7) A linear spring has a spring constant of 20 N/m. How far would it have to be stretched to have a potential energy of 0.101? A) 0.10 m B) 200 m (0.0050 m Di 20 m

Q: Subject:Electronics Engineering How MOSFET has been constructed? Explain the principle of operation…

A: Metal Oxide Silicon Field Effect Transistors: MOSFETs is a  electronic devices, that is  used in…

Q: Question No.32 Find the current rating for the following system. An outdoor pole-mounted 11 kV/415 V…

A: Given: Power, P = 63 kVA Line voltage, VL=415 V Line current rating, IL=?

Q: R VR IR VL LV. + Ī. IL Consider the RLC circuit shown. The sinusoidal voltage source has a magnitude…

A:

Q: Consider the following circuit. What is the value of current I in the circuit shown? (a) I A (b) 2 A…

A: Given,

Q: In the figure, the current through the wire (shown in cross-section) is into the screen. What will…

A:

Q: A single-phase half--bridge inverter is connected to a 600V d.c. source. A series connected R-L load…

A: The Given data is, Single-phase half bridge inverter is connected to a 600V dc. R-L load is R=60…

Q: What is the Baud rate for M-ary digitally modulated carrier if M = 8 and channel capacity = 2.7 kHz…

A: Baud rate is rate at which the data is transmitted that is number of bits transmitted per second.

Q: 2. For the circuit given below, compute for the value of V (assume that the circuit has been turned…

A:

Q: 3.2 In the circuit in Figure 3.2, the switch is closed at time t=0, the capacitor with 10 V voltage…

A:

Q: Describe and Explain what occurs in each of these circuits when the pushbutton switch is actuated…

A: The SCR is a unidirectional device that allows the current to flow in one direction and opposes it…

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R2…

A:

Q: find the voltage of the inductance 1H if the value of the source is: 50 sin(100) volt R3 R2 R1 552…

A: To find voltage across inductance of value 1H as shown in the circuit

Q: A building, supplied by a 230 Vrms source and with inductive loads, has an average consumption of…

A:

Q: What is the Baud rate for M-ary gitally modulated carrier if M = 8 and channel capacity = 2.7 kHz…

A:

Q: Q3: For the following system with T=0.5, T4-0.25, T3=1. determine the range of stability of the…

A: Given data : ζ1=0.5 ζ4=0.25ζ3=1K=k1k2k3

Q: Amplitude Modulation (AM DSBFC) radio broadcasting station with its carrier frequency of 650 kHz is…

A: We need to find out the percentage power saving for SSB modulation .

Q: FFEREN 1. y" + 5y' - 4y = 0

A:

Q: Find Vc, VB and Ic in the given circuit. RB www 33 ΚΩ Vcc +3 V +1₁ Rc 1.8 ΚΩ PDC = 90

A:

Q: Find the transfer function () for the circuit below. Is (w) ¿¸(1) O 252 1 H i,(t)) 492

A: In this question we need to find a transfer function of the given circuit.  We use Fourier transform…

Q: ulate the total current shown in figure (2-37). 100 Ω 100 V 60 Ω 40 Ω 88 9 Figure (2-37) www 38Ω

A:

Q: AMPLE (4):- Calculate the current through the resistance (102) for the circuit show in figure (3-9)…

A:

Q: EXAMPLE (1):- Calculate the electrical energy consumed by the electrical heater during (7 hours) if…

A: Given Time, t = 7 hr Voltage, V = 220 V Current, I = 8 A

Q: Solve for V₁ and IL-

A:

Q: Q: Draw output voltage waveform for this circuit if B=50. +10 +5 Vi -1vF 2 3 4 t(ms) 50k W +10v ·…

A: Brief discussion: For the given amplifier circuit we need to make the output voltage waveform.

Q: number? Q2/ Answer all branches: (7 1. By using BCD (8421) code express the (-849)10 in…

A: We will do complement and signed magnitude representation only for negative numbers.

Q: The switch in the circuit in Fig. P6.24 has been open a long time before closing at t=0. The initial…

A:

Q: PROBLEMS P6.1 Utilizing the Routh-Hurwitz criterion, determine the stability of the following…

A: Given polynomials, a s2+5s+2b s3+4s2+8s+4

Q: 2: find Z equivalent if the frequency is 50 R2 R1 R3 ww w 3022 5.52 792 :3mF Z eq 4mF 2H

A:

Q: . Find the Branch currents and V₁. ΖΩΣ 10V + ΙΩ τ ΤΩ Α 1.5V Ω

A:

Q: 3.3 k R₁ 24K0 R₂ 1.2 KO 120 mA 7. For the circuit above (circuit from question 2.): a. Find the…

A:

Q: The power of a heater is 500 W at 800 °C. What will be the power at 200 °C? Temperature coefficient…

A: In this question we need to find a power at 200oC .

Q: a. IB. b. Ic. For the emitter-bias network , determine: +20 V • 2 ΚΩ 430 ΚΩ Vi 10 με 10 με H β = 50…

A:

Q: Sow at an H-W₂D & A Power transistor for which TJmax = 180°℃ Can dissipat a case temperature of…

A: Given data, Tjmax  = 180°C ,TC = 50°C and power dissipated PD = 50 Watts and case sinks thermal…

Q: Total impedance is Z= Z₁XZ₂ Z₁ + Z₂ (5+j 6.28)(1+j 25.23) Z= 5+j 6.28+1+j 25.23 Z=

A: given total impedance is Z=z1z2z1+z2Z=5+j6.281+j25.235+j6.28+1+j25.23here we have to find the total…

Q: 2. For the circuit given below, compute for the value of V (assume that the circuit has been turned…

A:

Q: 2Ω 10V( + Μ ΖΩ 4Ω 1Ω 1Ω 3Ω Μ 4Ω ΖΩ 16V 3Ω |12V

A:

Q: Draw the circuit by following the steps for the given function. f(a,b,c,d)= (1,3,5,7,9)+ (11,13) a)…

A: Given data : fa,b,c,d=∑11,3,5,7,9+∑ϕ11,13

Q: 7. Simplify the following Boolean expression: Y = AB'CD' + ABC'D' + A'BCD + AB'CD + ABCD

A: Given Boolean expression, Y=AB'CD'+ABC'D'+A'BCD+AB'CD+ABCD

Q: An 891 kHz carrier having an amplitude of 60 volts is modulated by a 4.5 kHz audio signal having an…

A:

Q: Draw the dc and ac equivalent circuit for the unloaded amplifier in figure 1. Vcc +15 V C₂ 1 μF PDC…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R2…

A:

Q: The two plates are connected across a 12 V battery of a two flat metallic plates are 0.5 centimeter…

A: given circuit of capacitor

Q: Thee resistors each has a value of 1k ohm are connected in delta configuration to a three phase…

A:

Q: 1. Reduce the network below to the smallest possible number of components if each inductor is 1 nH…

A: given here a inductor and capacitor network and asked to reduce the network.     let c1 , c2  be two…

Q: Determine VD and VGS for the network

A: The required parameters can be calculated by using the DC analysis of the amplifier circuit.

Q: Is L₁ V (~) oad 1: 200 W, unity power factor oad 2: 1200 W at 0.85 power factor lagging oad 3: 400 W…

A:

Q: When x, y and z are positive and less than 6,a certain magnetic field intensity may be expressed as…

A: Given  The magnetic field density of a strip.we need to find the total current that crosses the…

Q: The switch in the circuit in Fig. P6.24 has been open a long time before closing at t=0. The initial…

A:

Q: What is the Baud rate for M-ary digitally modulated carrier if M = 8 and channel capacity= 2.7 kHz

A: It is given that: M=8fb=2.7 kHz

Q: Find 11, 12 and 13 for the circuit shown below 20 12 Ω 1:2 120/30° V ^^^+-+ C^^*^^-} -j5 N j16 Ω

A: In this question we need to find a current I1 , I2 , I3

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.