5.5 V 6.0 Ω Μ M 8.5 Ω 12 V 13 Ω

Q: a) For the Circuit shown calculate the value of C if the resonant frequency. is 5000 vad /sec

A:

Q: the total charge entering a terminal is q =(10-10 e^-2l)mc. find the current at t = 0.5 s

A: Given: q=10-10e-2 mC

Q: To prevent mal-operation of differentially connected relay while energising a transformer, the relay…

A: To prevent mal-operation of differentially connected relay while energising a transformer, the relay…

Q: (2). Current is defined as the rate of charge flow. If a charge of 0.00651 colombs passes a given…

A:

Q: Q18/ Consider the CT signals shown in figure below. Calculate the power and then classify this…

A: In this question, we need to find whether given signal is energy signal or power signal. Also we…

Q: The conductor configuration of a bundled single phase overhead transmission line is shown in Fig. 2.…

A: GMR:- Geometric mean radius (GMR) is used to calculate distance between transmission line for…

Q: 5. The ODE d²y dy dx² dx + - 2y = 0 has a general solution y(x) = C₁еx + С₂e−2x Determine the…

A:

Q: To implement the Boolean function F(Z,Y,X)=>m(0,1,2,4,6,7) using a multiplexer as shown in the…

A:

Q: Calculate the skin depth (in microns) for bronze ( = frequency f= 100 MHz $) a S.) m 107 S at a

A: Given data, For bronze Conductivity, σ=107 S/m Frequency, f=100 MHz

Q: 24V 318-4 Sensor K2 08 05-8 21 If you're only allowed to pick one, from which column would you…

A: Ans :( B) coulomn 2 Since two sensors are connected in series without any coordination... Which…

Q: Assuming odd parity, find the parity bit for each of the following data units. a. 1110111 b. 0001101…

A: Given data : a. 1110111b. 0001101c. 1000000

Q: Determine I in a circuit shown in figure 2.

A: this problem can be solved by using nodal analysis. In the nodal analysis we use KCL and ohm's law…

Q: a) For the Current Locus shown Draw the equivalent electric circuit? Find the value of each element…

A:

Q: • Construct 4-to-16 line decoder with 3-40-8 a line decoders with enable and external gates.

A: We need to design the given decoder.

Q: Q1/ For the circuit of Fig. (1) a. Determine V2 using Kirchhoff's voltage law. b. Determine I. c.…

A:

Q: i need the answer quickly

A:

Q: Q-2. B. A 2 MVA, 3-phase, 8-pole alternator runs at 750 r.p.m and operates in parallel with other…

A:

Q: 12 Sensor 2 Sensor 0 17 Sensor OX 05-1 you're only allowed to pick one, from which column would you…

A: Q.9) ans(B) (2) To ensure for better protection column 2 must be removed

Q: 1. A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is…

A:

Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the ?second clock…

A: We need to find out the output state of ring counter

Q: Consider the circuit shown below. 1) Determine the coupling coefficient 2) Calculate the energy…

A:

Q: Q-2. A. A lighting load of 2000 kW and a motor load of 4000 kW at a p.f. 0.8 lagging are supplied by…

A:

Q: Determine the phasor currents I, and I2 in the circuit of Fig 1.B.

A:

Q: Q.5: Correct any five sentences using suitable scientific phrases. 1 UNGE IN TE 2. 3. The…

A: Three-phase power can be measured by One wattmeter method two wattmeter method Three wattmeter…

Q: Q31 27, and draw the impedance diagram. I, VVV in the phaser domain, and draw the phaser diagram.…

A: Series combination of impedances: Z=Z1+Z2+Z3

Q: Q.3) The input voltage to a Full-wave rectifier employing a center - tapped step-down transformer…

A: Given data : Supply voltage Vp=220V Turn ratio n=0.125 Load resistance RL=100Ω

Q: Q-2. B. A 2 MVA, 3-phase, 8-pole alternator runs at 750 r.p.m and operates in parallel with other…

A:

Q: E5.18 A system is shown in Figure E5.18(a). The response to a unit step, when K=1, is shown in…

A: The given system is shown below:  The transfer function of the above system is,…

Q: تتكون المجموعة من ثلاثة مقاومات (10 و 15 و 50) كيلو أوم على التوالي ، إذا كانت هذه المقاومات لقطة…

A:

Q: Find the closed-loop transfer function, T(s) = C(s)/R(s) for the system shown in figure below, using…

A:

Q: Q.5: Correct any five sentences using suitable scientific phrases. 1. At any resonant circuit the…

A: Z parameterV1=Z11 I1 + Z12 I2V2=Z21I1+Z22 I2Y parameterI1=Y11 V1 + Y12 V2I2=Y21V1+Y22 V2

Q: a) For the Circuit shown calculate the value of C if the resonant frequency is 5000 vad /sec 5 0-6…

A: a) To find the value of C if the resonant frequency is w = 5000 rad /sec

Q: QUESTION 5 An electron and a mystery charge 5.3 x 10^-11 m apart attracts each other with a force of…

A: Given: Electron charge, q1=1.6×10-19 C Unknown charge, q2=? Force between charges, F=2.61×1012 N…

Q: Q3. Choose the correct answer from the multiple-choice list for each question. 1. The output voltage…

A:

Q: * If X= (1100101)excess-3 X=(101)octal O X=(65)decimal O X=(110000)gray O X=(1000001)binay O none of…

A: The coding techniques in the digital systems are listed as follows to represent a decimal number:…

Q: Simplified form of the boolean expression (X + Y+XY) (X + Z) is Select one: A. xz + y B. xy + yz

A: Given Boolean expression, F=X+Y+XYX+Z

Q: A decoder with 4-bit input signal has outputs 4 O 16 O 1 O none of the mentioned O 2 O

A: We need to select correct option for decoder .

Q: A transformer has 1200 primary turns and 200 secondary turns. The primary and secondary resistances…

A: It is given that: N1=1200N2=200R1=0.2ohmR2=0.02ohmX1=1.20hmX2=0.05ohm

Q: We need a three-stage time-space-time switch with N = 100. We use 10 TSIs at the first and third…

A: Given a three-stage time-space-time switch with, N =100 No of TSIs at the first stage= 10 No of TSIs…

Q: What are the drawbacks of slope detector? 8. How FM wave can be converted into PM wave?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: For the system in figure below if the input signal is unit-step, find (a) the output (b) the time…

A:

Q: by Draw the block diagram of the phase locked loop detector that can be used to detect FM signal and…

A: The working of a PLL is alike to some other feedback approach where the feedback signal favor to…

Q: Full adder circuit using Design a and external gates. a decoder

A: In this questions, we need to design full adder using decoder.

Q: Design the fixed bias circuit from the load line given in the figure below. Ic sat. =10mA IB=60UA…

A: We need to find out the value of Rc and RB for fixed bias circuit .

Q: (1) Percentage voltage regulation at 0.8 lagging power factor. (2)Load angle at unity power factor.…

A: The synchronous generator converts mechanical energy into electrical energy. The induced emf is…

Q: A fluid system has two sensors, a pressure sensor and a flow sensor. The pressure sensor has two…

A: Since it is asked to solve only subparts (3-c) and (3-d),so we are solving those two subparts only.…

Q: Q2/Solve the following sequence X(n)= n. "u(-n) by using the differentiation property of the…

A:

Q: a) Determine the power dissipated in the circut shown M if the applied voltage V2 5mH mm -= 10 + 15…

A: Power dissipation means the energy loss and waste in the form of heat this process mostly occur in…

Q: Determine the y parameters for the two-port shown in Fig. 19.17.

A: It is given that:

Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the second clock…

A: We need to select correct option for given counter

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.