20 kg/s of steam enters a condenserat a pressure of 0.08 bar and qualityof 0.68 and exits as saturated liquid atthe same pressure. What is the masflow rate of cooling water if thetemperature rise of cooling water is 10oC and its specific heat equals 4.2kJ/kg.k?

Answered: Image /qna-images/answer/16db506f-6c08-4957-a3a9-e3d8cf8ece0f.jpg

20 kg/s of steam enters a condenser at a pressure of 0.08 bar and quality of 0.68 and exits as saturated liquid at the same pressure. What is the mass flow rate of cooling water if the temperature rise of cooling water is 10 oC and its specific heat equals 4.2 kJ/kg.k?

20 kg/s of steam enters a condenser at a pressure of 0.08 bar and quality of 0.68 and exits as saturated liquid at the same pressure. What is the mass flow rate of cooling water if the temperature rise of cooling water is 10 oC and its specific heat equals 4.2 kJ/kg.k?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Steam with an enthalpy of 2843.5 kJ/kg undergoes a constant pressure process at 0.9 MPauntil the enthalpy becomes 2056.1 kJ/kg. What are: a. The initial temperature or quality of steamb. The work of the process.
Steam generators are a type of heat exchanges that are used inpower plants to generate steam at desired pressure andtemperature (Fig. Q1.b). In a steam generator, saturated liquidwater at 30°C enters a 60-mm diameter tube at the volume flowrate of 12 L/s. After exchanging heat with hot gas, the waterchanges to steam and leaves the generator at a pressure of 9 MPaand a temperature of 400°C. During this process, the diameter ofthe water/steam tube does not change. Where necessary, assume air as an ideal gas and consider R = 287J/(kg.K), Cp = 1005 J/(kg.K), Cv = 718 J/(kg.K). (i) Calculate the steam mass flow rate and inlet velocity of the steam? (ii) What is the exit velocity of the steam? (iii) Calculate the rate of heat transfer (in MW) required tochange the phase of liquid water to steam.
Calculate the compressor work in kJ required to compress 1 kg of an ideal gas from an initial volume and pressure of 0.65m3 and 101.3kpa to a final pressure of 517kpa & volume of 0.1943m3. Ans. 133.549 kJ
H.W: - 0.8m of gas at 8bar and 27°C is compressed isothermally until its volume is ¼ time the original volume, then its heated at constant pressure to original volume, finally its cooled at constant volume to original condition. Find: - a- the heat transferred. b- Work done c- Change in internal energy. (draw the processes on p-v diagram) Take cp=1.01kj/kg.k, R=0.28kj/kg.k
Exactly 10 kg of steam entered a heat exchanger at 100 bar and 560o C. At the exit the Steam was at 30 bar and a quality of 0.47. Please determine a. The exit temperature in oC. b. The mass of the liquid water in kg.
Determine the heat added in the system and its final pressure.Nitrogen with a mass of 2.5 kg expands at a constant pressure. Theinitial pressure and temperature in the piston cylinder system is 170kPa and 27 oC, respectively. Because of the heat transfer, the systemreached a final temperature of 200 oC. Note R= 0.2968 kJ/kgK Determine:a. The heat requiredb. The workc. The change of enthalpyd. The change of internal energy
Two kilograms of ice at -24C is heated in an open pan until melts and then evaporates. The saturate vapor exits the system at 100C. How much heat must be added to the system for this to occur?
An Isobaric process is done on steam where it is heated to 200 C at 1.1 MPa. It was initially a kilogram of saturated liquid. Find the change in volume, change in internal energy, change in enthalpy, and change in entropy. (0.1848 m3, 1837.31 kJ, 2040.66 kJ, 4.4609 kJ/k) Table 3. Vapor p(t Sat.) 1.10 (184.09) 1.15 (186.07) 10 10 . Sat. 177.53 2586.4 2781.7 6.5535 170.13 2587.7 27833 6.5381 175 180 185 190 195 172.50 2567.9 2737.6 L75.28 25782 2771.0 178.02 2588.2 2784.0 180.71 2598.1 2796.9 183.36 2607.8 2809.5 6.6137 164.20 25648 2753.6 166.91 2573.2 2767.2 169 37 258SS 2780.5 172.18 2595.5 2793.5 174.75 2605.4 2806.4 6.4726 6.3028 63320 6.5603 6.5878 6.5004 63300 6.5587 6.5866 200 205 210 215 220 185.97 2617.4 2822.0 6.6401 188.56 2626.8 2834.2 6.6659 191.11 2636.1 2846.3 6.6911 193.63 2645.3 2858.3 6.7157 196.13 2654.3 2870.1 6.7398 177.28 2615.1 2819.0 179.77 2624.6 2831.4 182.24 2634.0 2843.6 184.68 2643.3 2855.7 187.09 2652.5 2867.6 6.7154 6.6146 6.6407 6.6661 6.6910 225 230 235…
A piston-cylinder device initially contains 0.8m3 of saturated water vapor at 250 kPa. At this state, the piston is resting on a set of stops, and the mass of the piston is such that a pressure of 300 kPa is required to move it. Heat is now slowly transferred to the steam until the volume doubles. a. Indicate knowns and unknows for each state as well as what type ofprocess is performed to get from one state to another. State anyassumptionsb. Determine the final temperaturec. Determine the work done during the processd. Show the process on a P-v diagram with respect to saturation linese. Determine the total heat transferred during this process
An air compressor absorbs 1000 kg of air per hour at a pressure of 100 kPa and 500 kPait presses on the pressure. Specific volume of air at compressor Inlet 0.8 m3/ kg, at Exit0.2 m3/ kg dir. The internal energy of the air at the outlet is 100 kJ/kg more than at the inlet.60 000 kJ/h heat transfer occurs from the compressor to the air. Kinetic and potential energyfind the power needed to operate the compressor, neglecting its changes.
Q-1(c): Consider a case in which the air inside the pressurized cabin of a jet transport flying at some altitude of pressure, 0.9 atm and of temperature, 15°C. The total volume of air at any instant inside the cabin is 1800m3. If the air in the cabin is completely recirculated through the air conditioning system every 20 min, calculate the mass flow of air in kg/s through the system. I Answer:
(Processes of ideal gases) oxygen at 200 kPa, 27 degree celcius in a piston cylinder device arrange to maintain a constant pressure. how much work in KJ/kg is produced by this system when it is heated to 227 degree celcius?