200 lb 1.5 ft 200 lb -2 ft 1.25 ft 30° 30° -F F

Q: Problem 2 Collar B moves downward to the left with a constant velocity of 2 m/s, and rod AB has…

A:

Q: a. noving An aircraft is getting loaded with checked luggage. The ramp that has a belt makes an…

A:

Q: An airplane has a half-wingspan of 40 m. Determine the change in length of the aluminum alloy la =…

A:

Q: The variable h designates the arbitrary vertical location of the bottom of the rectangular cutout…

A:

Q: The couple M=126 kip-in. acts in a vertical plane and is applied to a beam oriented as shown.…

A: M = 126 kipTo find out :-The stress at point A

Q: A ramjet drives a missile at V0=966m/s at an altitude of 33.5km (air density 0.01kg/m3 and T0=232K).…

A:

Q: Determine the minimum coefficient of static

A: Given Data The mass of the car m= 1400 kg=1400*9.81=13734NFind Outa) The minimum coefficient of…

Q: A 40 kg youth jumps upwards at 8 m/s from a height of 5 m and lands on a trampoline of height 1 m…

A:

Q: Question 2: Determine the moment of inertia of the shaded area. 30mm 23mm 10mm x

A: Partition the area into simple disjoint shapes (areas) with known (or can be easily found)…

Q: Consider a refrigerator that operates on the vapor compression refrigeration cycle with R-134a as…

A: According to the given dataA vapour compression cycle is drawn belowWe need to findThe coefficient…

Q: Determine the smallest intensity of the distributed load that will cause both wires to yield. is…

A: Given DataThe steel wire diameter d = 6 mmPart -AThe yield stress of the wire The Youngs modulus of…

Q: A small airplane has a total mass of 2000 kg and a wing area of 56 m². Speed of it is 290 km/h.…

A: Total mass of the airplane (m) = 2000 kgWing area (A) = 56 m²Velocity (V) = 290 km/h = 80.56 m/sAir…

Q: In the following image the two temperature values that are equal are:

A: Given data:-To find:-the two temperature values that are equal

Q: The velocity of a particle moving in the x-y plane is given by (5.92i + 4.07j) m/s at time t = 5.92…

A: Given:The velocity of a particle is  at .The acceleration of a particle is at .Formula used:The…

Q: Two solid bars support a load P as shown. Bar (1) has a cross-sectional area of A₁ = 3100 mm² and an…

A: According to the  given dataThe area of bar 1 is .The allowable normal stress in bar 1 is .The area…

Q: Show on a free-body diagram how a normal force always remains perpendicular to the contact surface,…

A: to Show on a free-body diagram how a normal force always remains perpendicular to the contact…

Q: A coil spring with 5 cm outside diameter is required to work under the load of 190 N. The wire…

A: Outside Diameter (D) = 5 cm = 50 mmWire Diameter (d) = 5 mm Active Coils = 6

Q: QUESTION 4 For the beam and loading shown, draw the shear force and bending moment Diagram and…

A: As per bartleby rule, we can answer one solution in one post so i selected Q.4 please post remaining…

Q: Slider. A с link (AB) = 500 mm link (BC) = 42 mm link (CD) = ? D d For the mechanism Shown above...…

A: Length of the link ABLength of the link BCFrom the given figure according to the lines on the page…

Q: Determine the moment of inertia of the shaded area with respect to the centroid (lx, ly = ?) 3 cm 8…

A: to find the moment of inertia of the shaded region.

Q: A thin triangular plate PQR forms a right angle at point Q. During deformation, point Q moves to the…

A:

Q: Break down the units of a moment into the basic (or fundamental) SI units; kg, m, seconds.

A: The fundamental unit of moment is N.m

Q: Current Attempt in Progress Consider 6.8 kg of austenite containing 0.43 wt% C, cooled to below…

A:

Q: Part A A steel tube having an outer diameter transmit 9 hp when turning at 27 rev/min. 1 hp = 550…

A: Given data:The outer diameter, do = 2.5 in.The power transmitted, P = 9 hp.The turning revolution, N…

Q: A.  Which among the tool categories comprised most of the available tools? Infer a reason as to why…

A: There are different tool category including machine tool and hand tools.

Q: A stainless steel tube with an outside diameter of 52 mm and a wall thickness of 5 mm is used as a…

A:

Q: At time t=0, the position vector of a particle moving in the x-y plane is r = 5.28i m. By time t =…

A: Given data as below:

Q: Learning Goal: To be able to set up and analyze the free-body diagrams and equations of motion for a…

A: Given data :-  m1 = 34 kg                        m2 = 15 kgDetermine :-1. What is the acceleration…

Q: Slider A C link (AB) = 500 mm link (BC) link (CD) = 42 mm 2 D 미 For the mechanism Shown above...…

A: Length of the link ABLength of the link BCFrom the given figure according to the lines on the page…

Q: If the allowable bearing stress for the material under the supports at A and B is o₂ = 810 psi,…

A: FBD

Q: 1. A glass fibre reinforced epoxy matrix composite contains 60 volume percent of continuous glass…

A: For glass fibre:For epoxy resin material:To determine:young's modulus of composite in longitudinal…

Q: Correct. A tank of water is on a moving cart as shown below. Water flows out of the nozzle. The…

A: The nozzle area, A 0.01 m^2The velocity of the cart, U = - 7 m/s (-ve x-direction)The volume flow…

Q: Ten (10) lines are strung between the blocks in a block-and-tackle system whose sheaves have an…

A:

Q: Slider A 1 с link (AB) = 500 mm link (BC) 42 mm link (CD) = ? D d For the mechanism Shown above...…

A: Length of the link ABLength of the link BCFrom the given figure according to the lines on the page…

Q: Compute the thread pitch and friction angle for a screw,

A: to compute the thread pitch and friction angle for a screw,

Q: PLEASE ANSWER WITH UNIT!!!!! A copper sphere having a diameter of 2 cm is initially at a uniform…

A:

Q: Determine the moment of inertia of the shaded area with respect to the centroid (lx, ly =?) 3 cm 8…

A: To Find-The moment of inertia of the shaded area with respect to the centroid (lx, ly=?)

Q: The sprinter begins from rest at position A and accelerates along the track. If the stationary…

A: rate of rotation 13.1 deg/scompute velocity when sprinter crosses the 65 m mark.

Q: Draw a complete, clearly labeled free-body diagram (FBD) of frame member AB on your paper. Member AB…

A: If a joint has only two non collinear members and there is no external load or support reaction at…

Q: Calculate the horizontal and vertical components of the hydrostatic thrust on the 90 cm radius…

A: Given data :- Radius of cylindrical cover = 90 cm = 0.9 mγwater = 9.810 kN/m³θ  = 90°h = 1.20 md =…

Q: The y-coordinate of a particle in curvilinear motion is given by y = 5.2t3 -2.6t, where y is in…

A:

Q: Determine the angle for equilibrium.

A: Given DataThe mass of the disk m =12KgThe weight of the disk W=m*g=12*9.81=117.72NThe unstretched…

Q: A car starts from rest with an acceleration of 5.6 m/s2 which decreases linearly with time to zero…

A:

Q: wo carbon plates are bonded to the upper and lower surfaces of a wooden beam. The beam is simply…

A: The length of beam, L = 900 m = 0.9 mThe width of beam cross-section, b = 20.5 mm = 0.0205 mmThe…

Q: A steel bar with a rectangular cross section of 4 inches by 3 inches is loaded by a force direction…

A: Given Data

Q: Part 2 Calculate the component of the velocity in the 0-direction. 0 eo

A:

Q: 41. A batch of pins with p(12 ± 0.01) mm in diameter is machined by means of centerless grinding…

A: Range of diameter=Number of pins=100Mean value, X=11.99 mmRoot mean square deviation,To…

Q: Past ME Board The following coa C = 70.5 % S = 3.0% A stocker fired b fuel. Calculate th pressure if…

A: Given: C=70.5%; H2=4.5%; O2=6%; S=3%; N2=1%; Ash=11%; and Moisture=4%.A stocker fired boiler of…

Q: Give the following problem a try. If you get stuck, here is one way to work it: Essential Solution…

A:

Q: The sphere P travels in a straight line with speed v= 15.6 m/s. For the instant depicted, determine…

A:

Basic Terminology in Mechanics

The area of science and mathematics concerned the motion of the objects, the relation between the force matter, and motion if specified. Forces exerted over the objects result in displacements or changes in the position of an object concerning its environment. This branch of physics keeps its roots in Ancient Greece in the form of the scripts of Aristotle and Archimedes.