2. Three impedances (2 + j4), (3 - j5) and (1 – j3) are connected in paralel. The combination is connected in series with a coil of resistance 32 and inductance of 0.02 henry to a 230V , 50hz supply. Find the total current drawn by the circuit and the power factor of the system.

2. Three impedances (2 + j4), (3 - j5) and (1 – j3) are connected in paralel. The combination is connected in series with a coil of resistance 32 and inductance of 0.02 henry to a 230V , 50hz supply. Find the total current drawn by the circuit and the power factor of the system.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: Explain how B can be found for a transistor used in an experiment to study the characteristics of a ...

Q: When generator is being driven at 1200 rpm, the generated emf is 230V. What is the generated emf if ...

Q: xi[n] ak, x2[n] → bk, where ao = a3 = and bo = b1 b2 = b3 = 1. aj 21 742 = 1 %3D %3D Using the multi...

Q: 2. An amplifier has an input signal voltage of 30 mV, input signal current of 0.4 mA, input power of...

Q: 3. Given:wye to delta(balanced),abc sequence VAB=240 angle -20 Load impedance=20 angle 40 deg Find t...

A: The solution is given below

Q: Find the area of the triangle having vertices at P(1, 3, 2), Q(2, -1, 1), R(-1, 2, 3). Use dot or cr...

A: Dear student , kindly note that Im getting answer different from the option , as a part of self ana...

Q: Assume that you have been tasked with evaluating a new inductor. The inductor has a Q of 1454 at 50K...

Q: A series motor develops 164 lb-ft torque when the current is 94A. If the load increases the current ...

A: Given,T=164 lb-ftIa=94 ALoad increases the current 50%Flux increase of 20%T'=?

Q: Determine the Laplace transform of, v(t) = 8(t) + 2u(t) – 3e¬2tu(t) %3D

Q: 9. An air gap measuring 1.5 mm is cut in the magnetic ring with a mean radius of 10 cm and a cross s...

Q: ITE 296 - Logic Cireuits and Demign ta Far 1. What is the output of Q and Q' respectively? Justify y...

Q: In a series RL circuit, the resistance is 150 and the inductance is 5 H. The battery gives a constan...

Q: Why the power flow analysis involves with non-linear equations?

Q: S0,–10 < t < 0 The voltage from a square wave generator is in the form of v(t) : and (5, 0 <t < 10 i...

Q: The frequency band of a standard AM radio broadcast. Measure by which a carrier voltage is varied by...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: 0:0000 R Clock Q

A: The given circuit is asynchronous counter as clock is only provided to first flip flop. Also every f...

Q: A single phase motor is rated 5hp, 75% pf lag,220V. What is the approximate size of capacitor is nec...

A: It is given that:P=5HPP=5×746P=3.730 kWV=220 Vpower factor,cosϕ1=75%cosϕ1=0.75Required power factor,...

Q: 2- The circuit below is situated in a magnetic field B = âg3 cos (5710't -ny) (µT). Assuming R = 15 ...

A: The emf induced in the loop is given by the rate of change of the magnetic flux. The magnetic flux l...

Q: 2. A741 op amp has an open-loop voltage gain of 2x10°, input resistance of 2 MQ, and output resistan...

Q: A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A an...

A: In this question, The given The radius of spherical conductor 10cm total charge on it Q=20uC. If po...

Q: Two point charges are on the y axis. A 5uC charge is located aty = 1.5cm and a - 2.5uC charge is loc...

A: Brief description : In the above given question we need to calculate the value of net potential at o...

Q: The current flowing through a device is i(t)= 5sinót A. Calculate the total charge flow through the ...

Q: Calculate what the resistor value should be to operate the three lights in parallel.

A: The solution is given below

Q: In circuit analysis, expound separately the meaning of getting negative values for the current & vol...

Q: A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A an...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: calculate The otal charze by volume C.1S IXI, lyl, lz1502 w/

Q: A series resistance-capacitance (R-C) circuit is connected to a 230 volt 60 cycle source. If the pow...

Q: The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A, respective...

A: Alternator voltage V = 300 v Alternator current I = 20 A Voltage leads the current by an angle ¢ =...

Q: Answer the following problem. 1. Using the characteristics of (a), determine Ip, Vp and VR for the c...

A: Bries description: Diode is a unit directional device which will allow current to pass through only ...

Q: The collector current Ic (see the circuit below) is:

A: The following circuit diagram is given:

Q: 2µF a O 2µF 2µF 3µF 3µF 6µF 3µF 6µF b o

A: The solution is given below

Q: a power source outputs 30 watts of power that is equally divided into four branches. the first and s...

Q: A string of four diodes is used to provide constant voltage of 3.0 V. (a) Calculate the percentage c...

A: Answer - a)

Q: Find IB, IE, VBE, VCE, and VCB in this circuit. The transistor has

Q: In the network in Fig. E8.16, V, is known to be 8/45 V. Compute V,. ANSWER: V,-17.89/-18.43° V. I3 1...

Q: The message signal m(t) = sin(2000nt) + 2cos (1000nt) modulates the carrier signal c(t) = cos(2¤fct)...

Q: Y (s) U (s) 250 U s² + 15s + 250 what is its sampling frequency and its z- Eransform?

Q: G(s) R(s) C(s) K(s +2) G(s)= (s+3)(s² +s) Consider the pure proportional gain equal to fifteen. Dete...

A: Given data, Transfer function is given as, Gs=Ks+2s+3s2+s=Ks+2ss+1s+3 Proportional gain is given K =...

Q: Can we select components voltage references randomly in order to write KVL? Why? In what situation w...

A: Question 5 We will select components voltage reference to make calculation easily, but if we select ...

Q: 3.6. Consider three continuous-time periodic signals whose Fourier series repres= tions are as follo...

Q: etermine the Laplace transföri öf, v(t) = (20e-4" + 25e-5t)u(t), t>0

Q: Problem 1: A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If ...

A: Since you have asked multiple questions in a single request, we will be answering only the 1st quest...

Q: Start Now > Combine PDF > Send Files > Store Files 3. A one sided p+/n silicon junction at 300K is d...

Q: а. Obtain the absolute potential at point A (2, 2, 3) m due to a point charge Q=0.4nC is located at ...

A: Since you have asked multiple questions in a single request, we will be answering only the 1st quest...

Q: Q3: Obtain the equivalent resistance seen by the source and find the power delivered by the source f...

Q: A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A an...

A: Since you have asked multiple questions in a single request, we will be answering only the first thr...

Q: Given the function F(A,B,C) = ∏M(7) . Find the minimal POS Find the minimal SOP Implement F(A,B,C) ...

Q: (a) In the bridge shown, two strain gages R, and R2 are placed as shown. The unstrained resistance i...

Q: 1- Find the mutual inductance between two coplanar rectangular loops with parallel sides as shown in...

Q: Fill in the blanks: A cable company uses one cable TV Channel (with BW of 6MHZ) to provide digital c...

Question

2. Three impedances (2 + j4), (3 - j5) and (1 – j3) are connected in paralel. The
combination is connected in series with a coil of resistance 32 and inductance of 0.02
henry to a 230V , 50hz supply. Find the total current drawn by the circuit and the power
factor of the system.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Continued

Continued

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
An inductor and a 470 ohm resistor are connected in series with a function generator. The current is 53.7mA RMS 8kHz. The reactive power is 2.32 var. Find the value of the inductance.
Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at 25 Hz. The circuit takes 425 W, and the power factor is 0.47. The resistance of the circuit is A. 7.32 ohms C. 7.98 ohms B. 7.86 ohms D. 7.56 ohms
A 25-ohm resistor connected in series with a coil of 50-ohm resistance and 150-mH inductance. What is the power factor of the circuit? The standard frequency is 60 Hz. Show complete solution.
4. Design the network in the figure to have the following characteristics: i. BW - 500 Hz ii. Qp = 30 iii. Vemax = 1.8 V 0.2 mA Z0° C7 R, = 0 N
A 15µF capacitor and a 470 ohm resistor are connected in series with a function generator. The supply voltage is 50V RMS 40Hz. Find the reactive power for this circuit.
A 2.5A current is flowing in a series circuit comprises of a coil with inductance 15mH and resistance 102 and a variable capacitor. The supply voltage is 120V at 60 Hz. Estimate the following: i. The capacitance and impedance. ii. Angle between supply voltage and current. ii. The reactive power consumed
Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 Vusing a single 14 V dc voltage source
An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of 20 amperes, and a wattmeter indicates that the circuit has a true power of 3 kW. What is the circuit power factor, and what is the capacitance of the capacitor?
1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c source. What must be the value of the capacitance to be connected in parallel to the circuit to raise the power factor to 0.96 lagging. Draw the circuit diagram.
Which methods can be used to estimate or calculate the maximum power point on an I-V curve?