1. The negative feedback circuits are oftypes(d) Four(a)One(b) Two(c) Three2. A device with direct current coupled, high gain electronic voltage type amplifier with one output anddifferential input is called(a)Rectifier(b) Amplifier(c) Transformer(d) Op-amp3. Op-Amp with positive input type configuration +V or V is called(a)Non-inverting type input(b)Inverting type input(c)Non-inverting type output(d) Inverting type output4. Op-Amp has(a) Single(b) Similar(c)Multiple(d)Differential5. Write the formula for closed-loop voltage gain of inverting amplifier with feedback using open-loopvoltage gain and gain of the feedback circuit.(c)AF=-B/(1+AB) (d)None of the mentioned(a)AF= A/(1+AB) (b)AF= -A/(1+AB)6. Voltage shunt feedback amplifiers are also called as(a)Non-inverting amplifier with feedback(b)Non-inverting amplifier without feedback(d) Inverting amplifier without feedback(c)Inverting amplifier with feedback7. The type of active filter is:(a) active low pass filter (b) High pass filterpass filter(d)None of the above8. Op-Amp is atype of amplifier.(a) Current(b) Voltage(c)Power(d) Resistance9. The difference between higher and lower frequencies in a continuous wave is called(a) Frequency(b) Bandwidth(c) Amplitude(d) RMS10. Which of the following op-amp application doesn't have feedback?(a) Voltage comparator (b) Schmitt trigger (c) Triangle wave oscillator(d) Both b and coutputs.(c)active band

As per the honor code I will solve only first three parts. Kindly repost the other questions again.…

1. The negative feedback circuits are of types (d) Four (a)One (b) Two (c) Three 2. A device with direct current coupled, high gain electronic voltage type amplifier with one output and differential input is called (a)Rectifier (b) Amplifier (c) Transformer (d) Op-amp 3. Op-Amp with positive input type configuration +V or V is called (a)Non-inverting type input (b)Inverting type input (c)Non-inverting type output (d) Inverting type output 4. Op-Amp has outputs.

1. The negative feedback circuits are of types (d) Four (a)One (b) Two (c) Three 2. A device with direct current coupled, high gain electronic voltage type amplifier with one output and differential input is called (a)Rectifier (b) Amplifier (c) Transformer (d) Op-amp 3. Op-Amp with positive input type configuration +V or V is called (a)Non-inverting type input (b)Inverting type input (c)Non-inverting type output (d) Inverting type output 4. Op-Amp has outputs.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

PREAMPLIFIERS AND AMPLIFIERS What parameters can be varied if one wants to increase the gain of the pre-amplifier circuit?
a) What is an Op-Amp, and how is it used? b) What is the equivalent circuit model for an op-amp? c) What is negative feedback, and why is it used in Op Amp Circuits?
What is the gain of the op-amp circuit?
Give reasons for the following:(i) The gain of the Opamp rolls off after a certain frequency is reached.(ii) The Output offset voltage generated by the input bias current is always greater than that generated by the input offset current.
Calculate the total offset voltage for the circuit shown below for op-amp specification values of input offset values, VIO=2.8 mV and IIO=110 nA with RF=14000 ohm and Rin= 3000 ohm.
Calculate the total offset voltage for the circuit shown below for op-amp specification values of input offset values, VIO=3.5 mV and IIO=73 nA with RF=20000 ohm and Rin=3000 ohm.
1. What are the basic features of an OP - AMP? (6) 2. Basic op-amp connections include what? (10)
Q2/Explan the method to compensation of bias current, offset voltage,Offset current and maximum output voltage swing of op-amp.
The input voltage for an Op-Amp series regulator is 12v,, if the non inverting input of the op-Amp is connected to 3 series diodes instead of Zener one . a) Design the the op-amp feedback resistors to give 6.5V fixed o/p voltage b) Determine the line regulation in both % and in %/V. if the input voltage increased by 3V leading to o/p voltage increase of 0.05
Explain virtual short circuit of opamp.
Explain this single pole gain of opamp diagram?
Calculate the total offset voltage for the circuit shown below for op-amp specification values of input offset values, VIO=11.9 mV and IIO=62nA with RF=15 k ohm and Rin=3k ohm.