5m Determine The Force In Members CD And DF Of The Truss Shown. 3m 10 KN 3m 10 KN 3 m 10 KN Н 3m 10 KN SHOW COMPLETE SOLUTION AND DIAGRAMS. ORIGINAL WORK PLEASE I WILL UPVOTE

Q: 2.3 The floor system of a gymnasium consists of a 130-mm-thick concrete slab resting on four steel…

A:

Q: Q-A steel cantilever beam is proposed to build into a concrete wall at one end, and the other end is…

A: Given data: Dead load, D.L.=20 kNm Live load, L.L.=10 kNm The length of beam, l = 5 m Yield strength…

Q: Activity A B C D EFGI H 1 J K L M N Preceding Activity Draw a network for this project. None A A B D…

A: In project management, scheduling of activates is done prior to execution of the work. The…

Q: Problem- For design of a roof truss, if the design wind velocity is 20 m/s, what is the design wind…

A: Given- Design wind velocity V=20 m/s, Design wind pressure=?

Q: 1. Traverse lines MN, NO, OP, are centerlines of a portion of a proposed highway. Respectively, the…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: conclusion on chemical properties of rock-forming minerals.

A: Geology gives information on the location of sites utilised to create structures, dams, tunnels,…

Q: 3. Calculate the volume of rapid mixing tank with a flow rate of 6cfs, a mixing time of 11s, a mean…

A:

Q: Determine the magnitude of the couple C of the pulley shown if the resultan acts through the hinge…

A: T=600N to find couple about point C

Q: For undivided, multilane highways and highways with a two-way-left-turn-lane (TWLTL), no left-side…

A: Answer  We know that For multilane highways lateral clearance adjustment is based on the total…

Q: A very long, 10.0-ft-wide, concrete rectangular channel with a slope of 0.001 ends with a free…

A: A concrete rectangular channel, with uniform flow Slope, S = 0.001 Width, B = 10.0 ft As per the…

Q: A Raymond model 5/0 single-acting hammer is used to drive a pile. The stroke of this hammer is 39…

A:

Q: Are household density high or low in Detroit Michigan?

A: This question is related to the Building design and Construction from Civil Engineering.

Q: A plank L m long is placed in a horizontal position with its ends resting on two inclined planes…

A:

Q: QUESTION 1 From the given truss below, determine the forces for the members IK, IJ, and HJ. And also…

A:

Q: Use either the Virtual Work Method or the Method of Consistent Deformation. Please state what you…

A: Given Data E = 200 GPA  I = 2 × 109 mm4  Note: As per our guidelines we are supposed to answer only…

Q: 2. For the pipe flow-reducing section shown below, D₁ = 8 cm, D₂ = 5 cm, and p2 is at atmospheric…

A:

Q: Determine the reactions at the supports for the beam shown in Fig. 400 kN - m 15 kN/m 6 m Ţ -4 m 160…

A:

Q: Sand is placed on a rock slope, as shown in Figure Q2. (a) Show that sand will be stable (i.e., no…

A:

Q: 1.5 m 1 m 2 m B 5 kN -4 m C P₁ -5 m D VP2 -4 m E

A:

Q: 11.9 A consolidated drained triaxial test was conducted for a normally consoli- dated clay. Its…

A:

Q: Calculate the min. External dia of shaft.

A: Power transmitted by hollow shaft at 1200 pm = 450 Kw Allowable shearing stress in the shaft = 60…

Q: 3. In laying out a simple curve using deflection angle method, given are: D = 10.50 (deg), I = 55…

A:

Q: SITUATION 5: The 24-lb homogeneous square plate (i.e. same material & thickness) shown is supported…

A: Given: Weight of square plateW=24 lb Side of square plate=30 in a=10 in To find: Tension in the…

Q: Compute for the given closed traverse the following: a. Bearing of each line b. Latitude and…

A: As per our company guidelines, we are supposed to answer only the first 3 subparts. Kindly repost…

Q: QUESTION 1 From the given truss below, determine the forces for the members IK, IJ, and HJ. And also…

A:

Q: SITUATION 4: Boom ADB is connected at pin A and supports two forces F1 and F2, applied at D and B,…

A: Given Data  F2 = F1  Maximum tension in cable (T) = 1500 N  Find magnitude of F1 and F2 as well as…

Q: A sand with G, = 2.66 and e = 0.60 is completely dry. It then becomes wetted by a rising groundwater…

A: In dry condition The specific gravity of soil, G = 2.66 Void ratio of sand, e = 0.6 When the…

Q: Q- If a retaining wall 5m high is restrained from yielding, what is the at-rest earth pressure per…

A: Given data: A retaining wall has a height, H=5 m The backfill is cohesionless soil having, ϕ=30°γ=18…

Q: In the figure below, at section n-n (x = 4m from point A) determine shearing stress at a on the…

A:

Q: Q- An unlined canal under regime conditions along with a silt factor of 1 has a width of flow 71.25…

A: Given Data  Silt factor (f) = 1  Width of flow (B) = 71.25 m  Assume unlined wide channel  Find…

Q: There is a big old pipe that runs from Lake Whatcom that was used to supply water to the now defunct…

A: Given- Elevation of the pond H = 100 m, Elevation of Whatcom lake h=20 m, Discharge Q=3 m3/s,…

Q: Using the aluminum alloy 2014-T6, determine the smallest diameter rod which can be used to support…

A: Objective: To determine the smallest diameter for the rod needed to support the given concentric…

Q: Determine the force in member CF, FG, and Gc of the trusses

A:

Q: PLEASE

A:

Q: Water flows in a trapezoidal channel with a bottom width of 2.5m and side slopes of 1 vertical to 2…

A: Given data : Bottom width = 2.5 m Side slope = 1 vertical to 2 horizontal Q = 3 m3/s  Slope = 0.0004…

Q: What are The importance of clean code in personal projects?

A: This question is related to the Design and Drawing of Building and Building construction from Civil…

Q: Q1: A lake had a water surface elevation of 103.7 m above datum at the beginning of a certain month.…

A: Given- Water surface elevation of lake =103.7m In a month- Average inflow= 6 m3/sec Average outflow=…

Q: A boom consists of a 4-in.-diameter steel pipe AB and a cable as shown. The modulus of steel E = 29…

A:

Q: Using the Muller-Breslau principle, draw the influence lines for the following: a) The vertical…

A:

Q: Determine the maximum uniform loading w, measured in lb/ft, that the cable can support if it can…

A: .

Q: A survey is performed on a closed traverse as shown in the figure below. The course of the traverse…

A: Given: A closed traverse ABCDEFA as shown in the figure. Where, ∠A=70° 33' 20''∠B=127° 37'…

Q: Draw the Shear and Moment Diagram. 59 kN/m 95 KN 1m 105 KN 10m 59 KN 95 kN/m 1m

A: Given loading diagram:

Q: Determine the force in member BE if the force on E is changed to 525kN. 17 kN | 24kN Answer: -1.5 m-…

A: Solution:- Given data:- Force in E  = 525 kN   To find:- The force in member BE

Q: Problem A reservoir of carbon tetrachloride (CCL) has a mass of 475kg and a volume of 0.285 m². Find…

A: Mass of tetrachloride = 475 kg Volume occupied =0.285 m3

Q: What are three (3) major global environmental concerns facing today's environment. What sort of…

A: Solution:- Given data:- It is asked to what are three major global environmental concerns facing…

Q: Solve

A:

Q: a) Readings (m) 1.125 0.810 0.665 1.905 0.700 1.250 1.285 1.555 -1.400 1.235 Remarks BMI R.L. =…

A:

Q: Probiem 1.1. A rod 150 cm long and of diameter 2.0 cm is subjected to an axial pull of 20 kN. If the…

A: Given : Length of rod = 150 cm  diameter 2.0 cm  Axial pull = 20 kN Modulus of elasticity of…

Q: of concrete is 35 MPa. Compute the maximum P that can be carried by the structures. Pmax= a) b)…

A:

Q: Draw the shear, bending moment, and axial force diagrams for the frame shown. 25 k 20 ft B 1.2 k/ft…

A: