Answered: 3/5 The 20-kg homogeneous smooth sphere…

3/5 The 20-kg homogeneous smooth sphere rests on the two inclines as shown. Determine the contact forces at A and B. Ans. NA = 101.6 N, Ng - 196.2 N

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.26P: The homogeneous bar AB weighs 25 lb. Determine the magnitudes of the forces acting on the bar at A...

See similar textbooks

Related questions

Q: The 42-kg homogeneous smooth sphere rests on the 26° incline A and bears against the smooth vertical…

Q: الواجب 3 H.W. ) F3-5. If the mass of cylinder C is 40 kg. determine the mass of cylinder A in order…

Q: The shear leg derrick is used to haul the 200-kg net of fish onto the dock. Determine the…

Q: 4 kN 4) The uniform 200 kg beam AB is supported by a pin and a roller as shown. Determine the…

Q: - 5 ft- - 2 ft Question 1: 150 lb/ft Determine the resultant forces at pins B and C on member ABC of…

Q: Q4/ The jib crane is supported by a pin at C and rod AB. If the load has a mass of 3 Mg with its…

Q: The 46-kg homogeneous smooth sphere rests on the 32° incline A and bears against the smooth vertical…

A: When an amount of push or the pull applied on the object, it has the ability to change its state…

Q: If the box shown has a mass of 10 kg, determine the couple moment M needed to maintain equilibrium…

A: Given data: The mass of the block, m = 10 kg The angle when equilibrium is maintained, θ = 60o The…

Q: *R5-8. Determine the resultant forces at pins B and C on member ABC of the four-member frame. -1.25…

A: The free-body diagram of the frame showing the reactions at joints can be sketched as follows,

Q: 300 mm -700 mm and brake bar is = 0-4. If the moment %3D -125 mm M = 35 N-m, determine the smallest…

Q: 3-10. Determine the tension developed in wires CA and CB required for equilibrium of the 10-kg…

A: Let the tension in wire AC and BC be TA and TB respectively.

Q: The bobcat loader (Figure Q3) has a mass of 1200-kg, shows the center of mass is at G1. If there is…

Q: The ramp of a ship has a weight of 107.6 lb and a center of gravity at G. Determine the cable force…

Q: F3-3. If the 5-kg block is suspended from the pulley B and the sag of the cord is d=0.15 m,…

Q: The boy at D has a mass of 50 kg, a center of mass at G, and stands on a plank at the position…

Q: C4-3. Draw the free-body diagram of the wing on the passenger plane. The weights of the engine and…

Q: 3-45. If the bucket and its contents have a total weight of 20 lb, determine the force in the…

Q: Draw the Free-Body Diagram if the weight acts on point G

Q: Probs. 3-1/2 -3. If the mass of the girder is 3 Mg and its center of mass s located at point G,…

A: Givenmass of grinder =3mg

Q: 1. Determine the horizontal and vertical components of reaction at the supports. Neglect the…

Q: Determine the force acting along the axis of each of the three struts needed to support the 500-kg…

Q: Determine the magnitude of the pin force at A. Assume W = 675 lb, a = 2.7 ft, b = 2.0 ft, r = 9 in.…

Q: 3/3 The weight of the bicycle is 29 lb with center of grav- ity at G. Determine the normal forces at…

Q: Q.2. Determine the horizontal and vertical components of force at pins B and C. The suspended…

A: Solution Given data Mass (m)=75 kg

Q: 3-63. The crate has a mass of 130 kg. Determine the tension developed in each cable for equilibrium.

Q: Q-2: The woman exercises on the rowing machine. If she exerts a holding force of F = 350 N on handle…

A: Answer: (a) The horizontal and vertical reaction at point C: Rc,x = 818.1333 N ; Rc,y = 105.3105 N…

Q: The mass center G of the 1235-kg rear-engine car is located as shown in the figure. Determine the…

A: Given Data The mass of the car is:m=1235 kg To find: The normal force under each of the front…

Q: 1) Determine the (a) magnitude P the force which the man must cxcrt to the handle of the…

Q: P-

Q: *3-16. Determine the stretch of each spring for equilibrium of the 20-kg cylinder. Prob. 3-16 B 4 m…

A: Given DatakAD=400N/mkAC=200N/mkAB=300N/mW=20kg

Q: Determine the horizontal and vertical components of force at pins A and D. D 2 m 0.3m A -1.5m- |B…

A: Free Body diagram

Q: Q5/ A 120-lb crate rests on the 60-lb pickup -14"- tailgate. Calculate the tension T in each of the…

A: We take the moments of the various forces about the point O by assuming counter-clockwise moments…

Q: 3-9. Determine the maximum weight of the flowerpot that can be supported without exceeding a cable…

Q: 3/4 The 20-kg homogeneous smooth sphere rests on the two inclines as shown. Determine the contact…

Q: F4-7. The uniform plate has a mass of 200 kg. Determine the tension in each of the supporting…

A: Take the moment about y-axis ∑My=0TA4-220-1.9622=0TA=40+3.9244TA=10.981 kN

Q: If the mass of the flower pot is 85 kg, determine the tension developed In each wire for…

Q: 3-19. Determine the unstretched length of DB to hold the 40-kg crate in the position shown. Take k =…

Q: 3/3 The weight of the bicycle is 29 lb with center of grav- ity at G. Determine the normal forces at…

Q: F3-2. The beam has a weight of 700 lb. Determine the shortest cable ABC that can be used to lift it…

Q: 60 m 390 mm 600 mm Q-2 Q-2: If the 280-kg drum has a center of mass at point G, determine the…

Q: P5-3. then draw the free-body diagrams of each member of the identify any two-force members, and…

A: The two force members are member BC and member AB. The free-body diagram of the member AB is: Here,…

Q: The mass center Gof the 1235-kg rear-engine car is located as shown in the figure. Determine the…

Q: *3-48) Determine the tension in the cables in order to support the 100-kg crate in the equilibrium…

Q: The bobcat loader (Figure Q3) has a mass of 1200-kg, shows the center of mass is at G1. If there is…

Q: The weight of the bicycle is 29 Ib with center of gravity at G. Determine the normal forces at A and…

Q: 3-2. The members of a truss are pin connected at joint O. Determine the magnitude of F and its angle…

A: Given: The forces on the truss is shown below: F2=6 kN

Q: The structure below supports a 4-kN force. It is constrained by the cords BC and BD and by a…

Q: 3/6 The 20-kg homogeneous smooth sphere rests on the two inclines as shown. Determine the contact…

A: Given data :- Mass = 20 kg Angles = 75° and 30° Find :- Contact forces at A and B ?

Q: The ramp of a ship has a weight of 1000 N and a center of gravity at G. Determine the cable force in…

Question

3/5 The 20-kg homogeneous smooth sphere rests on the
two inclines as shown. Determine the contact forces at
A and B.
Ans. NA - 101.6 N, Ng - 196.2 N
75°
B
30
Problem 3/5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The homogeneous bar AB weighs 25 lb. Determine the magnitudes of the forces acting on the bar at A and B. Neglect friction.
The homogeneous 240-lb bar is supported by a rough horizontal surface at A, a smooth vertical surface at B, and the cable BC. Draw the FBD of the bar and count the unknowns.
Determine the smallest horizontal force P that would push the homogeneous cylinder of weight W over the curb. Neglect friction.
Determine the horizontal force P that would keep the uniform 12-kg rectangular plate in the position shown.
The pulley-cable system supports the 150-lb weight. The weights of the pulleys and the horizontal bar ABC are negligible. Determine the cable tensions at A and C and the distance x.
3/5 The 20-kg homogeneous smooth sphere rests on the two inclines as shown. Determine the contact forces at A and B. Ans. NA 101.6 N, NB = 196.2 N %3D 75° 30° Problem 3/5
The 46-kg homogeneous smooth sphere rests on the 42° incline A and bears against the smooth vertical wall B. Calculate the contact force at A and B. Assume 0 = 42°. B Answers: FA = i 607.23 N FB = i 406.31 ! N
The 44-kg homogeneous smooth sphere rests on the 36° incline A and bears against the smooth vertical wall B. Calculate the contact force at A and B. Assume 0 = 36° Ө Answers: FA= i FB = i B N N
Q3 The 20-kg homogeneous smooth sphere rests on the two inclines as shown. Determine the contact forces at A and B. Ans. NA 101.6 N, N =196.2 N SEF 75° 30 Se sesultant Dr. Hazim Umran Alwan
The 50-kg homogeneous smooth sphere rests on the 30° incline A and bears against the smooth vertical wall B. Calculate the contact forces at A and B. 1 B 30° A
The 79-kg homogeneous smooth sphere rests on the ( 2.3/2.4) incline A and bears against the smooth vertical wall B. Calculate the contact forces at A and B. Note: slope y/x В y A
The uniform rod AB has a mass of 75 kg . There is a smooth collar at A. A) Determine the force in the cable when the rod is in the position shown. TBC = ?