10. A 200-g pendulum is suspended on a cart moving to right with the indicated acceleration. If the acceleration si 0.5 m/s2, compute the angle 0 in degrees. a. 2.92 b. 3.64 c. d. a. b. 4.21 Answer is not among the choices 11. A billiard ball is about 61 mm in diameter and has a mass of approximately 210 g. If the balls are placed in contact, estimate the force (in Newtons) of attraction between them. 7.91 x 10-10 C. 5.91 x 10-11 6.67 x 10-11 d. Answer is not among the choices

10. A 200-g pendulum is suspended on a cart moving to right with the indicated acceleration. If the acceleration si 0.5 m/s2, compute the angle 0 in degrees. a. 2.92 b. 3.64 c. d. a. b. 4.21 Answer is not among the choices 11. A billiard ball is about 61 mm in diameter and has a mass of approximately 210 g. If the balls are placed in contact, estimate the force (in Newtons) of attraction between them. 7.91 x 10-10 C. 5.91 x 10-11 6.67 x 10-11 d. Answer is not among the choices

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.19P: Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of...

See similar textbooks

Similar questions

Hazel stands on the edge of a lookout admiring the view of a waterfall. The lookout is supported by a horizontal beam and a strut that makes an angle of 70° with the vertical. Hazel's mass is 60 kg 70° What is the horizontal force along the beam at the spot where she is standing? Use g = 9.81 m/s? for the acceleration due to gravity. Give your answer to the nearest Newton. Select one: a. 1721 N • b. 214 N c. 1617 N d. 626 N
The pulley assembly shown in the figure weighs 150 lb and has a centroidal radius of gyrationof 2 ft. The blocks are attached to the assembly by cords wrapped around the pulleys.Determine the acceleration of each body and the tension in each cord.a. Identify the direction of motion in the problem. 1)b. Set up the equations of motion that is required to solve the problem. SO1.5)c. Solve for the unknown variables by substituting the given in the equations of motionthat has been set up previously.
3.1.16. [Level 1] A person pulls down on the rope at B with a force of F = 10 lb. What is the acceleration of block %3| A if it weighs 50 lb? F gntogiebau A y E3.1.16 n1 070 Hend
A stepladder has negligible weight and is constructed as shown. The horizontal bar connecting the two legs of the ladder is pivoted half way up the ladder. A 47kg painter stands on the ladder a distance 4m from the foot of the ladder. The length of the ladder is 6.6m and the legs of the ladder are 8m apart on the floor. a) find the tension in the horizontal bar. The acceleration of gravity is 9.8m/s^2. Assume the floor is frictionless and that the ladder is symmetric and forms an isosceles triangle. Treat each half of the ladder separately. b) find the normal force on the left hand leg of the ladder and right hand leg of the ladder c) find the magnitude of the x and y component of the reaction force at the hinge that the left half of the ladder exerts on the right half.
A 5-kg block is acted on a 30-N Tensile force that acts 40 degrees from the horizontal. The kinetic coefficient of friction is 0.25. What is the acceleration of the block? Draw the FBD of the given.
An aircraft is getting loaded with checked luggage. The ramp that has a moving belt makes an angle of 60° with an aircraft body. The belt is stationary (Fig. 1a) a Fig. 1a Draw a free body diagram of a single luggage that is placed on the belt. Show weight as vertical and horizontal components. Suppose the belt now starts moving from rest, determine the acceleration of the bag and its speed after 2s. The mass of the bag is 22 kg, coefficient of kinetic friction u = 0.4 and the force produced by the belt on the bag Faet = 120 N. ii
1. Consider the system shown below. Block A weighs 95.0N and block B weighs 55.0N. Once block B is set to downward motion, it descends at a constant speed. A) Calculate the coefficient of kinetic friction between block A and the tabletop. B) A dog, also of weight 95.0N, Falls asleep on top of block A. If block B is now set into downward motion, what is its acceleration (magnitude and direction)? A
The two blocks started at rest. The surface of the inclined plane is frictionless. (note: neglect mass and friction of the pulley) Given: Weight of A=230 lb. Weight of B=300 Ib. Calculate: a) acceleration of A (ft/s"), 30° with the horizontal b) Acceleration of B (ft/s"), downward c) the tension in the cable (Ib.) B 30°
A 3-meter-long 25 kg beam is supported by two cables as shown below. You can treat the beam as a slender rod. Assume we want the left end of the beam at A to remain as a constant height while the right end of the beam at B to accelerate upwards at a rate of 1 m/s². a) What is the rate of acceleration of the center of the beam and the rate of angular acceleration for the beam? b) What will T₁ and T₂ need to be to achieve these accelerations? A T₁ .5 m 1.5 m C T₂ (Solution: acy = 5 m/s², a = 333 rad/s², T₁ = 81.75 N, T₂ = 176 N) 1m B
The 300N block rests upon a level plane for which the fk is 0.20. A force P = 100N, directed at 30° from the horizontal pulls the block and moves 80m starting from rest. If the 100N force is then removed, how much further will it travel? a. none b. 48.803m c. 40.078m d. 47.800m 3. 40.780m
Consider the system shown below. Block A weighs 95.0N and block B weighs55.0N. Once block B is set to downward motion, it descends at a constant speed.A) Calculate the coefficient of kinetic friction between block A and the tabletop.B) A dog, also of weight 95.0N, Falls asleep on top of block A. If block B is now setinto downward motion, what is its acceleration (magnitude and direction)?
An object, m1 with a mass of 10.0 kg placed on a frictionless, horizontal table. It is connected to a string that passes over a pulley and then is fastened to a hanging object, m2 with a mass of 14.0 kg. a. The tension in the string is? b. Find the magnitude of the acceleration of the objects