357.) The uniform rod in Fig. P-357 weighs 420 lb & has its center the reac- of gravity at 0. Determine the tension in the cable & t tions at the smooth surfaces at A&R N sin45* W=420lb B 2' Cable T N NCO645

Q: For a standard normal distribution, find: P(z < 2.11)

A: Given: P(z &lt; 2.11)= P(- ∞ &lt; z &lt; 0)+P(0&lt;z&lt;2.11)

Q: Determine the vertical deflection at the point where the 100N-m moment is

A: The values given in the question are as follows: Span of beam(L)=4 m Downward force(P)=500 N (at 1 m…

Q: Refer to the constant-head permeability test arrangement in a two-layered soil as shown in Figure…

A: i have not drawn the diagram again because it already drawn in question.   i used the simplified…

Q: roads with grades of +4.5% and -3% meet at station 15 + 100 at an elevation of 72.344 m. If the…

A:

Q: 3. For the piping system shown, the flow rate is 18 ft³/s of water (p = 1.94 slugs/ft³). Compute the…

A: Calculation of Pressure drop between junction point and Discharge in Each pipe####

Q: N 1200N 400 mm 150 5 mm tipico 20 mm 25 mm 20 mm (b) 45 mm

A:

Q: Convert the bearing into azimuth from north. N 20° 20' E

A: given - bearing N 20° 20' E   to find - azimuth from north

Q: roblem Number 7. olve for all the moment reaction and forces in the frame shown, the frame is not…

A:

Q: A double cantilever beam 25 m long is supported 6m from the ends. Section is 300mm x 750mm. It is to…

A:

Q: Using the slope-deflection method, draw the bending moment diagram. Determine the moment at A. B 3m…

A:

Q: 3. Determine the strain energy of the beam shown in the figure below. The cross-sectic beam is…

A:

Q: The two reservoirs connected by a smooth pipe below contain water at 20 °C. Ignoring minor losses in…

A:

Q: A circular swimming pool full of water has a diameter of 24 ft and the sides are 5 ft high. Set-up…

A:

Q: Obtain 0.5 Hr-UH from 2 Hr UH using S-Curve having Base Flow 8.900 cfs and catchment area 6526000 sq…

A:

Q: For the beam subjected to the loadings as shown, determine the following: 52 kN 40 kN/m 2m 4m B 2m C…

A: a. draw the shear and moment diagrams specifying values at all change of loading positions and at…

Q: A railway in the form of a vertical symmetrical curve linking two slopes 3.5%-=g=0.5%,g and its…

A: PVCelv=PVIelv-g1L2PVCelv=268.6-0.035L2Distance for summit point :x=g1g1-g2(L)x=2.53.5+0.5(L)=0.625L

Q: meters to the fourth power. Analyze the beam using area moment method.

A: Moment Area Method Of Analysis It is one of the method used for finding displacements of structural…

Q: The face of a vertical dam has the shape of an isosceles triangle of altitude 4 m with an upper base…

A:

Q: Three pipes of 400 mm, 350 mm and 300 mm diameter are connected in series between two reservoirs…

A: In this question 3 pipes are given which are in series network all types have different length and…

Q: The rigid bar of ABCD of negligible weight is supported hinge at A, steel rod at B and bronze rod at…

A:

Q: Explain each: The two physical zoning concepts: How these zoning concept can be apply in a simple…

A: Zoning categories and symbols vary among communities. A C-1 zone in one city is not necessarily the…

Q: 8. List the relations that control the connection of pumps in series, when we use this type of…

A: Hey there, Here Will know relations that can control the connection of pumps in series'   And also…

Q: STATICALLY INDETERMINATE BEAMS Using Double Integration Method and/or Moment Area Method, answer…

A:

Q: A ductile material is subjected to a tensile test. The yield strength was determined to be 100 MPa.…

A:

Q: A cantilever beam, carries a uniformly distributed load W, determine the maximum deflection of beam.…

A:

Q: Water is pumped from reservoir A at elevation 30m through 1200m of 600mm diameter pipe to reservoir…

A: Given :

Q: Looking at the x direction, provide the front view, top view, line. Provide also the given dimension…

A:

Q: Problem 4. Construct moment diagrams for the beam using superposition method. 500 N 450 N/m 2m 480 N…

A:

Q: THIN WALLED PRESSURE VESSELS SITUATION: A cylindrical water tank is 8 m in diameter and 12 m long.…

A:

Q: A 76.6% saturated soil has a moisture content of 38.4% and a specific gravity of 2.683. Find the…

A: Given data : The value of specific gravity G=2.683 The value of moisture content w=38.4100=0.384 The…

Q: * ски/т П вт B 4.5m 8KN m

A:

Q: Petroleum was made to flow through 2.0km in a pipe with diameter of 0.28m. The rate of flow is 36…

A:

Q: Q2: For the stresses at the point shown, find: • The maximum shearing stress. • The principal…

A:

Q: For a standard normal distribution, find: P(-0.68 < z < 1.52)

A: Given data: P(- 0.68&lt;z&lt;1.52)

Q: Problem Number 5 h = 8 m A 1 kN F B C E G 5 kN 5 kN 5 kN 1 kN 1 kN 1 kN K -6 panels @ 5 m = 30 m- D…

A:

Q: Problem 3. Draw the shear and moment diagrams for the beam. 500 N 450 N/m -X A 2m 480 N 920 N -2 m…

A:

Q: Q2: For the stresses at the point shown, find: • The maximum shearing stress. The principal stresses…

A:

Q: 1 kN F 1 kN J B C E G 5 kN 5 kN 5 kN 1 kN D 1 kN I K -6 panels @ 5 m = 30 m- 1 kN h=8m LA 12.…

A:

Q: 3. Determine the strain energy of the beam shown in the figure below. The cross-section of the beam…

A:

Q: the slope-deflection method, draw the bending moment diagram. 3m B 2EJ 4m 20kN/m 3m 5. Moment @D…

A:

Q: 3. Determine the strain energy of the beam shown in the figure below. The cross-section of the beam…

A: Determine the strain energy of the beam shown in the figure below.

Q: 3. Determine the strain energy of the beam shown in the figure below. The cross-section of the beam…

A:

Q: Consider the following particulars in respect of a concrete mix design: Specific Gravity Weight 400…

A: To Determine Weight of fine aggregates.

Q: governed? Write down the well-known amete

A: Introduction the turbomachine are gadgets in which energy is moved consistently streaming liquid by…

Q: Calculate the total stress, pore water pressure and effective stress at point and C. If the…

A: step 1-

Q: Which one is the most efficient VOD (m/s) design for an explosive with a density of 1.6 gr/cc and…

A: ∈= 75.5 Gpa  density of rock (γr)= 2.75 g/cc density of explosive (γe)=1.6 g/cc To find - VOD design…

Q: Problem 2. Determine the equations for shear and bending moment for the beam shown. 45 kN/m 30 kN/m…

A:

Q: The following figure shows the graphs of a normal distribution, a t- distribution with 1 degree of…

A: In this question 3 normal distribution curve is given and we are ask to find out the correct option

Q: Compute for the latitude of Line 1-2 A +4.81 B) +5.79 +8.03 D -18.63 Question 11 Compute for the…

A: Data is as given

Q: A vertical angle of +12352'25" is measured to a station at the top of a hill from an instrument…

A:

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.