[4} What is the pH of the solution in the flask after 25.00 mL of 0.110 M NAOH has been added to 50.00 mL of 0.108 M HCIOsolution using phenolphthalein as an indicator? The K, of HCIO is 3.0x10 at 25°C.[5] On the back of the quiz, derive the acıd form of the Henderson-Hasselbalch Equation (above) as was done in class.

Answered: Image /qna-images/answer/84c9c628-ec5b-4658-b575-ac37fbd9d1d5.jpg

Answered: [4} What is the pH of the solution in…

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter14: Principles Of Neutralization Titrations

Section: Chapter Questions

Problem 14.38QAP

See similar textbooks

Similar questions

Calculate the pH after mixing 15 mL of 0.12 M acetic acid with 15 ml of 0.12 M NaOH. What are the major species in solution at equilibrium (besides water), and what are their concentrations?
Sketch a titration curve for the titration of potassium hydroxide with HCl, both 0.100 M. Identify three regions in which a particular chemical species or system dominates the acid-base equilibria.
A sodium hydrogen carbonate-sodium carbonate buffer is to be prepared with a pH of 9.40. (a) What must the [ HCO3 ]/[ CO32 ]ratio be? (b) How many moles of sodium hydrogen carbonate must be added to a liter of 0.225 M Na2CO3 to give this pH? (c) How many grams of sodium carbonate must be added to 475 mL of 0.336 M NaHCO3 to give this pH? (Assume no volume change.) (d) What volume of 0.200 M NaHCO3 must be added to 735 mL of a 0.139 M solution of Na2CO3 to give this pH? (Assume that volumes are additive.)
Amino acids are an important group of compounds. At low pH, both the carboxylic acid group (CO2H) and the amine group (NHR) are protonated. However, as the pH of the solution increases (say, by adding base), the carboxylic acid proton is removed, usually at a pH between 2 and 3. In a middle range of pHs, therefore, the amine group is protonated, but the carboxylic acid group has lost the proton. (This is called a zwitterion.) At more basic pH values, the amine proton is dissociated. What is the pH of a 0.20 M solution of alanine hydrochloride, [NH3CHCH3CO2H]Cl?
The pH of 0.10 M CH3NH2 (methylamine) is 11.8. When the chloride salt of methylamine, CH3NH3Cl, is added to this solution, does the pH increase or decrease? Explain, using Le Chteliers principle and the common-ion effect.
Enough water is added to the buffer in Question 30 to make the total volume 5.00 L. (a) Calculate the pH of the buffer. (b) Calculate the pH of the buffer after adding 0.0250 mol of HCl to 0.376 L of the buffer. (c) Calculate the pH of the buffer after adding 0.0250 mol of KOH to 0.376 L of the buffer. (d) Compare your answers to Question 30 (a-c) with your answers to (a-c) of this problem. (e) Comment on the effect of dilution on the pH of a buffer and on its buffer capacity. Â
Methyl orange, HMO, is a common acid-base indicator. In solution it ionizes according to the equation: HMOaqH+aq+MO-aqredyellow If methyl orange is added to distilled water, the solution turns yellow. If 1 drop or two of 6 M HCl is added to the yellow solution, it turns red. If to that solution one adds a few drops of 6 M NaOH, the color reverts to yellow. a. Why does adding 6 M HCl to the yellow solution of methyl orange tend to cause the color to change to red? Note that in solution HCl exists as H+ and Cl- ions. b. Why does adding 6 M NaOH to the red solution tend to make it turn back to yellow? Note that in solution NaOH exists as Na+ and OH- ions. How does increasing OH- shift Reaction 3 in the discussion section? How would the resulting change in H+ affect the dissociation reaction of HMO?
Calculate the pH of a solution prepared by mixing 49.0 mL of butyric acid, HC4H7O2, with 6.15 g of KOH in water. The following data about butyric acid may be helpful: density=0.9595g/mL;K a =1.54105
You dissolve 0.425 g NaOH in 2.00 L of a solution that originally had [H2PO4]=[HPO42] = 0.132 M. Calculate the resulting pH.
A 0.400-M solution of ammonia was titrated with hydrochloric acid to the equivalence point, where the total volume was 1.50 times the original volume. At what pH does the equivalence point occur?
A good buffer generally contains relatively equal concentrations of weak acid and conjugate base. If you wanted to buffer a solution at pH = 4.00 or pH = 10.00, how would you decide which weak acidconjugate base or weak baseconjugate acid pair to use? The second characteristic of a good buffer is good buffering capacity. What is the capacity of a buffer? How do the following buffers differ in capacity? How do they differ in pH? 0.01 M acetic acid/0.01 M sodium acetate 0.1 M acetic acid/0.1 M sodium acetate 1.0 M acetic acid/1.0 M sodium acetate

Recommended textbooks for you

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry: Matter and Change

Chemistry

ISBN:

9780078746376

Author:

Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:

Glencoe/McGraw-Hill School Pub Co

Chemistry: Principles and Reactions

Chemistry

ISBN:

9781305079373

Author:

William L. Masterton, Cecile N. Hurley

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

[4} What is the pH of the solution in the flask after 25.00 mL of 0.110 M NAOH has been added to 50.00 mL of 0.108 M HCIO solution using phenolphthalein as an indicator? The K, of HCIO is 3.0x10 at 25°C.