Peak Factor b. Form Factor

018. An AC waveform is shown in figure B3. 4 3 1 10 20 40 50 60 70 do 100 110 Time (ms) -1 -2 -3 -4 -5 Figure B3 i) For the above waveform, determine a. Peak-to-peak voltage b. Time period c. Frequency ii) For the above waveform, determine a. Peak Factor b. Form Factor

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Table Q18. Peak to Peak Voltage 12V Time for ten cycles 20 ms Sketch the waveform and determine…

Q: 4. a. For the waveform shown in figure5, determine (i) Peak value (ii) (iii) (iv) the peak-to-peak…

Q: V (Volts) 12V 30 18 42 t (ms) -12V

A: The waveform is shown below: (i) Peak value is the value of the maximum displacement of the wave…

Q: The waveform displayed on an oscilloscope is as shown in Figure. Determine: (i) amplitude of…

Q: 4. The waveform displayed on an oscilloscope is as shown in Figure . Determine: (i) amplitude of…

A: Amplitude is the maximum value. i) waveform A required 14 division along the y-axis(V axis) to reach…

Q: Example 6 The EMF and current waves of a circuit having resistance only are e=170sin2 / 60t and…

A: We are authorized to answer only three subparts at a time since you have not mentioned which part…

Q: A sinusoidal waveform is displayed on a c.r.o. screen. The peak- to-peak distance is 5 cm and the…

A: CRO

Q: 18. For the periodic waveform shown in Figure B3 20 40 50 Time (us) Figure B3 Compute the following:…

A: x(t) 2.55 x 10-6t 0 < t <5 μs-2.55 x 10-6t +5 5μs ≤t < 15μs2.55 x 10-6t…

Q: Explain the half wave rectification and also calculate its rms value of current and voltage.

Q: Station 3 1. Draw an accurate graphical representation of the waveform on template below. 3.…

A: Given the waveform in oscilloscope as shown below: 1. We need to draw an accurate graphical…

Q: voltage wave is given by v=100 sin 314t. how long does it take this waveform to complete one fourth…

Q: The given function of voltage (in volts) is one period of a periodic waveform, determine the + peak,…

Q: The term used to describe a dc value (other than zero) that acts as the reference for a sine wave…

A: An ac sinusoidal signal has both positive and negative half cycles and zero average value.

Q: An AC waveform is shown in figure B18. Figure B18 For the above waveform, determine a. Peak-to-peak…

Q: If the peak to peak voltage is equal to 20 . How much the RMS value of the voltage!?

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: The peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 5 cm and the 'volts/cm'…

A: Need to tell about peak to peak voltage of given signal.

Q: What is the peak voltage across R2? b) What is the RMS value of I1?

Q: Q.1 For the given of Figure: a) Find the period T. b) How many cycles are shown? c) Find the…

A: The waveform is shown below: a) Since the frequency of the waveform is known, the period T of the…

Q: Problem 3 Sketch the following waveforms: a. 50 sin(wt + 0°) b. 5 sin(wt + 120°) c. 2 cos(wt + 10°)…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms…

Q: The sinusoidal waveform displayed by the CRO is shown in Figure below. The 'time/cm' switch is on 2…

A: Given:-Time/cm=2ms/cmvolts/cm=5 vcm

Q: Referring to Figure 5 above, given power R1 = 40 W, power R2-20 W, power R3 = 20 W, power R4-40 W,…

A: Time taken by one cycle = (1/frequency of the circuit).

Q: For the waveform shown in figure 1 , determine i - preak value ii - the peak-to-peak voltage…

A: given waveform

Q: iii) A sine waveform with following specifications. RMS voltage 161.4V Time for ten cycles 0.02s…

A: Given values are =

Q: (i) Amplitude of waveform Q = Answer and unit for part 1 (ii) Peak to peak value of waveform P =…

Q: The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak…

A: The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak…

Q: n AC waveform is shown in figure B3. 2 10 20 40 50 70 100 Time (m -1 -2 -3 -4 -5 Figure B3 For the…

Q: Question: The symmetrical saw tooth waveform voltage as shown in figure is applied to an average…

A: Form factor and Error is calculated as shown below

Q: find the following : a) the peak voltage Vp b) the Peak to bottom Vpp c) the Time period d)…

Q: 148 Determine the rms value of the voltage waveform shown in Figure vt) WW 4. 18 24 12

Q: If the peak to peak voltage is equal to 10. How much the RMS value of the voltage?

A: GIVEN VP-P=10 V SO VP = 10/2 =5 V

Q: Find the average and rms value of the waveform shown in Figure-2. Em 2x 3x at- Figure-2

A: Given

Q: 1. Formulas of Average Value and RMS Value of a waveform

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: 1) A phase modulator has kp=2 rad/V. What RMS voltage of a sine wave would cause a peak phase…

A: Given Phase sensitivity and phase deviation,we need to determine the RMS voltage. Please find the…

Q: For the waveform shown in Figure determine for each (i) the frequency ii) the average value over…

A: Frequency is the reciprocal of the time period average value = area under the curve / base length…

Q: Andisis for voltage, impodences, curvents and Wave forms c

Q: B1. The sinusoidal waveform is displayed by the CRO is shown in Figure below. The 'time/cm' switch…

A: Cathode ray oscilloscopes (CRO) are used to observe the time variation of signals. A CRO has a…

Q: A. In a series circuit, if the AC voltage is measured across the AC voltage source, will there be…

Q: IV. Sketch the following waveforms with the horizontal axis scaled in degrees: a. v1 = 80 sin(wt -…

Q: An AC waveform is shown in figure B3. 4 1 10 20 40 60 70 0 do 100 110 Thne (ms) -2 -3 4 -6 Figure B3…

A: (i) A> peak to peak = 3.5-(-3.5) = 7 Volt B> Time Period = 30 ms = 30*10^(-3) s C>…

Q: Define characteristic features of alternating current and voltage, such as the amplitude or peak and…

A: The characteristics features of alternating current and voltage are: Amplitude Cycles Frequency…

Q: A certain sinusoidal circuit has a given voltage having an equation v=324sin121t. If the peak…

A: Given: Sinusoidal voltage V=324 sin 121t V. Peak voltage is same in the triangular circuit.…

Q: A phase modulator has kp=1.5 rad/V. What rms voltage of a sine wave would cause a peak phase…

Q: The sinusoidal waveform displayed by the CRO is shown in Figure below. The 'time/cm' switch is on 50…

Q: A phase modulator has kp =2 rad/V. What RMS voltage of a sine wave would cause a peak phase…

Q: Explain why voltage spikes and surges are high frequency occurences

A: Both voltage spike and the voltage surge are the abrupt increase in the voltage within a very less…

Q: period in a square waveform? a. not related b. square proportional c. directly proportional d.…

Q: If the peak to peak voltage is equal to 20. How much the RMS value of the voltage?

A: In the question Peak to peak voltage = 20V Find the rms value?

Q: 2. The following waveform was derived from an oscilloscope. CHI Settings (Yellow) Volts/Div: 50V…

A: 1.Number of divisions× Volts per division in y axis from the mean position is the peak…

Question

Q18. An AC waveform is shown in figure B3.
4
10
20
30
40
50
70
100
Time (ms)
110
-2
-3
-4
-5
Figure B3
i)
For the above waveform, determine
a. Peak-to-peak voltage
b. Time period
c. Frequency
ii)
For the above waveform, determine
a. Peak Factor
b. Form Factor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

B1. For the CRO square voltage waveform is shown in Figure. The 'time/cm' switch is on 5 ms/cm and the 'volts/cm' switch is on 20 V/cm. Calculate (a) the periodic time, (b) the peak to peak voltage, (c) the maximum voltage, (d) the R.M.S voltage. [ The periodic time The peak to peak voltage The maximum voltage The R.M.S voltage
A load consists of XL=70 and XC=150 are connected in parallel across 120 Volt supply.The reactive power of the circuit is.......
The average (DC) value of a half-wave rectified voltage with a peak value of 200 V is: a. 63.7 V b. 127.3 V c. d. OV 141 V 2. Voltage regulation is determined by: a. load current b. Zener current and load current c. changes in load resistance and output voltage d. changes in no-load voltage and full-load voltage When a 60-Hz sinusoidal voltage is applied to the input of a full-wave rectifier, the output frequency is: a. 120 Hz b. 60 Hz c. 240 Hz d. 0 Hz
Consider only the GREEN sinusoidal waveform displayed on the CRO screen. The 'time/cm' switch is on 2 ms/cm and the 'volts/cm' switch is on 10 V/cm. Calculate for the GREEN waveform (a) the frequency, (b) the peak to peak voltage (c) the average voltage (d) the r.m.s voltage
For the CRO square voltage waveform is shown in Figure. The 'time/cm' switch is on 5 ms/cm and the 'volts/cm' switch is on 2 V/cm. Calculate (a) the periodic time, (b) the peak to peak voltage, (c) the maximum voltage, (d) the time taken to complete half cycle The periodic time The peak to peak voltage The maximum voltage The time taken to complete half cycle
The peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 5 cm and the 'volts/cm' switch on 44 V/cm. The peak to peak voltage is given by
For a full-wave rectified signal the dc voltage of 0.636VM. The rms value of the ac component of the output signal is 0.308Vm. Calculate the percentage ripple of a full-wave rectified signal.
For the C.R.O sine waveform shown in figure, determine (a) periodic time, (b) frequency, (c) Amplitude, and (d) peak-to-peak voltage. The 'time/cm' switch is on 85 us/cm and the volts/cm' switch is on 65 V/cm.
A resistor Ra is in series with a voltage source Va. Draw the circuit. Label the voltage across the combination as v and the current as i. Draw and label the volt–ampere characteristic (i versus v).
Advantages of improvement of transient stability by using waveform relaxation method
What is the dc output voltage and ripple in given example? Sketch the output waveform.
A sinusoidal waveform is displayed on a c.r.o. screen. The peak- to-peak distance is 5 cm and the distance between cycles is 4 cm. The ‘time ’ switch is on 100 μs/cm and the ‘volts/cm’ switch is on 10 V/cm. Determine (i) frequency (ii) peak and rms value of voltages (iii)Time .