answer 5 needs solution/explanation. please type the solution if you can because i cannot see handwritten sometimes. i will upvote tyUse the following data when needed: ρwater=1000 kg/m^3 , g = 9.80 m/s2 and 1 atm = 1.013 × 105 Pa. 4. A cubical water tank has a volume of 10.0 m³. What is the pressure at the bottom when it is fully filled withwater? Assumed that the surface of the water tank is at atmospheric pressure.a) 1.99 x 105 Pab) 9.80 x 104 Pac) 3.30 x 103 Pad) 1.01 x 105 Pa 5. Refer to #4. What is the gauge pressure at the bottom of the tank?b) 9.80 x 104 Paa) 1.99 x 105 Pac) 3.30 x 103 Pad) 1.01 x 105 Pa

4) height of cube h = 10(1/3) = 2.15 m At bottom P = Patm + ρgh P = 1.013 × 105 Pa +…

Answered: 5. Refer to #4. What is the gauge…

5. Refer to #4. What is the gauge pressure at the bottom of the tank? b) 9.80 x 104 Pa a) 1.99 x 105 Pa c) 3.30 x 103 Pa d) 1.01 x 105 Pa

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter4: Physics Of Matter

Section: Chapter Questions

Problem 15P: . Find the gauge pressure at the bottom of a swimming pool that is 12 ft deep.

See similar textbooks

Related questions

Q: Set up an integral for fluid force against the vertical plate submerged in a fluid with weight…

Q: A hydraulic lift is used to jack a 960-kg car 41 cm off the floor. The diameter of the output piston…

A: Given data: The input force , F1=360 N The mass of the car m=960 kg The diameter of output piston…

Q: Problem: Determine the pressure in kPa at the following points: a) Point 1 b) Point 23 c) Point A…

Q: The water inside a pipe (cross-sectional-area = 0.080 m²) has a velocity of 4.0 m/s. What would be…

A: Cross-sectional Area 1: A1 = 0.080 m2. Speed of water at A1 = v1 = 4.0 m/s Cross-sectional Area 2:…

Q: a) For the vessel containing glycerin (density = 1260 kg/" ³) under pressure as shown, find the…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The dam is 500 m wide, and the water is 80.0 m deep at the dam. (a) What is the average pressure on…

Q: An open cylindrical tank with a diameter of 2 m. has Water (s.g. 1.00, h 2m), Oil (s.g. 0.82, 2.5m)…

Q: What is the pressure, P, in the closed-tube manometer below? Assume static equilibrium and that the…

A: Given: Density of water = ρ We need to find pressure P.

Q: 1. Find the pressure increase in the fluid of a syringe when a nurse applies a force of 42N to the…

A: The applied force,

Q: What is the pressure at a depth of 110 m in the ocean? The density of seawater is 1. 03 x 10 kg/m.…

Q: Mercury and then an unknown liquid are poured into a U-shaped tube, open at both ends, and do not…

Q: 5. Refer to #4. What is the gauge pressure at the bottom of the tank? b) 9.80 x 104 Pa а) 1.99 х 105…

A: gauge pressure Pg=P-Pa= (Pa+hdg)-Pa hdg is gauge pressure depth is h

Q: What outward force (in N) is needed on the outside of a lung to create the pressure P noted in the…

A: The applied pressure is, P=-5.55 mm Hg=-5.55×133.32 Pa=-739.926 Pa The affected area is, A=295…

Q: To determine the absolute pressure of a static (unmoving) fluid, we can apply the following concept.…

Q: A manometer with two closed ends contain some gases inside. The pressure inside the bulb A is PA =…

Q: (I) If the force F needed to move the wire in Fig. 10–34 is 3.4 x 10-3 N, calculate the surface…

Q: When the force P is applied to the plate shown in (Figure 1), the velocity profile for a Newtonian…

Q: Calculate the absolute pressure when a submarine is at a depth of 500 m in the ocean. Assumed that…

A: Given data: Acceleration due to gravity (g) =9.80 m/s2 1 atm = 1.013 × 105 Pa Depth (h) = 500 m…

Q: (b) What average pressure (in Pa) from his weight is exerted on the horizontal surface if his two…

A: Answer :- (b) Mass of a man(m) = 70.5 kg Acceleration due to gravity (g) = 9.8 m/s2 Area(A) = 4.45…

Q: A 3.2-N force is applied to the plunger of a hypodermicneedle. If the diameter of the plunger is 1.3…

A: Given Force on Plunger FP = 3.2 N Diameter of the plunger DP = 1.3 cm = 1.3 x 10-2 m Diameter of the…

Q: Scientist found evidence that mars may once have had an ocean that is 0.500 km deep. The…

A: The fluid pressure at depth h can be determined as, Here, ρ, g and h represent the density of the…

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

A: We need to calculate the force F2 and also the distance moved by the larger piston, d2.

Q: Commercial airplanes have pressurized cabins. If the pressure inside the cabin is 0.90 atm and the…

A: Given that, Pressure inside the cabin(Pi)= 0.9 atm Pressure outside the cabin(Po)= 0.15 atm Area of…

Q: Unreasonable Results - A fairly large garden hose has an internal radius of 0.600 cm and a length of…

A: r=Radius of pipe=0.6 cml=Length of pipe=23 mQ=Flow rate=50 L/sη=Viscosity of water=1.005×10−3…

Q: _2. The specific gravity of certain metal is 1.93. What is its density? b) 193 kg/m³ a) 19.3 kg/m³…

A: Specific gravity is the comparison between the density of an object to the density of water and the…

Q: QUESTION 2 Manometer as shown in Figure Q2 are attached to a gas tank to measure it pressure.…

Q: Which of the following is the correct comparison of the specific gravity of the fluids indicated in…

Q: Blaise Pascal duplicated Torricelli’s barometer using a red Bordeaux wine, of density 984 kg/m3, as…

A: Given, Density of mercury, Height of the mercury column, h1=0.76m Density of French wine, Height…

Q: 1. A 700 N lady wearing stilettos walks with one foot on the ground. Find the pressure exerted on…

Q: 1. Which of the following is NOT a unit of pressure? A.Atm C. Pascal B.N/m2 D.…

A: There are three different questions. According to guideline I solve only first one. Please post…

Q: Refer to the law of laminar flow, which states that v = -(R2 - r2). Consider a blood vessel with…

A: Given that: v=P4ηl(R2-r2)R=0.01 cml=5cmP=dyne/cm2η=0.026

Q: So I'm just making sure I had the work done correctly I know the unit has to be in kPa but I wasn't…

Q: A tank is 10 m long, 6 m wide, 3 m high, and contains kerosene with density 820 kg/m3 to a depth of…

Q: Q1: The water in a tank is pressurized by air, and the pressure is measured by a multi-fluid…

A: H1 = 0.2 m H2 = 0.3 m H3 = 0.46m ρmer = 13.6 g/cm3 = 13600 kg/m3 ρoil = 0.85 g/cm3 = 850 kg/m3 To…

Q: Scientist found evidence that mars may once have had an ocean that is 0.500 km deep. The…

A: Consider a fluid as shown below: The fluid pressure increases with the depth of the fluid. Point…

Q: The pressure exerted by a phonograph needle on a record is surprisingly large, due to the very small…

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

Q: Suppose a glass capillary tube has a 0.495-mm radius. Part (a) How high, in centimeters, will…

Q: QUESTION 7 Bernoulli's Principle states that where the velocity of the fluid is high, the is low.…

A: Bernoulli's Principle states that as the speed of a moving fluid increases, the pressure within the…

Q: A 72.5 kg man stands on a horizontal surface. HINT (a) What is the volume of the man's body (in m³)…

A: Mass of man, m=72.5kg Average density, d=989kg/m3 Feet area, A=4.65×10-2m2

Q: ater moves through a constricted pipe in steady, ideal flow with a velocity of 1.40 m/s at the…

A: at initial point speed = V1= 1.4 m/s radius = r1= 4 cm = 0.04 m pressure = P1= 150 x 103 pa at final…

Q: Question 3. As shown in the figure that the pipe section is placed on a horizontal plane. At flow of…

Q: A 60-kg person's two feet cover an area of A=146 cm2. Assume the person is at rest. If the person…

A: Given: The mass of person is m=60 kg. The area covered by feet is A=146 cm2. The gravitational…

Q: Equation 13.7 Archimedes’ principle FB = ρfVfg allows us to calculate the magnitude of the buoyant…

A: The buoyant force is given by the formula : FB = ρf Vf g

Question

answer 5

needs solution/explanation.

please type the solution if you can because i cannot see handwritten sometimes. i will upvote ty

Use the following data when needed: ρwater=1000 kg/m^3 , g = 9.80 m/s2 and 1 atm = 1.013 × 105 Pa.

4. A cubical water tank has a volume of 10.0 m³. What is the pressure at the bottom when it is fully filled with
water? Assumed that the surface of the water tank is at atmospheric pressure.
a) 1.99 x 105 Pa
b) 9.80 x 104 Pa
c) 3.30 x 103 Pa
d) 1.01 x 105 Pa

5. Refer to #4. What is the gauge pressure at the bottom of the tank?
b) 9.80 x 104 Pa
a) 1.99 x 105 Pa
c) 3.30 x 103 Pa
d) 1.01 x 105 Pa

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

How much pressure is transmitted in the hydraulic system considered in Example 11.6? Express your answer in pascals and in atmospheres.
What fraction of an iceberg floating in the ocean is above sea level? Assume the density of the iceberg is 917 kg/m3.
Calculate the average pressure exerted on the palm of a shot-putter's hand by the shot if the area of contact is 50.0 cm2 and he exerts a force of 800 N on it. Express the pressure in N/m2 and compare it with the 1.00106 Pa pressures sometimes encountered in the skeletal system.
What pressure is exerted on the bottom of a 0.500-m-wide by 0.900-m-long gas tank that can hold 50.0 kg of gasoline by the weight of the gasoline in it when it is full?
. Find the gauge pressure at the bottom of a swimming pool that is 12 ft deep.
A container is filled to a depth of 20.0 cm with water. On top of the water floats a 30.0-cm-thick layer of oil with specific gravity 0.700. What is the absolute pressure at the bottom of the container?
What is the gauge pressure in millimeters of mercury inside a soap bubble 0.100 m in diameter?
What effect does capillary action have on the reading of a manometer with uniform diameter? Explain your answer.
Suppose the master cylinder in a hydraulic system is at a greater height than the slave cylinder. Explain how this will affect the force produced at the slave cylinder.
Gauge pressure in the fluid surrounding an infant's brain may rise as high as 85.0 mm Hg (5 to 12 mm Hg is normal), creating an outward force large enough to make the skull grow abnormally large. (a) Calculate this outward force in newtons on each side of an infant's skull if the effective area of each side is 70.0 cm2. (b) What is the net force acting on the skull?
A small statue is recovered in an archaeological dig. Its weight is measured to be 96 lb, and its volume 0.08 ft3. (a) What is the statue's weight density? (b) What substance is it?
What force must be exerted on the master cylinder of a hydraulic lift to support the weight of a 2000-kg car (a large car) resting on the slave cylinder? The master cylinder has a 2.00-cm diameter and the slave has a 24.0-cm diameter.