ssssssssssssssssssssssssssssssss 2.Refer to Fig. 11-5. The source voltage is27Vdc and total current I, is 30mAdc. Calculatethe following using Ohm's Law and Kirchhoff'sCurrent Law.1,=30mAdemAa) Current flow through R..27VdcR,10K15K_mAdc%3Db) Current flow through R2..Fig. 11-53.If you connected a milliammeter betweenpoints A and B of Fig. 11-5, how much currentwould it indicate?mAdc_mAdcIAB%3Dc) Current flow through R3..4.How did you calculate the current flowthrough R3 in Question 2?_mAdcd) Resistance of R3.5.Does current flow up or down throughthe resistors in Fig. 11-5?R3%3D

Answered: Image /qna-images/answer/ebef9b92-d2f9-4028-9cb9-dd25167a5d35.jpg

2. 27Vdc and total current I, is 30mAdc. Calculate the following using Ohm's Law and Kirchhoff's Current Law. Refer to Fig. 11-5. The source voltage is 1,-30mAde A mA a) Current flow through R1. 27Vdc R, 10K 15K mAdc b) Current flow through R,. Fig. 11-5 3. If you connected a milliammeter between points A and B of Fig. 11-5, how much current would it indicate? R2 mAdc c) Current flow through R3. LAB mAdc 4. How did you calculate the current flow through R, in Question 2? mAdc d) Resistance of R3. 5. Does current flow up or down through the resistors in Fig. 11-5? R3=

2. 27Vdc and total current I, is 30mAdc. Calculate the following using Ohm's Law and Kirchhoff's Current Law. Refer to Fig. 11-5. The source voltage is 1,-30mAde A mA a) Current flow through R1. 27Vdc R, 10K 15K mAdc b) Current flow through R,. Fig. 11-5 3. If you connected a milliammeter between points A and B of Fig. 11-5, how much current would it indicate? R2 mAdc c) Current flow through R3. LAB mAdc 4. How did you calculate the current flow through R, in Question 2? mAdc d) Resistance of R3. 5. Does current flow up or down through the resistors in Fig. 11-5? R3=

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

Task 3 A three phase, four wire star connected load consisting of: ZR: a resistor of 9500 in series with a 3H inductor ZB: a resistor of 1950 ZY: a resistor of 1950 in series with a 4µF capacitor Using the equipment available in the power lab (Room T017), connect the given load to a three-phase supply available in the lab and: 3.1. Determine the current of each line and the neutral current and measure the total power supplied by the source. 3.2. Analytically, calculate all currents and the total power and compare with those obtained in measurements. 3.3. Device a method and measure the waveform of the neutral current. Discuss the obtained waveform and the reason for any distortion in the waveform 3.4. Validate your calculations using computer simulation
(Note that the a,b,c,d are branches)1. Measure and record the potential difference for the following branches. Be mindful of the algebraic sign. a-b a-c b-c c-d a-d b-d And using the measured potential difference values, compute for the algebraic sum of the potential difference for the following electrical loops. Indicate the equation with values as well. abca abdca acda abcda acbda
Find the total current and show complete solution with figure.
For the circuit given in Figure 1, a) Find the Thevenin equivalent circuit with respect to terminals a-b b) When a 5000 resistor is connected to terminal a-b, find the voltage on the resistor wwwwwwmm c) It will be connected to a-b terminals and its voltage on 5000 load will be 132 kV rms. What should be the capacitive reactance value that will increase it? wwwwwwwww d) What happens to the short-circuit current when the a-b terminals are short-circuited? 2+1202 000 m da 127/6 kV rms ob 1.5 +/902 000 w 12725 kV ms
A resistor of 5 ohms is connected in parallel with an inductive reactance of 10 ohms, then connected in series with a capacitive reactance of 5 ohms. If the entire combination is connected across a 100 V, 60 Hz ac source, find the voltage across the resistor.
Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l33.2AI4RT3.582R116R210R3R420PTP1P2P3P4
Determine the current Ic, current at the resistor, and current supplied by the voltage source. Note: you must put the imaginary part of the reactances and its sign
It states that "in any electrical network, the algebraic sum of the currents meeting at a point or junction is zero". a. kirchoff's current law b. kircchoff's current law c. kirchooff's current law d. kirchhoff's current law
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
2.)What is the difference between Ampere's law and Biot-Savart's law?
In the figure: R1 = 1439.170, R2 = R1 and R3 =2R2, then determine the value of the voltage source E. a 8 mA 10 mA 2 mA RT R1 R2 R3 O 25.33 11.51 O 17.27 15.43 13.82 +
Oman- All Docume.. G flux type sign boar sf Career Oport The power factor of purely resistance circuit is Zero O Leading O Lagging Unity