22in A, 201lb disk weights 2.8ft

Q: The 51-kg homogeneous smooth sphere rests on the 36° incline A and bears against the smooth vertical…

A: Given   Mass, m = 51 kg       Angle = 36o Find  Contact forces

Q: 2. A uniform bar 6 ft long is held by ropes making angles as shown. A dead weight of 300 kg is…

A:

Q: A fixed crane as shown in Figure 5 has a mass of 2000 kg and used to lift a 4800 kg crate. It is…

A:

Q: 0.5 m dia with center of gravity at G, is parked on an 18- degree slope with its brakes off.…

A: GIVEN:- Slope:θ=18°Radius of wheel:r=0.25mg=9.81ms2 FREE BODY DIAGRAM:-

Q: Find the distance x (measured along AB) at which a horizontal force of 60 lb should be applied to…

A:

Q: A pulley-and-cable assembly supports block W and requires a downward force at P for equilibrium.…

A:

Q: A sphere is placed over the three closely packed identical spheres on a horizontal plane. All the…

A:

Q: Determine the force P required to maintain the M-kg engine in the position shown in the figure. The…

A:

Q: The 46-kg homogeneous smooth sphere rests on the 42° incline A and bears against the smooth vertical…

A:

Q: 3. The tasty fish pictured above has a mass of 1100 kg and is hanging from a cable attached via a 4…

A: Given data as per question Mass of fish = 1100 kg Length of cable = 4 m Weight of beam = 600 kg…

Q: A beam supports a distributed load as shown. Determine the reactions at the supports. 200 lb/ft 6…

A: This is the very basic question of strength of material portion. Topic:-Reaction calculation of…

Q: Question 2: Calculate the tension force that is being exerted on the box of mass 50kg. Refer the…

A:

Q: Question 24 In the same setup as in question 23, if the mass of the crane arm (including winch) is…

A: Solution for Question 24: Given, Mass of arm = m = 100 kgWeight of arm = W = mg = (100) (9.81) = 981…

Q: The 45-kg homogeneous smooth sphere rests on the 42° incline A and bears against the smooth vertical…

A: Mass of sphere, m=45 kgInclination angle of A, θ=42o

Q: A 50 kg fisherman sits at the center of the boat rented in a private resort, which has a uniform…

A: a) Calculate the load applied to the boat due to the weight of the fisherman.

Q: The square steel plate has a mass of 1820 kg with mass center at its center G. Calculate the tension…

A:

Q: The table shown weighs 30 lb and has a diameter of 4 ft. It is supportedby three legs equally spaced…

A: Let RC be the reaction at point C during tipping the table. Here, lines A and B are making 120o,…

Q: Practice Problem 4.4.9: The centers of gravity of the 50- kg lift truck and the 120-kg box are at G1…

A: Given, The mass of lift truck, m1=50 kg The mass of the box, m2=120 kg Pushing force, P=600 N

Q: The uniform boom shown below weighs 700 N, and the object hanging from its right end weighs 400 N.…

A: Draw the free body diagram of the boom.

Q: A rectangular tank of dimensions: 2 m x 1.4 m x I m deep contains fresh water to a depth of 0.6 m. A…

A:

Q: Two boxes of mass ma and mg are attached together with a rope as shown on the figure. The pulley has…

A:

Q: The platform scale consists of a combination of 3rd and 1st class levers so that the load on one…

A:

Q: Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1 and…

A: Given: Mass m1=50gMass m2=75gMass of the meter stick m3=150g

Q: Determine Horizontal force P to be applied to a block of weight 1500 N to hold in a position on a…

A: Weight of the block, W=1500 NInclination angle of smooth plane AB, θ=30o

Q: Evaluate the mass of Q suspended in the chord shown in Figure 3. Also calculate the tensions in AB,…

A: Find the mass of Q and tension in each cable.

Q: P=20 ton W= 20 tons 10' To prevent the traveling crane as shown in the fig. from tipping to the…

A: Given data: P=20 tonW=20 ton Need to determine the value and position of Q.

Q: A 14m bar of negligible weight rest in a horizontal position on the smooth planes as shown. Compute…

A:

Q: The dimensions of a jib crane are given in the figure below. The crane has a mass of 1950 kg and a…

A: To determine the horizontal component of reaction at B.

Q: 4. The block weighs 3500 kg. Find force in members AB, AC and AD.

A:

Q: Draw the free body diagram member CD

A: Given data  To draw the FBD of member CD

Q: Find the horizontal and vertical components of the reaction at A and B of plane frame loaded as…

A: The supports at A and B are pin supports, which indicates there exist horizontal vertical components…

Q: 1. The telephone pole AB weighing 3730 N is resting in a hole that is 2 m deep. If the contact force…

A:

Q: A crane boom is supported as shown. The boom has a mass of 660 kg and the box on the end of the…

A: given boom has a mass , M=660 kgbox has a mass, m=98×10=980kglength of boom, L=15mcable angle with…

Q: A basketball player weighing 200 lb hangs on the rim of the basketball hoop shown below. The…

A:

Q: A rocker arm with rollers at A and B is shown in the position when the valve is open and the valve…

A:

Q: The 39-kg homogeneous smooth sphere rests on the 36° incline A and bears against the smooth vertical…

A: Given:-m=39 kgθ=36°To find:-Find reaction forces at A and B

Q: The supporting structure of the billboard is attached to the ground by a pin at B, and its rear leg…

A: Given:

Q: d of mass m, = 163 g and length L = 100.0 cm is attached to the wall with a pin as shown. Cords are…

A: Givenuniform rod mass mr=163glength of the rod L=100cmmass m1=251gmass m1 distance from pin,…

Q: Draw the free-body diagram of the uniform bar, which has a mass of 100 kg and a center of mass at G.…

A:

Q: The square steel plate has a mass of 1830 kg with mass center at its center Calculate the tension in…

A: Given data: The mass of the square plate is m = 1850 kg. Taking G as origin the coordinate of…

Q: 4. M= 2gL %3D Joo? B:

A:

Q: Figure 4 shows a 27-kg concrete block that has been positioned on a 20° incline. As shown in the…

A: Note: As per company policy, answer of first three sub-parts of the question are provided here. You…

Q: Q15/A uniform steel plate 360 mm square with a mass of 15 kg is suspended in the horizontal plane by…

A: Consider the diagram as shown below for the steel plate.

Q: of body B in the figure that will permit the homogenous50lb block A to slide without tipping over.…

A:

Q: Exercise Figure 2.11 shows a flatboat hull that, when fully loaded, weighs 150 kN. Parts (b)-(d)…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.