PLEASE ans it in 1hr.TOPIC: Capacitors in Circuit ConfigurationsNeat and complete soln. 2.Two capacitors in parallel, 2-µF and 4-µF are connected in series with a 3-µF capacitor. Thecombination is connected across a 12-V battery. Draw the circuit (with labels) and find the voltageacross the 2-uF capacitor.

Answered: Image /qna-images/answer/a26a83e2-5752-4f98-84d2-b6f3a2f64f29.jpg

2. Two capacitors in parallel, 2-µF and 4-uF are connected in series with a 3-µF capacitor. The combination is connected across a 12-V battery. Draw the circuit (with labels) and find the voltage across the 2-µF capacitor.

2. Two capacitors in parallel, 2-µF and 4-uF are connected in series with a 3-µF capacitor. The combination is connected across a 12-V battery. Draw the circuit (with labels) and find the voltage across the 2-µF capacitor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Find out the Laplace Transform of the following function: z(1) = e *u(t) -551

Q: Three point charges Q1=20 nC, Q2=-15 nC, and Q3=45 nC are enclosed in a closed surface. Determine th...

Q: For the follower circuit, let transistor Q1 have β = 50 and transistor Q2 have β = 100, and neglect ...

A: Given the circuit, as shown below: For the follower circuit, let transistor Q1 have β = 50 and tran...

Q: The windings of an alternator are delta connected the alternator is producing a line to line voltage...

Q: Assume an annual available energy of 1200 Kwh/m2. The system rating peak is 50 Kw. The annual energy...

A: Given: Assume annual available energy of 1200 Kwh/m2. The system rating peak is 50 kW. The annual en...

Q: 3. The design of an FIR filter using the Parks-McClellan algorithm achieved the follo magnitude resp...

A: GIVEN FILTER RESPONSE

Q: PR1 D1 A 1 + V1 R1 Vo 100V 20002

Q: What is the difference between an Insulator and a Dielectric?

A: Insulator- Insulator is a substance that provides tremendous amount of resistance towards the passag...

Q: In a superheterodyne receiver, the incoming RF signal is at 25 dBµ, the RF amplifier has a 30 dB gai...

Q: The stationary windings or magnets of a DC motor are called the

A: In the DC motor, there are stationary windings are also called magnet of the DC motor.

Q: Apply Nodal Analysis in determining the values of Va, Vb, and Vc on the circuit below. 1 A 12 2iy 5i...

Q: Find : a) RT = ? RiB 22 5-2 322 Rを A-2 R23 tw AAA MA R24 Ris- Ri7 = 32 = 42 Rig- Rzo= R21 R24 = 52 %...

Q: 1-How to make the bridge output (Vo) equal to zero? explain?

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: On a three phase 208/120 V system the color typically used to identify the neutral is

A: Neutral color is white

Q: Discuss the causes of electrical insulation failures. Enumerate and describe the components of the t...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Compute for Vout and show complete solution

A: In this question, Find the voltage Vo Assume forward bias voltage across Ge = 0.3V And for si type...

Q: Which of the following is used to reduce the compounding of a DC generator? O Inverter Diverter Comm...

A: The compounded DC generator has both series and shunt field winding and the compounding can be contr...

Q: a) Figure 1 shows a complex resistor combination circuit. Find the equivalent resistance REQ, Is and...

Q: 5. For the CB amplifier circuit as shown below, calculate the output voltage vout with an input of 2...

A: The solution is given below

Q: A 120 KVA, 6600/250 V transformer gave the following results: OC test: 6600V, 7 A. 900 W; SC test: 1...

Q: In a parallel RL circuit, R = 10 , L = 40 mH and v = 110 sin(377t + 45) V. Find i.

Q: Obtain the magnitude and phase of the transfer function and draw the bode plot

A: In this question, We need to Obtain the magnitude and phase of the transfer function and draw the ...

Q: Using a diagram explain the difference between a common source amplifier and common gate amplifier?

A: FET circuit configurations are the common source, common gate, and common drain formats. Each have t...

Q: For the circuit in Fig. 4.76, find the terminal voltage Vab using superposition. 4.8 3V ab 102 o a 4...

Q: b) The following digital signal was encoded using NRZ-Invert. What is the digital data? (Fill in the...

A: What is the digital data for the given NRZ - Inverted output ?

Q: uniform line charge and a uniform sheet charge, both infinite in extent, are located in free space a...

A: We need to find out electric field at given point due to line charge density and surface charge dens...

Q: 1. A plot of the magnitude of the transfer function, |G(j@)|, as a function of the frequency is give...

Q: The logic 0 in port latch decides direction of which port?

A: LATCH Latches operate with enable signal which is level sensitive trigger. Whereas, flip-flops are ...

Q: volume charge in a form of a cube, 2m on an edge, parallel to the axes and centered at the origin is...

A: We need to find charge enclosed by given surface .

Q: 2. Total current in a semiconductor is constant and is composed of electron drift current and hole d...

Q: Matching Type. Match each item to a choice: Two vectors having the same magnitude and direction. A r...

A: Vector- Vector as we know is a quantity that has magnitude and direction in the space.

Q: A three phase wye connected load is connected to a 480V three phase line. The line current is 36 A. ...

Q: Consider a discrete time system with the following input output relation y[n] = x[n]x[n – 2] Is the ...

A: Given function yn=xnxn-2

Q: Ior a Dass up to 1000 Hz. You are planning to implement the filter digitally by first design- ing an...

A: Passband frequency, fp = 500 Hz Stopband frequency, fs = 1000 Hz Sampling frequency, fS =4000Hz Wp =...

Q: What is a load break down simply?

A: Load Break - A load break circuit is a disconnected device that is meant to make or interrupt certai...

Q: a) Determine the exponential Fourier series coefficients of the following periodic signal sp (t). A ...

A: Since you have posted a question with multiple subparts, we will solve the first part for you. If yo...

Q: 30 k2 Vs 50 μF 10 mH 50 k2

Q: Explain what is the Wiring Diagram of Direct On Line Starter based on your understanding.

A: DOL starter- A DOL starter (direct on line) is the standard method of starting a small single or thr...

Q: Two uniform line charges of ρL = 5 nC/m each are parallel to the x-axis, one at z = 0, y = -2 m and ...

Q: is te) - 5 cosfi00t +40] 0-18 FIMF 200

Q: 2. A voltage source of v(t) = 340sin(2n60t) V is applied to a nonlinear load, resulting a current i(...

Q: 39. Using branch current analysis, find the voltage drop across the 1 kN resistor in the figure show...

A: If we consider I1 as current flowing in the first loop in clockwise direction and I2 is the current ...

Q: Evaluate the following items below, if Z1 = -1 + I, and Z2 = 2 – 3i, (a). 2Z1 + 4Z2 (b). Z1Z2 (c). 3...

A: Using general rule of adding real and imaginary parts individually find the unknown values.

Q: It Given : VT = Vm cos wt Vm = 310V 2) f = 60HZ = 28 2 R4 L, - 0.06 H Find: Ca) RMS caleu lated volt...

Q: Prob#10 Find I. by nodal analysis.

A: Circuit with defined nodes is shown below

Q: A solar cell with an area of 4 cm^2 has the IV characteristics under the illumination of 600 Wm^-2 s...

A: GIVEN: load=5Ω area=4cm2 FIND: (a)power delivered (b)efficiency

Q: 3. A shunt motor running at 600 rpm takes 80 A at 250 V. Armature resistance is 0.1 ohm. Shunt field...

Q: Define Superposition Theorem with necessary circuit diagram. Explain the steps followed in superposi...

Q: Consider the following signal x(t) = 8(t + 2) - 8(t – 2) Find and plot y(t), where y(t) = %3|

A: The given signal is shown below: xt=δt+2-δt-2

Q: Problem 184: EE The total inductance of two coils, A and B when connected in series aiding is 0,5 H ...

A: Inductance:-The structure of the electrical circuit in which the electromotive energy is fed into th...

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

PLEASE ans it in 1hr.

TOPIC: Capacitors in Circuit Configurations

Neat and complete soln.

2.
Two capacitors in parallel, 2-µF and 4-µF are connected in series with a 3-µF capacitor. The
combination is connected across a 12-V battery. Draw the circuit (with labels) and find the voltage
across the 2-uF capacitor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms
Three capacitors 6, 10 and 15 uF are connected in series across a 100 volt supply. Find the voltageacross the 10uF capacitor.
99 Connect a group of identical capacitors first in series and then in parallel. The equivalent capacitance for parallel connections is 100 times larger than for serial connections. How many capacitors are there in this group?
An alternating voltage is applied to a series circuit consisting of a resistor and iron-cored inductor and a capacitor. The current in the circuit is 0.5 A and the voltages measured are 30 V across the resistor, 48 V across the inductor, 60 V across the resistor and inductor and 90 V across the capacitor. Find (a) the combined copper and iron losses in the inductor (b) the applied voltage.
An alternating voltage is applied to a series circuit consisting of a resistor and iron-cored inductor anda capacitor. The current in the circuit is 0.5 A and the voltages measured are 30 V across the resistor,48 V across the inductor, 60 V across the resistor and inductor and 90 V across the capacitor.Find (a) the combined copper and iron losses in the inductor (b) the applied voltage.Answer: [(a) 3.3 W (b) 56 V] Note: Please provide a clear solution!
An alternating voltage is applied to a series circuit consisting of a resistor and iron-cored inductor anda capacitor. The current in the circuit is 0.5 A and the voltages measured are 30 V across the resistor,48 V across the inductor, 60 V across the resistor and inductor and 90 V across the capacitor.Find (a) the combined copper and iron losses in the inductor (b) the applied voltage Answer: [(a) 3.3 W (b) 56 V]
Show that the voltage division rule for two capacitors in series as in the figure
Capacitors C1 = 10.33 uF and C2 = 10.77 uF are connected in series. After some time, the engineer decided to connect capacitor C3 = 4.93uF across C1 and C2. Find the total charge, in uC, of the group of capacitors if they are connected across 18.13 V battery.
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil