9.00 moles of an ideal gas, goes through heat engine cycle abca, as shown in the figure. Process ca is an adiabatic process. Process ab is isobaric. Process be is isochoric. y for this gas is 1.60. The temperatures at states a and bare 300 K and 500 K, respectively. The volume of states b and cis 0.200 m3. a. Calculate the pressures pa, ph, and pe, the volume Va, and the temperature Te b. Calculate the heat absorbed in process ab. e. Calculate the heat rejected in process be. d. Calculate the work done by this heat engine, in one cycle. e. Calculate the efficiency of this heat engine cycle. 300 K 500 K a b 0.20 m³

9.00 moles of an ideal gas, goes through heat engine cycle abca, as shown in the figure. Process ca is an adiabatic process. Process ab is isobaric. Process be is isochoric. y for this gas is 1.60. The temperatures at states a and bare 300 K and 500 K, respectively. The volume of states b and cis 0.200 m3. a. Calculate the pressures pa, ph, and pe, the volume Va, and the temperature Te b. Calculate the heat absorbed in process ab. e. Calculate the heat rejected in process be. d. Calculate the work done by this heat engine, in one cycle. e. Calculate the efficiency of this heat engine cycle. 300 K 500 K a b 0.20 m³

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2. Water as saturated vapor at 70 bar is heated at in a rigid vessel until its pressure reaches 100 bar. By using steam table, a. find the final T (°C), Au and Ah (kJ/kg) b. assuming an ideal gas, calculate Ah (kJ/kg) do the energy balance to find q (kJ/kg)? 3. Determine the internal energy change of hydrogen in kJ/kg as it heated from 76.85 °C to 526.85°C by using: a. empirical molar specific heat data from Table A-2(c) b. specific heat at the average temperature from Table A-2(b). C. the 300 K value for the specific heat from Table A-2(a).
1. Twenty kilojoules of heat is added at constant volume to 2.5 kg. ideal gas (k= 1.25, R = 320 J/kgOK). the initial temperature of the gas is 320C. compute for the following: a. Non-flow work b. final temperature of the gas
2. Saturated steam at 100°C is heated to 350°C at constant pressure. Use the steam tables to determine: a. The pressure in bar. b. the required heat input (J/s) if a continuous stream flowing at 100 kg/s undergoes the process.
NOTE: Complete solution and show the derivation/cancellation of units. A steel flask of 0.04 m capacity is used to store Nitrogen at 120 bar and 20°C. The flask is protected against excessive pressure by a fusible plug which will melt and allow the gas to escape if the temperature is too high. A. How many kilogram of Nitrogen will the flask hold at the design conditions? B. At what temperature in °C must fusible plug melt in order to limit the pressure of flask to a maximum of 150 bar?
Dry saturated steam is expanded in a nozzle from a pressure of 10 Bar to a pressure of 4 Bar. If the expansion is supersaturated, find: 1. The degree of undercooling 2. The degree of supersaturation
Consider the following : 1. For isobaric process, n=0 2. For isothermal process, n=1 3. For isochoric process, n= * 4. For Adiabatic process, n=1 Which of the above mentioned values are correct for the value of n? Select one: O a. 1,2 and 4 only O b. 1,2 and 3 only O C. 2,3 and 4 only O d. 1, 2, 3 and 4
A gas has a volume of 3.4L at 25 degC, what is the final temperature (in Rankine) if the volume increases to 4.7L?
Two vessels A and B of different sizes are connected by a pipe with a valve. Vessel A contains 142 L of air at 2,767.92 kPa, 93.330C. Vessel B, of unknown volume, contains air at 68.95 kPa, 4.440C. The valve is opened and, when the properties have been determined, it is found that pm = 1378.96 kPa, tm = 43.330C. What is the volume of vessel B?
Problem 1. A sample of an ideal gas goes through the process shown in Figure 1. From A to B, the process is adiabatic; from B to C, it is isobaric with 240 kJ of energy entering the system by heat; from C to D, the process is isothermal; and from D to A, it is isobaric with 360 kJ of energy leaving the system by heat. Determine the difference in internal energy Eint B - Eint ‚A P (atm) V (m³) 0.09 0.2 0,4
2. The gas expanding in the combustion space of a reciprocating engine has an initial pressure of SO bar and an initial temperature of 1623*C. The initial volume is 50000 mm' and the gas expands through a volume ratio of 20 according to the law pV constant. Calculate w and AU Take R= 270 J/Kg K and C, = 800 J/Kg K. Assume n 1.38
An Isobaric process is done on steam where it is heated to 200 C at 1.1 MPa. It was initially a kilogram of saturated liquid. Find the change in volume, change in internal energy, change in enthalpy, and change in entropy. (0.1848 m3, 1837.31 kJ, 2040.66 kJ, 4.4609 kJ/k) Table 3. Vapor pt Sat.) 1.10 (I4.09) 1.15 (I6.07) 10 Set. 177.53 2586.4 2781.7 6.5535 170.13 2587.7 27833 6.5381 175 100 185 190 195 4.4726 172 50 2547.9 2757.6 175.28 2572 27710 178.02 25882 2784.0 6.3387 180.71 2598.1 2796.9 183.36 2607. 2809.5 14.20 2564 27336 164.91 25732 2767.2 3028 L69.37 23835 27405 6.5004 6.5866 6.6137 63603 6.5878 174.75 2605.4 2806.4 200 205 210 215 220 185.97 2617.4 2822.0 6.6401 188.56 2626.8 2834.2 6.6659 191.11 2636.1 2846.3 193.63 2645 3 28583 196.13 2654.3 2870.1 6.6911 6.7157 6.7398 177.28 2615.1 2819.0 6.6146 179.77 2624.6 28314 6.6407 182.24 2634.0 2843.6 6.6661 184.68 2643.3 2855.7 6.6910 187.09 2652.5 2867.6 6.7154 225 230 235 240 245 198.60 2663.3 28818 6.7634 201.05 2672.2 2893.4…
Can you solve this problem (full solution) for my thermodynamics subject. Thank you 4. Five kg of water vapor are contained at 150 kPa and 90 percent quality in a suitable enclosure. Calculate the heat which must be added in order to just produce a saturated vapor. What will the pressure be at the end of the heating process? Ans. 1045.5 kJ, 168 kPa.