(Physical Chemistry Question) 4. The vapor pressures of benzene and toluene have the following values in the temperaturerange between their boiling points at 1 bar;T, °C79.488941001101.5261.801P*(C,H), barP*(C-Hs), bar1.001.2850.5080.6160.7421.00a) Calculate the composition of the vapor and liquid phases at each temperature and plotthe boiling point diagram.dreamstie

The law which states that the partial vapor pressure of solution is equal to the mole fraction…

4. The vapor pressures of benzene and toluene have the following values in the temperature between their boiling points at 1 bar; T, °C P*(CHs), bar | P*(C-Hs), bar range 79.4 88 94 100 110 1.00 1.285 1.526 1.801 0.508 0.616 0.742 1.00 a) Calculate the composition of the vapor and liquid phases at each temperature and plot the boiling point diagram.

4. The vapor pressures of benzene and toluene have the following values in the temperature between their boiling points at 1 bar; T, °C P(CHs), bar | P(C-Hs), bar range 79.4 88 94 100 110 1.00 1.285 1.526 1.801 0.508 0.616 0.742 1.00 a) Calculate the composition of the vapor and liquid phases at each temperature and plot the boiling point diagram.

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter6: Equilibria In Single-component Systems

Section: Chapter Questions

Problem 6.62E

See similar textbooks

Similar questions

A solution containing 1.470 g of dichlorobenzene in 50.00 g of benzene boils at 80.60 degree C and a pressureof 1.00 bar. The boiling point of pure benzene is 80.09 degree C, and the molar enthalpy of vaporization of purebenzene is 32.0 kJ/mol. Determine the molecular mass of dichlorobenzene
Consider a system where 2.40 mol of CH3CN(g) are converted into CH3CN(1) at 1.00 atm and 82.0 °C. The normal boiling point of CH3CN is 82.0 °C, and AvapH much less than the volume of CH3CN(g). 29.75 kJ mol-1. Assume the volume of CH3CN(I) is What is the enthalpy change for the process described above? Enter your answer in kilojoules accurate to three significant figures. Do not use scientific/exponential notation. AH= Number kJ. What is the work done during the process described above? w= -7087.0 J w= 798.2 J w= -69.9 J w = 69.9 ) w = 7087.0 J O O O
The vapour pressure of a liquid at 35°C is 0.60 bar and its enthalpy of vaporization is 40 kJ/mol. What is the boiling point of this liquid (in °C) at the atmospheric pressure of 1.00 bar?
The vapour pressure of hexane between -10°C and +90°C fits the expression log(p/Torr) = 7.724 – 1655/(T/K). Calculate the enthalpy of vaporization.
1-Octanol (C8H18O) is a compound used for the synthesis of important component in perfume production (esters). The approximate enthalpy of vaporization of 1-octanol was found to be 72.37 kJ mol–1 and the vapor pressure of 1-octanol was measured to be 6.863 kPa at 20.05 °C. At what temperature (in °C, to two decimal places) would the vapor pressure of 1-octanol equal 0.781 kPa?
Q3b. Draw and explain the phase diagram of sulfur system. At 200 °C, the specific volume of water and steam are respectively 1 c.c. and 1673 c.c. Calculate the change in vapour pressure of the system by 20 °C change in temperature. The molar heat of vaporization of water in this range may be taken as 9.70 K cal.
Melting enthalpy of ice at 1 bar 9.134 kJ /mol; At 0 ° C, the density of water is 999.9 kg m-3, and the density of ice is 812.0 kg m-3. Assuming that the molar volume and enthalpy change in fusion are constant, find the freezing point of water at 85 bar using the information given?
3. A 12.0 cm3 sample of liquid H2O (density 1.00 g.cm-3) is heated to 328 oC under an external pressure of 0.8 atm, conditions under which it vapourises: (i) Calculate the volume of the gas. (ii) Calculate the mass of the same volume (as in part i) of CO2 gas under the same conditions. (iii) Calculate temperature of that sample of CO2 (as in part ii) at 8.0 atm pressure in a 20.0 L container.
P8.10 The normal melting point of H2O is 273.15 K, and AfusH freezing point at 200. and 400. bar, assuming that the density of the liquid and solid phases remains constant at 997 and 917 kg m, respectively. Explain why your answer is positive or negative. = 6010 J mol. Calculate the change in the normal -3
At 25 °C, the equilibrium vapour pressure of ethanol is 0.0821 bar. The standard enthalpy of vapourization is 39.28 kJ/mol. What is the boiling point of ethanol at standard pressure? In other words, at what temperature does the equilibrium vapour pressure of ethanol reach 1.000 bar? Report your answer in degrees Celsius, but do not include the units in the answer. Report your answer to the nearest degree.
Solid benzene melts at 28.35 °C when the pressure is 85.2 MPa. The molar volumes of solid and liquidbenzene at these conditions are 74.25 cm3 mol-1and 82.55 cm3 mol-1, respectively.High Temperature Materials and Processes 26 (2007) 365-369 a. When the pressure is increased to 128 MPa, benzene is found to melt at 39.85 °C. Calculate theenthalpy and entropy of fusion of the solid. b. Estimate the freezing temperature of benzene at 92.5 MPa
Part B At a particular temperature, the vapour pressure of acetone is 0.2270 bar. Suppose the temperature is suddenly decreased to 268.00 K. Compute the 4,G under these conditions. Hint you will require A = 29.11 kJ mol and AS, = 88.40 J K' mol". O 5.42 kJ mol 56.10 kJ mol O 8.72 kJ mol O 2.12 kJ mol O 5.42 kJ mol