i need the answer quickly 6. Whether the value of synchronous impedance (Zs) is constant? Statethe conditions on which it depends?7. Why the saturation under short circuit conditions is low?8. Draw the labeled vector diagram for lagging power factor load.9. Why the regulation is negative in case of leading power factor load?10. Draw the nature of voltage characteristic of an alternator for a load atlagging, leading; and unity power factors.11. Plot the graph between open circuit voltage and short circuit currentagainst field current.12.What happen if the speed of dc motor is not constant throughout theexperiment?13. What are the other methods for regulation calculation?

We are authorized to answer one question at a time, since you have not mentioned which question you…

Answered: 6. Whether the value of synchronous…

6. Whether the value of synchronous impedance (Zs) is constant? State the conditions on which it depends? 7 Why tbe saturation under short circuit conditions is louv?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: In transistor modeling, all capacitors must be replaced by a _______ equivalent. a.short circuit…

A: In this question, we need to choose the correct options capacitors must be replaced by a _______…

Q: Astable multivibrator was designed using a 555 timer. The periodic time of the output signal should…

A: We need to find out the value of resistance for given timer

Q: A discrete-time system is described by the following rule y(n) = (-1)"x(n) + 2 x(n – 1) where x is…

Q: Arrange AM, SSB-SC, DSB-SC, and FM in the decreasing order of bandwidth required for transmission.…

A: We need to find out bandwidth for different modulation .

Q: H.W.4: For the circuit in Fig., find i(t) for t > 0. Answer: 2e A, t>0 12 ww 2413

Q: Design a simple zener diode shunt regulator circuit with an input voltage of 15V nominal and 16V…

Q: Compute the total Resistance Compute the voltage and current in each resistor R1= 30 0 R= 50 R= 15 0…

A: Given:

Q: Given the following three mutually exclusive alternatives, Alternative A B Initial Cost $50 $30 $40…

A: Given the following three mutually exclusive alternatives, Initial Cost A Alternative B…

Q: Q 2: Astable multivibrator was designed using a 555 timer. The frequency of the output signal should…

A: We need to find resistance value for given timer .

Q: A series resonant circuit has a Q of 150 at 3.5 MHz. The applied voltage is 3 microvolts. What is…

Q: TUTORIAL PROBLEMS A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature…

A: Solve the problem

Q: Three types of electric devices A, B, and C are connected in series across a 115-volt ac source, and…

A: In thid question we will find given device types with given information...

Q: (a) The following circuits made of universal gates could be replaced with just one single gate for…

Q: A fixed-bias common-emitter amplifier has an unbypassed, 1.2 kQ emitter resistor, and 270 kN base…

Q: E2 The input impedance parameter (hie) in CE configuration is almost equal to O a. re O b. Bre O c.…

A: Solve the problem

Q: H.W. : Design a low-pass RC filter to have a cutoff frequency of 30 krad/s. Use a 0.01- uF…

Q: We want to design a causal discrete-time LTI system with the property where the input is 피(m) =…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: a) i) Sketch the sequence x[n] = sin(n. T1/2) plotted against 'n' (the sketch should only go from n…

Q: Compute the total Resistance Compute the voltage and current in each resistor

A: It is given that:

Q: Determine the static resistance of the diode characteristics labelled A as shown in the figure. *

Q: Apply mesh analysis to find Vo in the circuit. 5 A 4Ω 2Ω 4Ω 20 V 40 V

Q: first step in determining the AC equivalent model for a transistor is setting all dc sources to ____…

A: We need to select correct option for given statement

Q: A temperature sensor transfer function is 44.5 mV/°C. The output voltage is measured at 8.86V on a…

Q: 9. Write the emf equation Ef/ph of 3 phase synchronous generator.

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: H.W.5: Determine i, i,, and v, for all t in the circuit shown in Fig.. Assume that the switch was…

A: Inductor doesn't allow the sudden change of current flowing through it. In steady state inductor…

Q: 2. Determine the indicated parameters across terminals a and b. Consider each of the networks…

Q: Vo (w) V, (m) H.W.1: For the circuit shown, obtain the transfer function filter and determine the…

A: To obtain the transfer function for the given circuit and then find the corner frequency

Q: Answers can be found at www.pearsonhighered.com/floyd. 1. An amplifier that operates in the linear…

A: In this question, We need to choose the correct options What is linear amplifier? as per our…

Q: Problem #16: A substation operating at full load of 1200 kVA supplies a load at 0.7 power factor…

Q: Astable multivibrator was designed using a 555 timer. The periodic time of the output signal should…

Q: ii) We want to digitise a signal that contains frequencies between 100 Hz and 1500 Hz, assuming 16…

A: Bits rate are number of bit transmit over the medium per second . Bit rate is calculated by : bit…

Q: 1. Solve for the current of 1+j3 ohms impedance using Kirchhoff's Law. 0.022 0.02 L looiv

A: In this question we will find current through RL series circuit using Kirchoff law....

Q: (i) (ii) (e) Consider the output of the full bridge rectifier from part (d) (i) If a smoothing…

A: We need to solve the above question related to full bridge rectifier and half wave rectifier and…

Q: 6) For a binary multiplier that multiplies two unsigned four-bit numbers, (a) Using AND gates and…

A: Given A four bit binary multiplier using AND gates and binary adders. Please find the below…

Q: FIND THE INVERSE LAPLACE OF: 10 5 18 F(s) 6. S-4 (s–5)* 2 S+9

Q: Find the energy in the signal x[n] = n² over the period n=0 to n=9.

Q: Astable multivibrator was designed using a 555 timer. The periodic time of the output signal should…

Q: Next State/Z Present State x=0 X-1 A A/O B/0 B c/o A/O C A/0 D/1 B/0 A/0

A: The solution is given below

Q: The input impedance of an ac network can be measured with an ohmmeter. a.False b.True c.True if the…

A: In this question, We need to choose the correct options The input impedance of an ac network can…

Q: 7. Suppose you have a supply of inductors ranging from 1.00 nH to 10.0 H, and resistors ranging from…

Q: In a CE Voltage Divider Bias configuration AC analysis, the resistor connected to the Emitter will…

Q: connected to the divider circuit in the configuration shown in the figure? R1 R2 R3

Q: Difference between Lumen and Candela?

A: Bartleby has policy to solve only first question. Kindly upload one question at a time.

Q: A series RLC circuit consists of a 10Ω resistor in series with L = 10µH and C = 100µF. Determine a…

Q: Q2: Answer two of the following questions: a) For the circuit shown in fig.(2), R. C - 10e v and…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: E2 Problem No. 3 (P3) A CE Fixed Bias BJT configuration has the following parameters: Vcc=12V,…

A: Note : After the analysis we come to know that none of the options are correct for the given…

Q: 2. What binary word would represent the decimal number 14 if Table 1.1 were continued? TABLE 1.1…

A: Binary of a decimal no is calculated by 2 method First by table continue decimal to binary follow…

Q: Solve the current flowing to silicon diode of the given circuit below. 32 V 6.8 kohms 14V O OA O4 mA…

Q: What is the data rate then of a Delta Modulation encoder that uses the same sampling rate as that of…

Q: C. Determine the collector current in Q5 and the reference current Ix. If the amplified mirrored…

A: The given circuit is as shown below,

Question

i need the answer quickly

6. Whether the value of synchronous impedance (Zs) is constant? State
the conditions on which it depends?
7. Why the saturation under short circuit conditions is low?
8. Draw the labeled vector diagram for lagging power factor load.
9. Why the regulation is negative in case of leading power factor load?
10. Draw the nature of voltage characteristic of an alternator for a load at
lagging, leading; and unity power factors.
11. Plot the graph between open circuit voltage and short circuit current
against field current.
12.What happen if the speed of dc motor is not constant throughout the
experiment?
13. What are the other methods for regulation calculation?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3- A 3-phase, 8-pole, star-connected alternator has 72 slots on the armature. Each slot has 12 conductors and winding is short chorded by 2 slots. Find distributed factor and pitch factor? Note : w.r.t. mean (with respect to)
1.) A 6-pole, 3-phase, 60-Hz alternator has 12 slots per pole and four conductors per slot. The winding is 5/6 pitch. There are 0.025 Wb entering the armature from each north pole, and this flux is sinusoidally distributed along the air gap. The armature coils are all connected in series. The winding is wye-connected. Determine the open circuit emf per phase of the alternator. Subject Electrical machine 2
Draw a complete circuit diagram of 1 phase synchronous alternator including the field excitation circuit. Then, draw the phasor diagram of the generator a general leading power factor. Include the phase resistance in the diagram.
3. A three-phase 60 Hz Wye connected, 2,000-kVA, 2,300-V alternator give a short circuit-test current of 600-A for a certain field excitation. With the same excitation, the open circuit-test voltage was 900-V. The resistance between a pair of terminal was 0.12-ohm. Find the full load regulation at a) unity power factor and b) 0.8 power factor.
b) Explain the conditions of parallel connection of alternators and how these conditions are fulfilled.
Draw a complete phasor diagram of a single-phase synchronous generator at a general unity power factor. Draw also the equivalent circuit of the generator. Phase resistance must be included in the phasor diagram.
A three-phase 3300V. 50 Hz star-connected alternator has an effective resistance of 0.5 ohm/phase. A field current to of 30A produces full-load current of 180A on short- circit and a line to line emf of 1000V on open circit Determine(i) the power angle of the alternator when it delivers full-load at 0.8p.f(lag) (ii)the SCR of the alternator D
A single phase, 2000 V alternator has armature resistance and reactance of 0.8 ohms and 4.94 ohms respectively. The voltage regulation of the alternator at 100 A load at 0.8 leading power factor is ??
Draw a complete equivalent circuit of one phase only of a synchronous generator. Then draw the phasor diagram for a unity power factor. Assume the phase resistance is ignored
A synchronous generator has 4 poles and a synchronous reactance of 5 ohms. The operating frequency is 60 Hz. The stator windings are connected in Y and the voltage between the lines is Vl= 15 kV. The generator line current is 1 kA with a power factor of 0.9 (lagging). Find:a) The amplitude of the excitation voltage (induced voltage Eaf. ).b) The actual power delivered by the generator.c) The reactive power supplied by the generator.
A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing 5 conductors arranged in a full-pitched winding for 3-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emf induced in each phase winding and the terminal voltage.
A three-phase, 4-pole, 1,500 rpm alternating having a double layer-windings with 18 turns per coil. The slots per pole per phase are 10 and the coil span is 22 slots. The spread phase is 60 degrees and the flux per pole is 0.0625 Weber. If the armature windings are wye connected. a) Determine the generated voltage per phase and the line to line voltages. b) If the alternator is delivering a three - phase load of 1,200KW at 0.8 lagging power factor what is the line current of the alternator