3. Two (2) 30-ohm resistors are connected in series, when a resistor R is connected across one of them (connecte4d in parallel) the total circuit resistance becomes 40-ohm. Calculate the ohmic value of resistor R.

Q: =E₁ 2=E2 Vb 4.7k-2 Vab IRY E₁ lov V₂ V₂ 19 22kn b (12) R4 Parameter / Computed Va lok Eskrrr 33k-2…

A:

Q: Given: V₁ = 46 volts, V2 = 28 volts, V3 = 56 volts, R₁ = 3 ohms, R2 = 9 ohms, R3 = 1 ohms, R4 = 2…

A:

Q: 1.22 (Node-Voltage Method) Find Vo and the power delivered by the 25 V + Vy 201 2A (1 + να 350 Ω Σ…

A:

Q: Calculate the voltage gain for transformer coupled amplifier, when Vout=40mV and Vin = 5mV 08 O None…

A: Given,. In a transformer coupled amplifier, Output voltage, Vout=40 mV. Input voltage, Vin=5 mV.

Q: Consider the signal in frequency domain as X(w) = -|w| +3. Find the 80 percent energy containment…

A: Given,The signal in frequency domain is,Xω=-ω+3

Q: 3. Solve I using source conversion. 5 65V I 4 (± 50V 5 (F) 20V

A:

Q: 2. 25V M R₁ www 3802 R₂ R₁ www 2052 3052.

A: We need to solve the given circuit for current I .

Q: What is the DC resistance per phase? What is the effective resistance per phase?

A:

Q: A network containing 50 buses in which 10 are the voltage control buses, 6 are the generator buses.…

A:

Q: A 10 nC point charge is located at the origin. Calculate the electric flux passing through the…

A: It is given that: Q=10 nC=10×10-9 Cr=100 cm0<θ<π20<ϕ<2π

Q: 1. Calculate Req: Req 4Ω 8 Ω Μ Μ 6Ω 19 ΖΩ 3 Ω Ω

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: a -2 Io R3 R5 b e R₁ R6 с RA f || R₁ = 40 R₂=302 R3=802 R₁ = 20 R$ = 602 R6=502 lo=2.4A What is the…

A: We need to find out the current through given resistor for given circuit, we will use current…

Q: A conductor of length 100 cm moves at right angle to a uniform field flux density of 1.5 Wb/m with a…

A: Given, Conductor length, l = 100 cm. Moves at right angle, θ=90°. A uniform field flux density,…

Q: A 250 V, 30 Hz generator supplies power to a parallel circuit consisting of a 20 Hp motor whose…

A: Given: V=250Vf=30Hz Output power,  Po=20 hp or 20×746Po=14.920 kW Power factor, ϕ=.8 Efficiency,…

Q: Question- An amplifier without feedback has a gain of 150, input resistance of 2kQ and output…

A: It is given that: A=150Ri=2 kΩRo=5 kΩβ=0.2

Q: For the following circuit, G(s) = 1/s and H(s) = 1/(s+a) otet sosia 10-3H20-mo ►Y(s) X(s) + G(s)…

A: Given block diagram: The transfer functions are, Gs=1s,Hs=1s+a.

Q: Problem 4.12 (Node-Voltage Method) Find V₁, V₂, V₂, and vb vel 144 V + 4Ω V 80Ω Υ ανάλο γάξ 10 Ω Ων…

A: We need to find out the node voltage for given circuit, we will use nodal analysis .

Q: Problem 4.13 (Node-Voltage Method) Find Va and V₁ .6A(1 8 Ω ΥΣ 40 Ω - V₂ 80 ΩΥΣ 120 Ω Φ 1Α

A:

Q: 9. Find Rin(emitter), Ay, A₁, and Ap for the unloaded amplifier in Figure 6-57.

A: The required parameters can be calculated by using the DC and AC analysis of the amplifier circuit.

Q: 3. Solve for I and the power delivered to the 3-k resistor using Mesh Analysis and KVL at the outer…

A:

Q: Convert x to both rectangular and polar forms. 1+j7 4+j4 x =

A:

Q: 2. Determine i using superposition theorem. Show all the responses. GA ↑ 522 M $422 20V +- i↓ 652…

A:

Q: 5. The D flip-flop is created by connecting two gated D latches serially, and inverting the CLK…

A: D for Delayed A digital electrical circuit called a flip flop is used to delay the changing of its…

Q: 15-mA current flows into four parallel resistors having resistances of 4, 6, 8, and 12 k-ohm. Find…

A:

Q: Measured Voltage Computed Current Measured Current 9V. W 1,0KQ W 10KQ R1 R2 1.0KQ Figure 1 Table 1…

A:

Q: Consider the circuit shown in (Figure 1). Suppose that v₁ = 10 V and v2 = 4 V. Figure Part A Pdev =…

A:

Q: what kind of applications might use a sensor network?

A: Sensor: Sensor is a device which sense and react on some environmental factors.  The input can be…

Q: A 4MVA, 13.3 kV, 60 Hz, 3 phase, delta connected alternator has an effective resistance of 5.2 ohm…

A:

Q: 100 micron 75 micron- 2 micron 1 micron C 3 micron 50 micron b) If a voltage of 5V is applied across…

A:

Q: In intrinsic GaAs, the electron and hole mobilities are 055 and 0.04 respectively and m² V-s…

A:

Q: 2. Table 1 gives the types and size of various loads that will be connected to a three-phase…

A: given that there are 20 lamps, 10 1phase motors, 5 3phase motors connected as loads to a 3phase…

Q: Given the following circuit, 24 V +1 20 Ω 40 Ω www 10 Ω 20 Ω 60 Ω 50 Ω Find the equivalent…

A: Given, Supply voltage, VS=24 V

Q: Vino VDD M3 M₂ 4M₁ (c) Vout

A:

Q: A shunt generator has a no load voltage of 125 V and voltage regulation of 6%. Calculate the full…

A: Given: A shunt generator has no load voltage = 125 V and voltage regulation = 6 % To find: full load…

Q: Measured Voltage 9 V. Computed Current Measured Current -W- 1.0KQ R3 1.0KQ R1 R2 >1.0kQ Figure 1…

A:

Q: 1. Plot the root Locus of the the control system given below

A: Given- GsHs=Ks+3ss+1s+2s+4 To find- Root locus for the given system =?

Q: Question 03: Use Boolean theorem to prove the following i. Y + XZ + XY = X+Y+Z ii. (A + C). (A + B).…

A:

Q: *** . . V1 9 V. ** R1 10KQ R3 1.0KQ ** … * * R5 >1.0kQ . W 1.0KQ R4 1.0KQ * ***** *** V2 12 V.

A:

Q: A 25 kW, 240 V self excited dc shunt generator has a field circuit resistance of 62.5 02, and an…

A: Given, Power, P=25 KW field winding resistance, Rf=62.5 Ω armature winding resistance, Ra=0.05 Ω…

Q: use the mesh-current method to solve for the current through each of the 5 resistors in the circuit…

A: Given here a circuit and asked to find the currents through the resistors.

Q: 3. Solve Ix and all the mesh currents using mesh analysis. lov ( + 15V (+ 252 1₁ 65 13 Me 75 =102 8…

A:

Q: Fig. 1 2- If Rg in the circuit shown in the given in Fig.2, is variable between 2002 and 802, then…

A: This is a problem of maximum power transfer theorem. The detailed solution is given in the next step…

Q: c) Determine the electromotive force when t = 3 s. d) Find the maximum and/or minimum electromotive…

A: Given,The function for current is,It=9 cos120πtWhere,I=current Ampt=time sec

Q: 1. Calculate for the power delivered to the 2-kΩ resistor using Mesh Analysis. 2mA (1 3ΚΩ 12mA 2ΚΩ…

A: In this question we need to find a power consumed by 2 kohm resistance.  To determine power we need…

Q: For an FM modulator with a modulation index m = 1.5, a modulating signal vm(t) = Vm sin(2000πt), and…

A: Given: Modulation index, m=1.5 Modulating signal, vm(t)=Vmsin2000πt vm(t)=Vmsin2π×1000πt…

Q: Find the electric field intensity at point P(2,–3, 8) in the field of a point charge of 50 nC/m at…

A:

Q: Use the mesh-current method to find the branch currents ia , ib, and ie in the circuit in (Figure…

A: We need to find out current for given circuit, first we will find out the node voltage then we will…

Q: I. CONVERT THE FOLLOWING NUMBER SYSTEM. OCTAL BINARY 10101100.001 715.32 DECIMAL HEXADECIMAL

A:

Q: Three resistors of 6-ohm resistance are connected in delta. Inside the delta are three 4-ohm…

A: Given, Three 6 ohm resistors are connected in a delta configuration, Three 4 resistors are connected…

Q: What will happen to minor carrier density, total carrier density, and Efn if we add iron and boron?…

A:

Current Division Method

The generalized current divider formula is given by the following relation below,