5. A welder machine operates automatically as follows : 30A current in 10 seconds, 20A in 10 sec., 10A in 10 sec. And finally 30A for 20 sec. To complete one cycle. What is the equivalent rms value over one cycle?

Q: rotor resistance and reactance per phase of a 4-pole, 50-Hz, 3-phase  induction motor are 0.025 ohm…

A:

Q: 5- Find the efficiency of a 150KVA transformer at 25%, 33% and 100% full load at: a/ unity power…

A: In this question we need to find a efficiency of transformer for the given condition.

Q: If the roots of the characteristics equation z=0.5347t0.5543 rad and sampling time=0.5sec., the…

A: Given  Roots of the characteristic equation Z=0.5347∠±0.5543 radSampling time T=0.5 sec

Q: USING SUPERPOSITION THEOREM FIND THE CURRENT FLOWING THROUGH ALL IMPEDANCES. SHOW YOUR…

A:

Q: Determine the saturation current (Ic...) for the network of Fig. 122 For the emitter-stabilized bias…

A:

Q: Q.2. Four- Terminal RLC-Network : Sct) Find output voltage Vit) R= 20, L= 1, C = l04 Input voltage s…

A: We need to find voltage across capacitor in series RLC circuit .

Q: 5) The switch in the circuit below has been closed for a long time. At t = 0, the switch is opened.…

A:

Q: Two inductances L1 and L2 are connected in series with mutual inductance M. If the total inductance…

A:

Q: Find the individual currents using the following methods. Show your complete solution. Mesh…

A: P

Q: Find F(-1). 2e3t sin (2t)- 3e cos (2t) Round-off to 1 decimal place. Answer: 0.8

A: In this question,   We need to determine the value of f(t) at time t= -1s

Q: How much current will flow in a series RLC circuit when VT = 100 V, XL = 160 ohms XC = 80 ohms , and…

A:

Q: Refer to Figure below. Determine the output voltage -4 Vo VOUT 3 v 7V O -7 V O +Vsat O -Vsat O

A:

Q: A CE amplifier uses a Wilson source as an active load. npn transistors have a beta    of 100 and an…

A: The Wilson source is a type of current source. It is used as a current mirror in various…

Q: Shift registers are essentially directional * circuits that shift every bit of data True O False O

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: 1. Find the Total Resistance RAB in the circuit. 4 kn 4 kN ww RAB 6 KN 3 kn 12 kn B kn Bo

A:

Q: Calculate the power and voltage of the dependent source in the circuit below. is 15 N U 3 N< 9N<…

A:

Q: D *7.115 For the circuit in Fig. P7.115, assuming all transistors to be identical with ß infinite,…

A:

Q: Two inductances L1 and L2 are connected in parallel with mutual inductance M. The inductance in coil…

A: In this question we will find mutual inductance in parallel opposing circuit....

Q: 50Ω resistor, a 20mH coil and a 5uF capacitor are all connected in parallel across a 50V, 100Hz…

A:

Q: (a) Figure Q1 (a) shows a 85 turn's coil of wire wrapped around an iron core. If the flux in the…

A:

Q: A discrete-time signal x(n) is illustrated in Figure 3.1. x(n) ... 0.25 0.0625 0.015625 오 -3 -2 -1 1…

A: a) To represent the signal in discrete-time domain x(n) and then convert it into frequency domain…

Q: 2. Find the Total Resistance RAB in the circuit 3 kn ww 4 kn 2 kn RAB 12 kn 2 k B 4 kn 4 kn 2 kn

A: We need to find equivalent resistance for given circuit .

Q: What is the impedance of the circuit in the given circuit? Vs R1 12 V 1.2 ko 4.5 mH 0.001 µF 47 kHz…

A:

Q: d. Vc- e. VB- f. Ve-

A: We need to find out voltage for bjt .

Q: QUESTION 1 The switch in the circuit in figure below has been closed for a long time. At t = 0, the…

A: as per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions…

Q: Given the transistor circuit with beta as 100. Answer the following items below. 270 k Ohrh -16 V…

A: The solution is given below

Q: 3. Three charges and their specific locations are given as follows: q1 = - 20 nC; (0, 3.00 cm) q2 =…

A:

Q: the circuit operates at 60 hz, the rms of the voltage is 120 volts, the resistor has a value of 40…

A: In this question we will find parallel circuit impedance , current , total current ,phasor…

Q: Electronic Circuit Lab 2. Determine the diode is contacting or not. 52 102 ww F, = 12 V- V 10 V 3.…

A:

Q: Find i(t) for t>0 in the circuit of Fig. 1 t = 0 10Ω 60 Ω 1 mF 30 V 40 2 2.5 H Figure 1 www

A:

Q: 2) The switch in the circuit below has been closed for a long time, and it opens at t = 0. Find v(t)…

A:

Q: The function Y represented by this logic circuit may be written :D A В C OY = (A+B) + C | Y = (A + B…

A: In this question,   We need to choose the correct options We know  (AB)'= A'+B'  (A')'= A

Q: -1, 1, 0, 1<n<4 SInl, 0, -3 < n< 3 x (п) y(n) -4 <n< -1 — elsewhere elsewhere

A:

Q: Q /Find current, voltage, total current, and total voltage using a superposition? 1502 L17 52 12V 5…

A:

Q: What is the impedance of the circuit? R110 ka 317V 1.5 kHz G+0.01 µF 3H O A. 12.2 ko О в. 14.5 ko О…

A:

Q: Y = A+ B ? Which circuit(s) below represent the function A Y B (i) (i) A A Y (iii) (iv)

A: In this question,   We need to choose the options What is correct circuit for the implement Y=…

Q: VD Rp2 Rp M1 M2 V2 V11 R. V. ss D0 V Figure 4

A: Types of differential amplifier  Singal input balanced output differential amplifier  Dual input…

Q: Ris A V2 sis ww sig Figure 4(b) Figure 4(a)

A: We need to find out Miller impedance for given circuit .

Q: What is the impedance of the circuit in the given circuit? R1 HE 220 a 0.47 µF 25 mH Vs 20 V 800 Hz…

A:

Q: (a) A four-pole three-phase induction motor operate at 50-Hz. It has the no-load speed of 2940 rpm…

A:

Q: Explain this diagram for a dummy

A: The given circuit is as shown below,

Q: With the aid of suitable diagrams, explain the occurrence of crossover distortion in the basic Class…

A:

Q: 6. The terminal voltage of a 2H inductor is V=10(1-t) V. Find the current flowing through the…

A: In this question we have given terminal voltage across inductor....We have to find out current at…

Q: Q /Find current, voltage, total current, and total voltage using a superposition? 1502 17 52 34752…

A: According to superposition principle,  in a linear bilateral network the response in any branch is…

Q: connected in parallel. This combination is then placed in series with a capacitance. Compute the…

A:

Q: Consider the signal x(t) x(t) = sinc (a) Find the Fourier transform of x(t) (b) Determine the…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: Refer to Figure below. 20 2V 4 V 10 30 2 V 10 40 Write the mesh equations for the network Write the…

A: We need to write mesh equation for given circuit.

Q: Ql- Write a program to create a vector matrix A(10) from input. Stop when entered number equal (-2).

A: The program has been developed using MATLAB and the code is shown in the following section.

Q: Solve the following problems. Show your solutions (write legibly). Use 4 decimal places. Enclose all…

A:

Q: 7. Find the voltage across the capacitor as a function of time v(t) for t> 0 for the circuit in Fig.…

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.