*5.11 An infinitely long wire carrying a 25 A current in the positive x direction is placed along the x axis in the vicinity of a 20-turn circular loop located in the x-y plane (Fig. P5.11). If the magnetic field at the center of the loop is zero, what is the direction and magnitude of the current flowing in the loop? d = 2 m 1 m X 1₁ Figure P5.11 Circular loop next to a linear current (Problem 5.11).

*5.11 An infinitely long wire carrying a 25 A current in the positive x direction is placed along the x axis in the vicinity of a 20-turn circular loop located in the x-y plane (Fig. P5.11). If the magnetic field at the center of the loop is zero, what is the direction and magnitude of the current flowing in the loop? d = 2 m 1 m X 1₁ Figure P5.11 Circular loop next to a linear current (Problem 5.11).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Three long, parallel, straight wires each carrying a 5.0 A current pass through the vertices of an equilateral triangle (L= 5.0 cm) as shown in the figure below. Currents on wires B and C are out of page while that of wire A is into the page. What is the x and y components of the magnetic field vector at the point of the wire A? Give your answer in µT. B Her birinden 5,0 A akım geçen üç uzun ve birbirine paralel düz tel bir kenarı L=5,0 cm olan bir eşkenar üçgenin köşelerinden geçmektedirler. B ve C tellerinden geçen akım sayfa düzleminden bize doğru, A telinden geçen akım sayfa düzleminden içeri doğrudur. A telinin üstünde manyetik alanın x ve y bileşenleri µT cinsinden nedir? L
10 Given a common magnetic core whose length is 100 cm, its cross-sectional area is 25 cm square. The relative permeability of the core material is 5000. Two coils are tightly wound on the core. N1 =1000 turns and N2 = 500 turns. The self-inductance of coil N1 will be: [ 7.85 m H 15.7 m H 3.927 m H 5.17 mH
3. An aluminum ring of 5.00 cm radius and a 3.00x10 'Q resistor are placed on top of a solenoid coil of 1000 turns per meter and 3.00 cm radius as shown above the area of the section. the end of the solenoid The magnetic field generated by the solenoid coil at the core is 0.500 T and the magnetic field outside the solenoid coil is not charged. If the current in the solenoid coil Noid increases with a rate of 270 A/s. Find a) Inductive current in the ring b) the magnitude and direction of the magnetic field created by the inductive current in the ring. Answer is [1.60 A; 20.1 µT, upward]
1. Inductance. Consider the configuration of a wire with 90° bends as shown below. A small loop, with its sides of length a and width d = a/16 is placed with its plane lying along xz principal plane as shown. Stating all assumptions, determine mutual inductance between the loop and the wire. a/2 9/2 2a
PLEASE ANSWER IT ASAP FOR AN UPVOTE. THANK YOU. Round off your answer into four decimal places .Box your final answer .Use SI unit. A magnetic circuit consist of silicon having a cross section of 1.5 sq. m and 0.1 m length and an air gap of the same cross section and pf 0.02 m length. what is the field intensity at the air gap if 0.5 A current flows through the 5000-turns coil? Assume the permeability of silicon steel is 3000.
The sides measure 10.0cm in length each, what is the magnitude of the electric feild in the center of the square? Hint... The answer will be 3.?? x 10^-5 N/C
1: During an experiment based on magnetic force, you can take 60 turn rectangular coil with length 20.0cm and height 30.0 cm. The coil is hinged along the Y-axis and 1.27 A current is passing through coil suchthat its plane makes an angle 40o with magnetic field. How can you find the magnitude and direction ofthe rotational force on coil by a uniform magnetic field 5000 G directed in the positive X-direction?What are possible ways to rotate coil in opposite direction?
For the circuit shown in Figure:a. Determine the reluctance values and show themagnetic circuit, assuming that μ = 3,000μ0.b. Determine the inductance of the device.c. The inductance of the device can be modified bycutting an air gap in the magnetic structure. If a gapof 0.1 mm is cut in the arm of length l3, what is thenew value of inductance?d. As the gap is increased in size (length), what is thelimiting value of inductance? Neglect leakage fluxand fringing effects.
A wire is bent in the following shape and carries a current of 10 A in the direction shown. Find the components and the magnitude of the magnetic field at point “P". 1 m 0.5 m 0.5 m 1 m 1 m
The parallel-plate capacitor shown to the right is discharging so that the electric field between the plates decreases. Answer the questions below and explain your reasoning. The bulk of the credit will come from your explanation. What is the direction of the magnetic field at point P?
A straight wire carrying a 2.88-A current is placed in a uniform magnetic field of magnitude 0.274 T directed perpendicular to the wire. Find the magnitude of the magnetic force on a section of the wire having a length of 13.9 cm. N
Q5. Consider two magnetic fields given by (a)B = 3x²y – 4xz + 5z2 and (b) B =constant. Comment on these magnetic fields.