25 cm2 45° 150 cm2 40 cm Water 30.0 kg/s

Q: A 3-in-diameter horizontal jet of water, with velocity 140 ft/s, strikes a bent plate, which…

A: Given data: Diameter of jet ,D = 3 in. Velocity of jet, V = 140 ft/sec Density of water, ρ = 62.4…

Q: The ourlet pipe frrom a pump is a bend of 45° rising in the horizontal plane. The inlet and outlet…

A:

Q: A jet of diesel with relative density 0.8 strikes normally a plate with a velocity of 12 m/s. The…

A:

Q: A jet of water of 75 mm diameter moving with a velocity of 15 m/s impinges on a fixed plate. Find…

A: Given, Diameter of water jet = d = 75 mm = 0.075 m Velocity of jet = v = 15 m/s Angle between the…

Q: A cylindrical tank is being filled with water flowing with constant velocity V1 through a tap (Tap…

A: Given, Diameter of the tap  1= d1 Velocity through the tap = V1 Diameter of the tank = DT. Diameter…

Q: Water flowing steadily at a rate of 0.16 m3/s is deflected downward by an angled elbow as shown. For…

A: The point 2 is taken as reference point as shown in figure below :

Q: A jet of water of diameter 7.5 cm strikes a curved plate at its centre with a velocity of 20 m/sec.…

A:

Q: A reducing elbow is used to deflect water flow at a rate of 14 kg/s in a horizontal pipe upward 30°…

A:

Q: A reducing elbow is used to deflect water flow at a rate of 95 kg/s in a horizontal pipe upward 45°…

A:

Q: Water with density of 1000 kg/m^3 flows through a horizontal pipe (in the x-z plane) bend as shown.…

A: Flux Flux is a term to describe passage through a surface. Electrical flux is how much electricity…

Q: The adjacent picture shows a pipe section in which a reduction sleeve (nozzle) is connected to the…

A:

Q: A 5-cm-diameter horizontal jet of water with a velocity of 30 m/s relative to the ground strikes a…

A: Given data: The diameter of water is given as d = 5 cm = 0.05 m. The velocity of water jet is vj =…

Q: (d) Water of density 998 kg/m is moving with a speed of 6 m/s through pipe with cross-sectional area…

A: Every real fluid existing in nature must satisfy the equation of continuity. The equation says that…

Q: A jet of water discharges into an open tank, and water leaves the tank through an orifice in the…

A:

Q: Water with density of 1000 kg/m^3 flows through a horizontal pipe (in the x-z plane) bend as shown.…

A:

Q: Water is flowing through a 15-cm-diameter pipe that consists of a 3-m-long vertical and 2-m-long…

A: Given Data: The diameter of pipe is d = 15 cm. Velocity of water leaving is v = 5 m/s. The mass of…

Q: (b) A reducing elbow is used to deflect water flow at a rate of 30kg/s in a horizontal pipe upward…

A:

Q: (b) A 9-cm-diameter horizontal water jet strikes a curved plate, which deflects the water 180° at…

A: Given- Net holding force (F) = 7 kN= 7000 N d = 9 cm = 0.09 m density of water ρ = 1000 kgm3

Q: A reversing elbow used to deflect water flow at a rate of 14 kg/s in a horizontal pipe to make a…

A:

Q: Two circular water jets (d = 0.5 in.) issue steadily from this unusual nozzle. If Vj = 80.2 ft/s,…

A: The diagram for the nozzle is given as, The velocity of water in the jet is given as,

Q: A 2.8-in-diameter horizontal water jet having a velocity of 88 ft/s strikes a curved plate, which…

A: Understand that the water is flowing through the jet is a control volume and also there are no…

Q: A three-arm sprinkler is used to water a garden by rotating in a horizontal plane. Water enters the…

A:

Q: V2 D2 60° Rx Ry D, A segment of the carotid artery (as shown) has an inlet velocity V1 = 50 cm/s and…

A: Given: Inlet Velocity (V1)=50cm/s or 0.5m/sInlet diameter D1=1.5cm or 0.015mOutlet diameter D2=1.1cm…

Q: atm FR Out A water jet with a uniform velocity profile, whose average speed is increased to 8 m/s…

A: Given data  Average speed increased = 8m/s  Outlet diameter = 10cm  To calculate  Force = ??

Q: Express the unsteady angular momentum equation in vector form for a control volume that has a…

A:

Q: Ten kilograms per second of air is flowing in an adiabatic system. At one section the pressure is…

A: a) To determine the general shape of the systemm˙=ρ1A1c1  c1=m˙ρ1A1     =m˙p1RT1A1…

Q: Tank build bro. Shown is a pressurized water tank. What is the #speed of the water exiting at point…

A:

Q: Orange juice is flowing through a horizontal U-type reducing bend at a rate of 36kg/s. The…

A: We have to determine the force applied to the reducing bend by the orange juice in the horizontal…

Q: Water with density of 1000 kg/m^3 flows through a horizontal pipe (in the x-z plane) bend as shown.…

A:

Q: Water is flowing from hole 1cm radius at the bottom of a closed cylindrical container of 2m…

A:

Q: (a) By considering the ratio of the areas A, and A, of Fig. 8.5, show that the optimum power…

A: Here, Wind Turbine Power Output : The amount of air (volume), the speed of the air (velocity), and…

Q: A converging elbow turns water through an angle of 135º in a vertical plane. The flow…

A: Draw the free body diagram Calculate the mass Flow rate m = P x Q    = 1000 x 0.4 ⇒ m = 400 kg…

Q: Q3. A pump draws water through a 20-cm suction pipe and discharges it through a 10- cm pipe in which…

A:

Q: The water (density =1000 kg/m3) leaves the nozzle (area of the nozzle=0.01 m). Assuming steady,…

A: GIVEN :- height of stagnation tube : h= 50 cm area of nozzle : A= 0.01 m2 S.G = 10.4  ρ=10400 kg/m3…

Q: A reducing elbow is used to deflect water at a rate of 14kg/s in a horizontal pipe upwards through…

A:

Q: Problem 7 Water with density Pwater = 1000 kg/m3 flows through a pipe, composed of two reduced in…

A:

Q: from an ariface at bottom at a rate 0.003 m^3/s. what is rate of change of mass of water in the…

A:

Q: 27 500 600 A cylindrical tank discharges water at 20^O C through a well-rounded orifice to hit an…

A: Given data . Water at 20°C Plate is inclined at 60° from horizontal. Find the components of the…

Q: A 3-in-diameter horizontal water jet having a velocity of 90 ft/s strikes a curved plate, which…

A: Given: The diameter of jet, d = 3 in The velocity of the jet striking curved plate, v = 90 ft/s The…

Q: Water enters a two-armed lawn sprinkler along the vertical axis at a rate of 150 L/s, and leaves the…

A: Given Data: The flow rate of water is, Q=150 L/s=150 L/s×10-3 m3L=0.15 m3/s. The diameter of the…

Q: A 4-cm-diameter horizontal stationary water jet having a velocity of 50 m/s strikes a cone having in…

A:

Q: Water with density of 1000 kg/m^3 flows through a horizontal pipe (in the x-z plane) bend as shown.…

A: Given:

Q: The open jet of water exits a nozzle into sea-level air and strikes a stagnation tube as shown. If…

A:

Q: The water (density =1000 kg/m3) leaves the nozzle (area of the nozzle=0.01 m). Assuming steady,…

A: Given:ρ=1000 Kg/m3Area,A=0.01 m2S=12.2height of stagnation tube,x=0.5 m

Q: The diameter of a tube changes gradually from 20cm at "A" to 40cm at "B". "A" is 4.5m below "B". if…

A: It is given that the diameter of pipes at A and B are 20 cm and 40 cm respectively. Therefore, the…

Q: reducing elbow is used to deflect water flow at a rate of 25 kg/s in a horizontal pipe upward by an…

A:

Q: A reducing elbow is used to deflect water flow at a rate of 14 kg/s in a horizontal pipe upward 30°…

A: We have to determine (a) the gage pressure at the center of the inlet of the elbow and(b) the…

Q: This nozzle can be used to propel a rocket. As the rocket rises in altitude the atmospheric pressure…

A: With a change in local atmospheric pressure around the nozzle, the turning angle of the exhaust flow…

Q: A 9-cm-diameter horizontal water jet strikes a curved plate, which deflects the water 180° at the…

A: For solution refer below images.

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.