A 10-mH inductor has current i = 5.0 cos 2000t (A). Obtain the voltage VL.
Q: A. Three capacitors 15 µF, 10µF, and 5µF are connected in series with a 10 v battery. Determine:
A:
Q: In a day, a household consumes 30W Light for 10 hours usage and 70W from appliances for 4 hours…
A:
Q: 12. Consider a battery having Ví = 300V. We measure V1 known resistance Ro = 150kN on the…
A: Given information: A battery has a value of EMF Vb=300 Volts. Since nothing is mentioned we are…
Q: Q1: Draw the block diagram for AM/DSB-SD system uses a carrier frequency 1MHZ and pilot carrier of…
A:
Q: Find expressions for the magnitude |G(j@)| for function G (s) below: s+5 G(s) = s(s + 1)(s + 2)
A:
Q: The network shown in Figure 2 contains two voltage sources, V, = 30Z0° and V2 = 2020°. Using mesh…
A: In this question, Find the power in the resistor We know Power P= I2 R Watt
Q: (a) For the common base circuit shown in Fig. Q2(a), determine Ic and VcB. Assume the transistor to…
A: Please refer the attached images for the complete answer..
Q: A copper conductor wire with a total length of 100ft is used in a 15 amp common household circuit…
A: Given , A copper conductor wire problem. We have to find the required One. Please find the below…
Q: A 200 kVA, 60 Hz, 4600/230 volt transformer has the following characteristics: R;=2.25 Q R,=0.005 N…
A:
Q: Calculate the noise voltage at the input of a television RF amplifier, using a device which has a…
A:
Q: Which of the following are considered an issue with wind or solar power? a) It is not always…
A: The answer is option d) all of the above. Let's get to each option one by one.
Q: Consider the angle modulated signal: v(t) = 10 cos [2πx108t + 3 cos(2πx103t)] Assume that the…
A:
Q: In the following circuit, the switch has been in current position for a long time. At t=0 s switch…
A:
Q: . For the circuit in Fig. 3.10, is = 6 cos 10°t A. Find the average power absorbed by the 50 - n…
A:
Q: Q1: If the power generated by a wind system at a height of 50 m is equal to 30 kw at a wind speed of…
A: Given that Pw1=30 KWh1=50 mh2=?v1=4m/sPw2=1.5Pw1v2=2v1 Although it is known that , in the case of…
Q: 1. Perform the theoretical calculations to determine the Q-point for both circuits and compare them…
A:
Q: Inverting Amplifier Analyze the following circuit: R. R, in out From the schematic complete the…
A: Given,
Q: UL LET iL = 85mA sin(1650t+160 ) and L = 5 mH then Calculate the voltage across the inductor in…
A:
Q: 19. An AC generator has delta connections. If each winding is rated at 20 amperes, the line rating…
A: In this question, We need to choose the correct options What is each winding current is 20A Then…
Q: O Determine the value of ir and Vo
A:
Q: When a fault occurs, Select one: O A. the generator terminal voltage does not change immediately O…
A:
Q: . Which electrical quantity is measured in terms of the amount of electrons that continuously flows…
A: Current is the electrical quantity is measured in terms of amount of electrons that continuously…
Q: If a 1500-W hair dryer is connected to a 120-V line. What is the maximum current drawn? I =
A: The solution is given below
Q: Determine the region of an NMOS transistor O a. Triode region O b. None of the options O C. Cut-off…
A:
Q: 9.11 Find the phasors corresponding to the following signals: (a) v(t) = 21 cos(4t – 15°) V (b) i(f)…
A:
Q: A resistor of 50 ohms, a 200mH inductor, and a 1.5 x 10-4 F capacitor are connected in parallel to a…
A:
Q: 3. Determine the nodal voltages for the networks in Figure? 1,- 3AZ0 anee 40 20 I-SAZ 30
A:
Q: Find expressions for the magnitude |G(jw)| for function G(s) below: s+5 G(s) = s(s + 1)(s + 2)
A: A transfer function is the ratio of output to input with zero initial conditions. The numerator…
Q: Using the general approach to meśh analysis, find the current I, in metwork is redrawn subscripted X…
A:
Q: B. Three capacitors 15 pF, 10µF, and 5µF are connected in parallel with a 10 v battery. Determine:…
A: In this question we have given 3 capacitors which connected in parallel....
Q: Given a transformer (single-phase, 10kVA, 2400/240V, 60Hz) Z1 = 5.2 + j12.5 ohms; Z2 = 0.06 + j0.12…
A: In this question we need to find a load voltage of transformer for given condition.
Q: 'm not sure what capacitive touch is, or how it works.
A: Capacitive touch : Capacitive touch is the type of control display in which the input is the…
Q: The 50kW, 500V short compound DC generator has an armature resistance of 0.06 Ohms, a series field…
A:
Q: How long does it take for the conductors to reach the threshold temperature in a short circuit?…
A: The maximum operating temperature for the given conductor is, T1=70 oC. The cross-sectional area of…
Q: Why is it crucial to design a wiring system in farm structures?
A: The wiring systems are designed to carry consistent continuous electric current . These should be…
Q: The circuit is at steady-state when the switch closes at time t = 0. Calculate the steady-states…
A:
Q: Given the following circuit, what the current through the diode D2 (in mA) if: Vin = 1 V, R1 = 6 k2,…
A:
Q: Derive the flux density, D, by applying Gauss's Law: 1. Infinite Line Charge
A:
Q: Attempt the exercise of Passive Low-pass Filter Phasor Analysis R= 1kOhms, C-1 uF %3D [+] V_out VIN…
A:
Q: F(s) = -3s - 2
A:
Q: Cubes 1 and 2 electrostatically attract each other, and Cubes 1 and 3 electrostatically repel each…
A:
Q: Which of the following has a characteristic to operate in high voltages and can be transmitted over…
A: In this question we need to choose a correct option.
Q: Assuming that initial gain, K, of the system represented in the figure below is 1, the calculate the…
A: Let, GS=KSS+x The magnitude graph shows that both are poles because it have the negative slope. The…
Q: Find the equivalent resistance and output voltage ???? of a bridged T network
A: This question belongs to circuit theory . It is based on the concept of delta star transformation ,…
Q: Calculate the voltage across the inductor in phasor form
A:
Q: Question No.33 A single phase half bridge VSI has load R = 1.8 Q and DC source voltage 130 – 0 – 130…
A: Given a single phase half bridge VSI has, Load resistance, RL=1.8 Ω DC source voltage, Vdc=130-0-130…
Q: The percent modulation of the sound portion of a TV signal is 80%. Determine the frequency deviation…
A:
Q: (a) For the common base circuit shown in Fig. Q2(a), determine Ic and VCB. Assume the transistor to…
A:
Q: A copper conductor wire with a total length of 100ft is used in a 15 amp common household circuit…
A:
Q: Given a transformer (200 kVA, 60 Hz, 4600/230 volt ) R1=2.25 Ω, R2=0.005 Ω X1=13.4 Ω, X2=0.03 Ω Core…
A:
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
- A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?. An inductance of 15mH has a current drawing I = 15sin(650t - 300) A. Determine the equation of voltage in the circuit
- 4. The current through a 10-mH inductor is 10e“²A. Find the voltage and the power at t = 3s. Ans.-11.16 mV and -24.89mW5. A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e amperes. Ans. 0.05 Faradshow do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
- The parallel capacitor combination shown in the figure is connected across a 12 V source. Determine the following: a. equivalent capacitance Ceq b. the charge on the combination. c. the work needed to carry the charge across 1uF + 12V 3uF 2uFA. Find the equivalent capacitance of the combination shown in the figure. (C2 = 2µF, C3 = 3µF) B. Determine the charge on each capacitor, if there is a potential difference of 900V C. Determine the voltages across each capacitorPlease explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage