1. During the quarantine period, your mother instructs you to water the plants in the garden using a hose. When you hold the hose near the ground, it shoots water at a speed of 3.5 m/s at an angle of 72 degrees above the horizontal. a. Determine the total time when water is in the a b. Determine the maximum height the water reaches. c. Determine the maximum horizontal the water covers.

1. During the quarantine period, your mother instructs you to water the plants in the garden using a hose. When you hold the hose near the ground, it shoots water at a speed of 3.5 m/s at an angle of 72 degrees above the horizontal. a. Determine the total time when water is in the a b. Determine the maximum height the water reaches. c. Determine the maximum horizontal the water covers.

C++ for Engineers and Scientists

4th Edition

ISBN:9781133187844

Author:Bronson, Gary J.

Publisher:Bronson, Gary J.

Chapter1: Fundamentals Of C++ Programming

Section1.2: Preliminary Two: Exponential And Scientific Notations

Problem 7E

See similar textbooks

Similar questions

A ball is thrown from the top of one building toward a tall building 50 ft away. The initial velocity of the ball is 20 ft/s at 400 above the horizontal. How far above or below its original level will the ball strike the opposite wall?
A capacitor, an electric resistance heater and an impedance are connected in parallel to a 120V 60HZ system. The capacitor draws 50VAR, the heater draws 100W, and the impedance coil draws 269VA at 0.74 pf. ( Determine the following: a. pf of the system, b. the total apparent power and c. total current flowing thru the system.
1. A 500-liter tank initially contains 10 g of salt dissolved in 200 liters of water. Starting at to = 0, water that contains 1/4 g of salt per liter is poured into the tank at the rate of 4 liters/min and the mixture is drained from the tank at the rate of 2 liters/min. Determine the quantity Q(t) of salt in the tank at time t = 0 until the time when the tank overflows. Code a C program which determined this quantity Q(t) by using RK4 method with h = 1. Note: May use the concept of function prototypes, function definition, function call, recursion etc. in a program. 2. A team of surveyors conducted depth-sounding at equidistant locations across the river to measure the area of a river cross-section. Determine the area of the cross-section by coding a C program of the Composite Simpson Rule, taking into consideration the river's 6.0 m width and the fact that it is equally divided into 7 stations. Station Depth, m 0 1 -1.23 24555 3 6 7 -2.08 -2.57 -1.86 -0.65 -0.24 Note: Determine the…
4- The potential difference 2 points between two point in an electric circuit is 24 V, If 0.4 J of energy were dissipated in a period of 5 ms, what would the current be between the two points? *
A 100 W electric light bulb is connected to a 250 V supply. Determine: The current flowing in the bulb. 0.4 A The resistance of the bulb. 25
A rope of negligible mass is wrapped around a 225-kg solid cylinder of radius 0.400 m. The cylinder is suspended several meters off the ground with its axis oriented horizontally, and turns on that axis without friction. (a) If a 75.0-kg man takes hold of the free end of the rope and falls under the force of gravity, what is his acceleration? m/s² (b) What is the angular acceleration of the cylinder? rad/s² (c) If the mass of the rope were not neglected, what would happen to the angular acceleration of the cylinder as the man falls?
Find the fluid force on the vertical side of the tank, where the dimensions are given in feet. Assume that the tank is full of water. (The weight-density of water is 62.4 pounds per cubic foot. Round your answer to two decimal places.) Parabola, y = x² Ib Submit Answer
A bicycle wheel has a diameter of 64.6 cm and a mass of 1.87 kg. Assume that the wheel is a hoop with all of the mass concentrated on the outside radius. The bicycle is placed on a stationary stand and a resistive force of 125 N is applied tangent to the rim of the tire. (a) What force must be applied by a chain passing over a 8.96 cm diameter sprocket if the wheel is to attain an acceleration of 4.49 rad/s22? (b) What force is required if the chain shifts to a 5.57 cm diameter sprocket?
A thermometer reading 50°C is taken outside where the temperature is30°C. Five minute later the reading is 40°C. Find the temperature reading 10minutes later after the thermometer was brought outside.
When a tension force of 900 N is applied to a steel wire, it is assumed that E = 210 GPa and that the diameter of the wire increases by 1.05 mm. Calculate the diameter of the wire.
4. A ball rolls horizontally off a cliff at 10 m/s. It takes 20 seconds for it to hit the ground. Calculate the height of the cliff
Aan TUUR IEACHER The four particles shown below are connected by rigid rods of negligible mass where y,6.60 m. The origin is at the center of the rectangle. The system rotates in thexy plane about mezawth an angular speed of 5.90 rad/s. 3.00 kg 2.00 kg 200 kg L00 kg 4.00 m- (a) Calculate the moment of inertia of the system about the z axis. kg m? (b) Calculate the rotational kinetic energy of the system