5. IF you want to design 8: 1 MUX by using 2: 1 MUX only, how many 2:1 MUX you need - Your answer

Q: S.1.) The scalor electric potential V= x²y (2+3). (v) که in empty space is given E find and Pu?

A:

Q: What does you tell about-Q₁ +Q2 = ???? C₁ 0-Q₁+Q₂ 0 O (-Q₁+Q₂) is always very high to Given Voltage…

A: Given:

Q: Considering (103)₁ = (abcdefg)₂, design a synchronous sequence detector circuit that detects…

A: Given  (103)10 = (abcdefg)2⇒(103)10 = (1100111)2 To Design: A logic circuit for Sequence detector…

Q: Find the current through the resistor at t=0+, and at t=1.25s. The switch is closed at t=0 50V 2092…

A: The general expression of current in RL circuit is given as i(t)=VsR(1-e-t(L/R))vS=supply voltage

Q: (B): Obtain the transfer function V2(s)/V (s) of the electronic cct. shown in Fig.(3) 남해해 카 Vi(s)…

A:

Q: A 50 MVA, 11 KV three-phase alternator was subjected to a different types of faults. The fault…

A:

Q: 1. The area of the hysteresis loop of a 1200 cm³ ferromagnetic material is 0.9 cm² with Bmax=1.5 T.…

A: We have, 1T= Wb/m2 where, T= Tesla and Wb=Weber Area of  0.9cm2 will give the hysteresis loss per…

Q: * Y11 for the following circuit is I V₁ 5Ω 10 5Ω 0.572 I 2Ω V 10

A:

Q: Write Truth table for 2-digits down counter

A: Counter : A Counter is a device which record every high or low signal  by the use of clock…

Q: Q4. A 200KVA single phase transformer with a voltage ratio 6350/660 V has the following winding…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly…

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: Stateetypes of synchronous machine.

A: Synchronous machine works on the principle of magnetic locking. The synchronous machine rotates with…

Q: Plant A - 150kVA, 0.68pf lagging Plant B - 70kVA, 0.65pf lagging It is desired to correct the power…

A:

Q: The parameters that are mainly used in * electronics circuits are Z Parameters Y Parameters H…

A: About electronic circuit parameters

Q: Q5/ Given that E1 = 3ax - 5ay + 7az V/m at the charge - free dielectric interface of figure(2). Find…

A:

Q: One application of the diodes is to build a clipper circuit which is used to shape the signal…

A: The Given is creating a clipper circuit that can cut the input in both positive and negative half…

Q: The current passing through the resistor 40 when t<0 is* lov (+) O 1.5A 2A O 1A O 10A 42 www tzo 7-…

A: Given here a electrical circuit and asked to find the current though the 4 ohm resistor when t&lt;0…

Q: Which of the following power is useful power? O Apparent Power Reactive Power Average Power OActive…

A: In this question,  We need to choose the correct option in this question.  In this question, we are…

Q: Convert the logic diagram below to both NAND and NOR implementations.

A: By using NAND and NOR gates, all basic gates can be implemented. Due to that reason,  the NAND and…

Q: One of the applications of the mutual inductance is Wireless Charging of Electrical Vehicles O…

A: Application of mutual inductance is

Q: For the automobile ignition circuit shown, R=502, Vs=12V, L=7mH switch takes us to open. The voltage…

A:

Q: 1. Let us assume that two homogeneous, isotropic di electric mediums with dielectric constants=3 and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Write down the equation for 11 800 0° 200 M C I₁ j480 j360 -j138.89 150 Ix j720 C 1₂ 110 / 30⁰

A:

Q: 2 . Why is copper mainly used in electrical cables and electronic industries

A: Electric conductors used in cables and electronic industries  should have low resistivity. If…

Q: Which of these equations is correct (choose one only)? O V2= A*V2 - B*12 O V1= A*V1 - B*12 O V1=…

A:

Q: The Final value of the voltage of capacitor for t>O is t = 0 50V 1 O 25V O 20V O 30V O 50V +1 1 + 2…

A:

Q: By using Laplace Transform for circuits * analysis we O O O Replace capacitor with impedance SC in…

A: Laplace transform for the circuits having capacitor.

Q: A "for the JFET voltage divider biasing Configuration if Rs = Rs1 the Q-Point is (VGsa, IDQ), Now if…

A: A JFET is a three-terminal semiconductor device in which current is conducted by either electrons or…

Q: What is the energy required to build up current of 1A in an inductor of 20 mH?

A: We need to find out energy of given inductor for given current

Q: Calculate the total apparent power ST (in va) of the whole circuit (magnitude only). 5/M0PA 30…

A:

Q: In the parallel connection of the following two port network, which of the following is correct V₁…

A:

Q: Based on Figure Q2 above, show that the complex / exponential Fourier Series for this function may…

A:

Q: A copper conductor has a resistance of 15 ohms at 20 degrees celcius. Determine the resistance at 80…

A: A copper conductor has a resistance of 15 Ω at 20°C.here we have to determine the resistance at 80°C…

Q: If the magnitude of a transfer function is given to be 2000 in linear scale, |H| = 2000 , what would…

A: Given: Magnitude of transfer function on linear scale, H=2000

Q: An ideal transformer has a turns ratio of 8:1 and the primary current is 3A when supplied at 240v…

A: In this question,  We need to determine the secondary voltage and secondary current?  We know  In…

Q: Switch 1 HI Switch 2 Switch 3

A: No, current will not make it to the other side of the power supply..

Q: The node a equation is * V; (ω) (+1) 10 ΚΩ 20 ΚΩ a V.(ω) - H11 40 ΚΩ 5x106 jo + Vo (0)

A:

Q: Plant L: 100kVA, 0.68pf lagging Plant K: 60kVA, 0.65pf lagging It is desired to correct the power…

A:

Q: 1. Suppose you have multiple sinusoidal signal sources with four different frequencies where f₁-4,…

A: Matlab code for the message signal: clc;clear all;close all;t=0:…

Q: Are the following two logic circuits equivalent and write the final equation for the circuits:- * D…

A: Let input given to gate is A and B so the output for AND Gate =AB Let input given to gate is A and B…

Q: (b) X(jw) 2- نماز (-²-3.75 ju-1)(jw+0.625) Hand written plz only 'b' part

A:

Q: In a two port network, when 12=0, V2=4 V, 11= 3 A and V1 = 3 V. C is equal to O 1.333 Siemens O 0.75…

A: We need to find out value of C for given parameters

Q: 03: (a) For the bandpass filter shown in Fig. Q3, calculate foff ₂ Q and B. (b) in the input voltage…

A:

Q: For the Photoflash unit. Vse 9V R15KQ. C-1500 uf. R2 120. The average power dissipated by the lamp…

A: As per guidelines given to us, we can only provide the solution of one question in multiple type of…

Q: 2. Find the inverse Fourier transform of the following signals. (a) X(jw) = (1-j)8(w - 3) + (1+j)8(w…

A:

Q: Q1: For the Instrumentaion amplifier shown below, drive the equation of v, and i,. R₂ ww CHI A₁ A₂ R…

A: 1)  To derive the equation of output voltage and current for instrumentation amplifier

Q: The Final value of the voltage of capacitor for t>0 is t=0 50V 1 50V O 20V 30V O 25V + 19 2 20V R C…

A: Introduction:- Capacitor gets fully charged with dc source in steady state and act as open circuit.…

Q: Q4) Find the Y-parameters of the network shown below and then from the Y-parameters find h-…

A: y-parameter matrix: this matrix is also known as the admittance matrix. this matric can also be…

Q: A generator is supplying a load. An incremental change in load of 4 MW requires generation to be…

A:

Q: The contents of the designated register pair are decremented by 1 and the result is stored in the…

A:

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.