6. An eight-pole wound rotor induction motor op- erating on 60 Hz supply is driven at 1800 r.p.m. by a prime mover in the opposite direction of revolving magnetic field. The frequency of rotor current is (a) 60 Hz (c) 180 Hz (b) 120 Hz (d) none of the above.

Q: Can tutor write the explanation more clearly as I don't understand the hand writting

A: A flip flop change it's output at active edge of clock.  Preset is used to set the output of flip…

Q: Example 3: Obtain the power angle relationship and the generator internal emf for (i) classical…

A: Assuming that the generator's rated power  is 100 MVA, frequency is 60 Hz, and Xd =Xq =1.0Pu, the…

Q: Determine vo for the network shown below. 16 0 16 R www+ A 4V 0+

A: Diode.

Q: Give the transfer function of this circuit.

A: The amplifier circuit is given as We need to find the transfer function of the given circuit.

Q: terminals

A: Synchronous motor terminal voltage (line)=400 v ( star connected) 20HP power Full load efficiency…

Q: TJE ww RD Rs UDD = 1,8V Vout (a) Find the Voltage gain: 5 bias current: IMA Mnlox= 100MA/v² UTH =…

A:

Q: A continuous-time signal, x(t), has a Fourier transform denoted by X (w), and is expressed as: a)…

A: In this question we need to find the following value of integral I show in above question.

Q: In this Zener diode regulator, the source voltage varies from 6 V to 11 V. Assume that the load…

A: Given data Source/input voltage range, Vin=6 to 11 V Load current range, IL=1 to 38 mA Zener diode…

Q: Design Simpinial logic circuit for the expression + ABCD + ABCD, using rangl gate only X = ABCD)

A:

Q: (a) Find the electric field on the z axis produced by an annular() ring of uniform surface charge…

A:

Q: A capacitor is charged by connecting it to a 12 V battery with internal resistance 22. If the time…

A: given here the time constant and resistance and asked to find the capacitance.

Q: :Consider the sinusoidal current i(t) = 25 cos (400t+60˚) A ?What is the phase angle in radians Trad…

A: Given data, Current is given as, it=25cos400πt+600 A.

Q: se the SUPERPOSITION theorem to find the current going through the 6 ohm resistor  Please show all…

A: here we have to find the current through the 6 ohms resistor using the superposition theorem.

Q: A source impedance vs(t) = Vcos100πt has an internal of (4+j3) N .If a purely resistive load to this…

A: Given - Source Voltage, vs(t)=Vcos100πt. Internal impedance, Zs=(4+j3) Ω.,   To find- Value of…

Q: A 480 delta to 120/208 wye transformer, without taps, is connected to a 510-volt supply circuit. The…

A: here we have to find the line to neutral voltage on the secondary side.

Q: A 10-hp, 230-V shunt motor takes 43 A when operating at full-load speed of 1800 rpm. The resistance…

A:

Q: -/sketch the root locus for the TF below. G(s)H(s) - K (S+9) S (5² +45+11) o/L

A: Given: An open loop transfer function,  G(s)H(s)=K(s+9)ss2+4s+11, To do: We have to sketch the root…

Q: What will be the boolean function (y) for the given CMOS logic circuit as shown in the figure? AMP,…

A:

Q: A source impedance Vs(t) = Vcos100πt has an internal of (4+j3) .If a purely resistive load to this…

A: Given - Source Voltage vs(t) = Vcos100πt, Internal impedance Zs=(4+j3)Ω,   To find- Value of purely…

Q: 5- Under de conditions, find the voltage across the capacitors and the current through the inductors…

A:

Q: A single-phase full-wave uncontrolled bridge rectifier is supplying a highly inductive load (L/R…

A:

Q: A carrier signal ve(t) = E cos(wet) is modulated by a single tone signal Um(t) = Em cos(wmt) to form…

A: Given Data: An Amplitude Modulation system with, Carrier signal vct=Eccosωct Modulating signal…

Q: Complete the following expressions so that they are true. The function of a filter is to pass…

A:

Q: If a particular parabolic reflector has a gain of 30dBi, what is its new gain with respect to the…

A: The old gain of a parabolic reflector is Gold=30 dBi. We need to determine the new gain of the…

Q: A continuous-time signal, x(t), has a Fourier transform denoted by X (w), and is expressed as: a)…

A:

Q: R₁ ww in b BIb w Ro C= Vout M R₁

A:

Q: Use your personal key number N to find the values to use in solving. Show your work and explain your…

A:

Q: Question 3: Write the state transition table and draw the state machine figure of the sequential…

A:

Q: Q1:-Design and connect astable 555 IC circuit and explain the output plot and VC.

A: The above question is based on the working of a 555 timer as an astable multivibrator.

Q: H.W.3: obtain the y parameters for the T network shown in Fig. Answer: Y₁ = 75.77 mS, Y12 Y21= -30.3…

A: here we have to find Y-parameters to the given network.

Q: Given the following control system block diagram: R(s) 9 s+1 (b) K 1 S Y(s) Find the closed-loop…

A:

Q: 2. Calculate (i) the open circuit voltage gain and (ii) the voltage gain with RL included in the…

A:

Q: in phase. Determine the fault current, the bus voltages during fault, and the line currents during…

A:

Q: how to build this circuit on a breadboard? Please show it with images.

A: Need to design the given IC555-based circuit in the breadboard based on the circuit connection.

Q: Example: (₂³ (1unit) Given xEU = (a) Find the fundamental frequency (b) Find all F.S. Coefficients…

A:

Q: Consider a tank circuit consisting of a 15 µF capacitor and a 15 mH inductor connected in series. At…

A:

Q: Consider the second-order circuit shown below. Given the values of the circuit parameters (shown in…

A: The above question is based on the differential equation of a parallel RLC circuit. To simplify the…

Q: B4. a) Determine if the transistor in Figure B4a is working in the saturated, active or cut off…

A: For the given BJT circuit the region of operation needs to be identified based on the given values…

Q: Vs 0.2 VP-P BDC = 80 Bac=75 Iin Vin Rs = 250 £2 RB = 4 ks M Rc = 3 kn M + Vcc +30 V R₁ = 6 k Lout…

A:

Q: d) The signal (t) is now sampled at a rate of ws. (i) (ii) If we wn, plot the resulting spectrum of…

A:

Q: #1 + P? Vi Ri - Iz d} I Load PL V₂ For The above cricuit, the zenev Voltage is V₂ = 10v mnd the…

A: The above question is based on the Zener diode as a voltage regulator. Here, the voltage is in V,…

Q: An iron cored choke coil has an equivalent resistance of 4 . It draws 10A from a single phase ac…

A:

Q: The transfer function of a second order control system is Y(S) C(s) Suppose that the input signal is…

A: NOTE : As per our guidelines we are supposed to answer first three sub-parts only. Kindly re-post…

Q: Use the node-voltage method to find V1 and V2 in the circuit if V = 147 V, i = 3.1 A w 80 0 ₁100 ₂ i…

A:

Q: VIO R₁ 2₁ R₂ -Vcc 2₂ +Vcc +Vcc 23 R3 R₁ 24 RL VO Suppose Vcc=10V, the transistors are matched with…

A:

Q: 10. Determine the minimum bending radius for Type AC cable with an external diameter of 0.80".

A:

Q: Workspace From your observation of the measurement results in Table 5.0, was the operation of a…

A: The potentiometer placement in the bread board is The values of measurement of potentiometer are…

Q: In the circuit below;R1=22kQ, R2=22 k2, R3=2.5 kQ, R4=200Q, Rg=150Qgm=80, ra=50k2, are given.…

A:

Q: 1+ K 0 s(s+1)(s+2) Draw the asymptote of the root curves. Solve it by explaining step by step.

A: given characteristic equation is                      1 + Ks(s+1)(s+2) = 0 to find the asymptotes of…

Q: 3. Consider an angle modulated signal x(t) = 10 cos (wet + 3 sinwmt). Assume FM and fm =1 KHz.…

A: x(t)= 10cos(wct+3sinwmt) The given signal is frequency modulation FM. fm=1 KHz,

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.