5. Transmission of a radar screen's data requires transmission of data from 500000 pixels. Each pixel is binary: the probability of a 0 is 99%, and the probability of a 1 is 1%. There are 2 screens per second. (a) What is the information rate (hint: entropy) in bits per second? (b) Assuming that this is transmitted over a Gaussian channel with bandwidth 10kHz, what is the requisite SNR at the receiver?

5. Transmission of a radar screen's data requires transmission of data from 500000 pixels. Each pixel is binary: the probability of a 0 is 99%, and the probability of a 1 is 1%. There are 2 screens per second. (a) What is the information rate (hint: entropy) in bits per second? (b) Assuming that this is transmitted over a Gaussian channel with bandwidth 10kHz, what is the requisite SNR at the receiver?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Suppose the spectrum of the channel is between 5 MHz and 6 MHz. If the signal to noise ratio is found to be 24dB, Find the maximum channel capacity. Also find the maximum number of signal levels in the transmitted signal?
1- 2- 3- 4- 5- s, True or False, and correct the error if there is. The solid-state relay depends on the electric field to control the output moving parts. At the solar cells, the long wavelengths generate electron-hole pairs at near the surface. The IMPATT is a noisy system because it depends on the avalanche break down. The BARITT diode depends on thermionic emission rather than avalanche multiplication. For IMPATT and BARITT microwave devices, the frequency generation is inversely proportional to the drift region length. 6- The Gun diode depends on the avalanche break down.
B- Give a brief answer for the following questions 1. A temperature measurement within a range of (-20° to 20° ) with accuracy of 0.25° the readings are taken every (0.5 Sec), then converted to binary PCM. What is the bit rate required? 2. Five signals have the same BW = 10 KHz to be FDMed. What is the FDM bandwidth? 3. Why does a broadcast radio station need only one transmitter, but mobile telephony requires many?
A data stream of 500 Mbps is to be transmitted through a wireless channel using 32-PSK technique. Find the minimum bandwidth requirement of wireless channel. A 15.625 MHz B 50 MHz C D 200 MHz 100 MHz
q1 The System y(n)= 5 x(n^2) ans Time Variant Time Invariant ================= q2 Even signals are symmetric about the vertical axis? ans True False ========================= q3 When x(t ) is said to be non periodic signal? If the equation x (t) = x (t + T) is satisfied for all values of T If the equation x (t) = x (t + T) is satisfied for only one value of T If the equation x (t) = x (t + T) is satisfied for no values of T If the equation x (t) = x (t + T) is satisfied for only odd values of T
A low-pass channel with a maximum frequency of f, Hz is to be used in a communication system. Assume that the wave length for fn is 100 meters and the signal-to- noise ration (SNR) is 127 dB. (Assume speed of light to be 3x10° m/sec) a. The bandwidth of the channel is Hz b. The theoretical highest data rate for the channel is bps. c. based on the data rate in part (b), the minimum number of signal levels that can be used to represent data will be levels
I want to design a superheterodyne receiver with an IF frequency of 10MHZ to receive a frequency band of 20MHZ to 40MHZ. (a)Find the frequency range of the receiver local oscillator (b)Find the video frequency when the carrier frequency is 40 MHz (c)Briefly describe how the video channel of the video frequency mentioned in (b) can be reduced or eliminated.
Please help me with my homework. Thanks! The course subject is Fundamentals of Electronic Communications. 2. A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 KHz audio signal having an amplitude of 20 V. Determine the modulation index, % modulation, fusb, flsb, AM equation.
An FSK system transmits binary data at the rate of 2.5x106 bits per second. During the course of transmission, white Gaussian noise of zero mean and psd of 10-20 w/Hz is added to the signal.. In the absence of noise, the amplitude of the received signal is 1 µV across 50-ohm impedance. Determine the average probability of error assuming coherent detection of the binary F5K signal. [Hint: Energy per bit is given by Eb = Ac² T/2R, where Ac is the signal amplitude, T is the bit duration and R is the impedance of the load.] Given: erfc(x) = for large x, e-x2 (πχ
For a transmission medium, SNRdb is given as 30. The given capacity of 600 Kbps is valid for which bandwith and amount of signal level? a. Signal level = 49 Bandwith = 70 KHz O b. Signal level = 4 Bandwith = 80 KHz O c. Signal level = 4 Bandwith = 40 KHz d. Signal level = 25 Bandwith = 60 KHz %3D e. Signal level = 49 Bandwith = 120 KHz %3D %3D
To put it another way: A BTS broadcasting information with 10 W of output power at 1800 MHz can only cover half the area as a BTS transmitting at 900 MHz. Describe the benefits and drawbacks of using the 1800 MHz BTS to cover the same area as the 900 MHz BTS.
A Stereo (i.e., two channels) audio signal with each channel having a bandwidth of 20 kHz needs to be sampled at a rate equal to 1.1 their Nyquest rate, and then quantized using 16 bits for transmission of a channel. Determine the following: Minimum data rate (in bits/s) that the transmitter must have to be able to transmit this stereo audio signal. Amount of data (in bits) that will be generated from this signal over a duration of 1 hour and 8 minutes (Note: this is approximately the capacity of a standard Audio CD).