7. Encode a binary word 110101 into an even parity hamming code.
Q: . Consider a random process x(t) = Acos(wot+0), where A and wo are real constants, and Ⓒ is a random…
A:
Q: If C 45 µF, determine the equivalent capacitance for the combination shown. a) 17.0 µF, b) 30.0 µF,…
A:
Q: 1. Find the equivalent impedence Zeq of this network at f = 1 kHz. A) 10 + j95.46 Ω Β) 5.19 - j19.04…
A:
Q: A unity negative feedback system has an open loop transfer function k G₂ s(s+10) for the system to…
A: Given data, Open loop transfer function Gs=kss+10, Unity feedback system Hs=1. Damping factor…
Q: 12 V V 4 ΚΩ www 3 ΚΩ 2 ΚΩ www 1ΚΩ 8 V 5 ΚΩ 10 ΚΩ Find current across 10k ohm resistor. (1+ 6V
A: We need to find out the current for given circuit through given resistor .
Q: How much current flows through a 250-millihenry inductor when a signal of 12 volts and 60 hertz is…
A: We need to find out the current for given Voltage and inductor .
Q: A 30 60-Hz induction motor runs at 715 rpm at no load and at 670 rpm at full load. The slip-torque…
A:
Q: A square-wave generator produces the voltage waveform shown in the given figure (a). v (V) A 5 0 WW…
A: Formula VL=L dILdtIC=C dVCdt L= Inductor C= Capacitance
Q: A proton is moving at 2.0 x 107 m/s perpendicular a magnetic field of 30 mT. What is the magnetic…
A: Given data, Velocity of proton v=2×107 m/s. Magnetic field B=2 mT=2×10-3 T. Charge on proton…
Q: The full-scale deflecting torque of a 20 A moving-iron ammeter is 6 × 10³ N-m. What is the rate of…
A: The given problem is from measuring instruments. The detailed solution is given in the next step
Q: Please consider the following circuit. If f= 159.15kHz, V1 = 12230° and V2 = : 620°, determine the…
A:
Q: Which of the following characteristics are true for both RF and laser communications systems? None…
A: Given:
Q: 1. Laplace transform and its inverse -5t te a) Consider f(t) = To 05 70(1-7) i) Write f(t) in terms…
A:
Q: An audio amplifier with resistance 7 supplies power to a speaker. In order that maximum power is…
A: Given, The audio amplifier is supplies power to speaker. The resistance of audio amplifier is…
Q: What is the relationship of current, coulombs, and time? How long does it take for 3 coulombs to…
A: We need to find out time for given current and charge .
Q: 6. A digital signal is sent using a Hamming code for error detection and correction. The signal…
A: The parity code is checked as shown below.
Q: An example of the Standard Problems is: ⬚ VLSI Designs ⬚ Network Routing ⬚ Circuit-Board Drilling ⬚…
A: The question is from electrical engineering. The question is about standard problems.
Q: d) N=1100 13cm¹ 5cm Mr=4000 7cm =cy find the maximum current, I, so that the force across is S=30cm²…
A: Current is the rate at which a charge moves through a circuit point. Potentially, the maximum…
Q: A bipolar HVDC link is delivering 1000 MW at ±400 kV at the receiving end. Calculate the losses in…
A: A bipolar HVDC link is delivering,Power P=1000MW at±±400kVR=1ΩTo find,Plosses=?Ps=?Vd1=?Pdm=?
Q: The characteristic of an op-amp that tells how fast the output voltage changes is called O gain…
A:
Q: DELMAR CENGAGE Learning FIGURE 5-21 16 E₁ = 12 V R, = 500 Ω R₂ = 12000 5. What is the total circuit…
A: We need to find out the current for given circuit.
Q: For the circuit below in phasor form with R₁ = 13N, X₁ =-7, A=8 and B=39, calculate the average…
A: The given problem is from circuits. The detailed solution is given in the next step
Q: The upper critical frequency of a particular op-amp is 100 Hz. What is its open-loop 3 dB bandwidth?
A: Given data, Upper critical frequency fu=100 Hz.
Q: C=1µF Vo R ww LM741 V₂
A:
Q: Q3) a PMMC instrument with a 100 turn coil has magnetic flux density in its air gaps of b-0.2 T. The…
A:
Q: Specifications: (a) VDD = 9 V (b) The DC voltages at Vout1 and Vout2 are VDD/2. (c) IR,=10 μA. (d)…
A: The current mirror circuit is given as Given…
Q: d) To measure currents in the simple circuit shown in Fig. 2 below, you would replace a wire between…
A: We know that For measuring current we connect ammeter in series with the corresponding element…
Q: Determine the magnetic field at (0, 0, 5m) due to 15 A current flowing in a circular loop of radius…
A: Given- Current I = 15 A, A circular loop of radius 3 m, To Find- The magnetic field at (0, 0, 5m)…
Q: Required information Problem 05.001 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS The equivalent…
A: We need to find out the output impedance for given circuit.
Q: Draw the magnetization curve of the generator results of IF 1 0 0.02 07 0.0 0.12 0.17 0.24 0-36 0.55…
A: Magnetization characteristic Magnetization characteristic depicts the relationship between no-load…
Q: f) The maximum potential across the source. TI of th 1 R
A:
Q: Problem 05.047 - A difference amplifier The circuit given below is for a difference amplifier. Find…
A: The operational amplifier is solved as shown below.
Q: Problem 03.008 - Nodal analysis: Independent voltage source and dependent voltage source In the…
A: The given problem is from nodal analysis of circuits. The detailed solution is given in the next…
Q: QUESTION 8. Find the piecewise-linear equivalent circuit for the diode of Fig. 1.15. Use a…
A: Diode A diode is a two-terminal electronic component that primarily conducts current in one…
Q: in Manila, the LRT runs between Gil Puyat Station and Tayuman Station, which is 4 km apart and…
A:
Q: The circuit has an RMS secondary voltage of 22.16 volts. One of the diodes is broken. Considering…
A: Given data Primary voltage, VpRMS=120 V Secondary voltage, VsRMS=22.16 V Supply frequency, f=60 Hz…
Q: For a BJT to operate in the saturation region, the base-emitter and collector-base junctions must be…
A: Given for the BJT to operate in saturation the conditions .
Q: 4. An LRC circuit is shown with an alternating source with a current given by i(t)- Icos(cot), with…
A: Given: In this question, the given details are, The LRC circuit with an alternating source with a…
Q: Required information Problem 05.008 Consider the followings: Problem 05.008.b - Ideal op amp with…
A:
Q: 4. Find i(t) on the following circuit for t 0. 1=0 6A Μ 4 Ω όλα (0) από πολλά άλλα προ i 2 Ω 3Η Ο
A: We need to find out the inductor current for given circuit .
Q: Find, from the definition, &{cos wit} Jo ej(w-wit= and (w-w₂) Use <-02
A: here we have to find the fourier transform of cos w0t we know that ∫-∞∞ e -j w - w 0 t dt = 2 π…
Q: Calculate for the low cut-off frequency of the bandpass filter given below. 1.5k vi-M 0.047u O 225…
A:
Q: I (b) 6. Given the vector: A = 3e*sin(x)i - (3y-ysiny)j + ln(z) k (a) Find the Divergence Find the…
A:
Q: 2.( ) AT89C51 applying 6MHz crystal oscillator, when timing 1ms in the timer mode 1. The initial…
A:
Q: Q3 A transmission line of 50 2 operating at 120 MHz is terminated by (80 j20) 2 load impedance. Is…
A: The transmission line problem is solved as shown below.
Q: A non-inverting comparator circuit has a voltage reference of 500 mV. If the input voltage is…
A: comparator output will saturate at positive value if the voltage at the non inverting terminal is…
Q: V₁ +1 t = 0 X R + UL elle
A:
Q: QUESTION 3 A voltmeter, having a sensitivity of 1,000 £2/V, reads 100V on its 150V scale when…
A:
Q: 3.) For the unit step response shown, find the transfer function of the system. PRUCHY F GE Thecond…
A:
Q: For the circuit shown. If I =20 20 A, R = 1492, Xc1 = -2j Q2, Xc2 = -5jQ2, XL1 = 7j92, and X₁2 = 1j…
A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per…
Please assist with question 7 with details on how to do it. Thank you
Step by step
Solved in 3 steps with 2 images
- Q2) A) Based on the count sequence and decoding operations of 74LS90S ICs shown in Figure below. Q2) B) Use the SAR ADC to convert the analog voltage of (7.28 V) to 8-bit binary. If (VREF = 10V), determine the final %3D binary answer and the percent error. 01011101, 0.1974588% 11011101, 0.1974588% 01011111, 0.1974588% 01111101, 0.1974588%Write hamming code for the data 0011 for the (i) Even parity (ii) Odd parity. Explain the process brieflyDraw the circuit diagram of 4-bit Ripple Carry Adder. Page 6 of 8
- An analog voltage (0 to 5) volt is to be converted to 8 bit digital form. d. What is the error made in quantization of 2.2 volt as a percentage of the input.(a). If I want to store 4-bit data 0110 and at 4th clock I want to extract all the stored bits, which shift register I should explain it with the help of circuit diagram and table. (b). Write comparison between Diode transistor logic and Transistor Transistor logicAn analog voltage (0 to 5) volt is to be converted to 8 bit digital form. a. What is the resolution in volt. b. What is the digital representation of 2.2 volt. c. What is the largest quantization error as a percentage to full scale. d. What is the error made in quantization of 2.2 volt as a percentage of the input.
- 13. How can be increased the accuracy of the derivatives for linear finite elements in FEM postprocessor?Q2) B) Use the SAR ADC to convert the analog voltage of (7.28 V) to 8-bit binary. If (VREF = 10V), determine the final binary answer and the percent error. O 01011101, 0.1974588% 11011101, 0.1974588% O 01011111, 0.1974588% O 01111101, 0.1974588%please show work included 4. If a 6-bit binary number is used to represent an analog value in the range from -63 to 126, what is the accuracy of the system? In other words, if the binary number is incremented by one, how much change does it represent in the analog value?
- -72 in decimal equal to . ..in signed binary O a. 10111000 O b. 10111100 O c. 10111101 O d. 10011100B) Design an Octal-to-Binary (8-to-3) Encoder, and then draw a block diagram for Octal-to- Binary Encoder.The resolution of the ADC unit with the reference voltage value of 3V is set to 8 bits. If the voltage level applied to the ADC input is 1.67 V, what is the numerical value read? For numbers with commas, take 4 digits after commas.?