5. In the figure shown below, the height of the water and oil are 15 and 8 m respectively. The container is open to the atmosphere (a) What is the gauge pressure and absolute pressure at the oil water interface? (b) What is the gauge pressure and absolute pressure at the bottom of the container? The density of the oil is 750kg/m^3 OIL WATER shutterstock.com 1172374471

5. In the figure shown below, the height of the water and oil are 15 and 8 m respectively. The container is open to the atmosphere (a) What is the gauge pressure and absolute pressure at the oil water interface? (b) What is the gauge pressure and absolute pressure at the bottom of the container? The density of the oil is 750kg/m^3 OIL WATER shutterstock.com 1172374471

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In the figure given, fluid 2 is carbon tetrachloride and fluid 1 is benzene. If patm = 101.5 kPa, determine the absolute pressure at point A. fluid 1 A T 12 cm Patm fluid 2 35 cm ] LIVE 10 nexxt Reimagine Education. www.dlsl.edu.ph
As shown in the figure, an inclined manometer is used to measure the pressure of the gas within the reservoir. The manometer fluid is mercury, which has a density of 845 Ib/ft3. The manometer fluid rises a distance d = 12 inches along the manometer tube, which is inclined e = 20° from the horizontal. The atmospheric pressure is 14.7 Ibf/in? and the acceleration of gravity is 32.2 ft/s?. Patm = 14.7 Ibf/in.? Gas reservoir g = 32.2 ft/s? a 20 in. Mercury (p = 845 Ib/ft³) Determine the gas pressure, in Ibf/in?. Express the pressure as a gage or a vacuum pressure, as appropriate, in Ibf/in2.
In the figure, fluid 2 is carbon tetrachloride(1.589) and fluid 1 is benzene (SG = 0.877). If the atmospheric pressure is 101.5 kPa, determine the absolute pressure at point A. Patm fluid 1 35cm 12 cm fluid 2 Fig. 2-26 Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: kPa abs
For most gases at standard or near standard conditions, the relationshipamong pressure, density, and temperature is given by the perfect gasequation of state: p = ρRT, where R is the specific gas constant. For airat near standard conditions, R = 287 J/(kg · K) in the International System of Units and R = 1716 ft · lb/(slug · ◦R) in the English Engineering System of Units. Using the above information, consider the following two cases: a. At a given point on the wing of a Boeing 727, the pressure andtemperature of the air are 1.9 × 104 N/m2 and 203 K, respectively.Calculate the density at this point.b. At a point in the test section of a supersonic wind tunnel, the pressureand density of the air are 1058 lb/ft2 and 1.23 × 10−3 slug/ft3,respectively. Calculate the temperature at this point.
The pressure of the natural gas installation is as follows.As you can see, mercury (mercury), oil (oil) and water (water) fluidsIt is measured with a manometer. Open end of the manometer (X + 85)It is under the influence of kPa ambient pressure. The relative content of mercury and oil (relative to water)density (SG) and density of water (ρwater = 997 kg / m3) is known.Determine the absolute pressure in the installation (X=00)
The tank of an air compressor has a volume of 2m3 and is filled with air at a temperature of 40 degrees C. If agauge pressure on the tank reads 7.5 bars,what is themass of the air in the tank?
Sometimes manometer dimensions have a signifi canteffect. In Fig. containers ( a ) and ( b ) are cylindricaland conditions are such that p a = p b . Derive a formula forthe pressure difference p a - p b when the oil–water interfaceon the right rises a distance ∆ h< h , for ( a ) d << D and ( b ) d=0.15 D . What is the percentage change in the value of ∆ p ?
A cylinder contains a fluid at a gauge pressure of 350kPa. Express the pressure in terms of the column height of (a) water (p = 1000kg/m) (b) Hg (S = 13.6). What would be %3D absolute pressure in the cylinder if the atmospheric pressure is 101.3 kPa ?
For a liquid with the contact angle of 53.6 degrees and surface tension of 0.075 N/m, capillary rise is 2.50 m. What is the expected capillary rise in meters if the liquid is replaced with another with a contact angle of 12.7 degrees and a similar surface tension? (answer should be accurate to 2 decimal places) Answer:
A rigid container is closed at one end and measures 8 in. diameter by 12 in. long. The container is held vertically and slowly moved downward until the pressure in the container is 15.5 psia. What will be the depth of the water surface measure from the free water surface? ANswer: 22in Fluid Mechanics ( Please include units)
The sketch shows an oil manometer that is connected between two pipes which transport water. The density of water can be taken as 998kg/m3, the specific gravity of glycerol is 0.76 and atmospheric pressure is 100 kPa. The respective dimensions (as shown on the sketch) are given below: h1 = 0.17 m h2 = 350 mm h3 =15cm. From the given data, calculate the pressure difference between the two pipes.
Determine the pressure of Gas 2. Follow the figure and the statement below. (Fluid Mechanics). Answer: 106,64kPa