A 25-kg ladder, 4 m long, rests on a rough floor and against a vertical wall. The ladder makes an angle of 35° withthe horizontal. It starts to slip when a man weighing 75 kg has dlimbed halfway up. f= 0.20 at the wall.LadderWall35010) What is the coefficient of friction at the floor in three decimal places?

Answered: Image /qna-images/answer/fc26456b-b19b-4b4c-868f-4fd82a14df4b.jpg

A 25-kg ladder, 4 m long, rests on a rough floor and against a vertical wall. The ladder makes an angle of 35° with the horizontal. It starts to slip when a man weighing 75 kg has dimbed halfway up. f= 0.20 at the wall. Ladder Wall 350 10) What is the coefficient of friction at the floor in three decimal places?

A 25-kg ladder, 4 m long, rests on a rough floor and against a vertical wall. The ladder makes an angle of 35° with the horizontal. It starts to slip when a man weighing 75 kg has dimbed halfway up. f= 0.20 at the wall. Ladder Wall 350 10) What is the coefficient of friction at the floor in three decimal places?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 76PQ: Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to...

See similar textbooks

Similar questions

Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to either side. As they lift and hold it up so that it is motionless, each handle makes a different angle with respect to the vertical side of the chest (Fig. P5.76). If the angle between Jamals handle and the vertical side is 25.0 and the angle between Dayos handle and the vertical side of the chest is 30.0, what are the tensions in each handle? FIGURE P5.76
I 00LLJ408 - Go.. Question Info and Solutions Blocks A and B of mass 5 kg and 10 kg respectively are placed on a Smooth inclined plane of Inclination 30, as shown. Block A and B are subjected to forces 5 N And 50 N respectively along the incline, as shown. The coefficient of friction between A andBis 0.50 find the frictional force between A and B in N is: (g= 10 ms SOH 300 Options Solution Fs=Static frictional force umg cos 30 (0.5) (5) (10) cos 30 21.6 N Let a be the acceleration of both the blocks along 5.27 PM
A 45 kg box is at rest at one end of a 2 meter board. That end of the board is slowly raised at an incline until the box starts to slide. At that point, the angle is at 34 degrees. The coefficient of kinetic friction is 0.50N. Please help me calculate the coefficient of static friction between both the box and the board?
01. If cable CB is subjected to a tension that is twice that of cable CA, determine the angle 0 for equilibrium of the 10-kg cylinder. Also what are the tensions in wires CA and CB? i
A 2.0 kg box is placed on a wooden board with a static coefficient of friction= 0.2 and a kinetic coefficient of friction= 0.1. You slowly raise one side of the board until the box begins to slide. a) What will be the angle of the inclination of the board? b) Keeping the board at that angle, what will be the acceleration of the box?
A 5.0kg crate is tasting on a horizontal plank. The coefficient of static friction is 0.50. You raise one end of the plank slowly. What is the maximum angle (with horizontal) you can go without the crate sliding down the incline?
A box of mass M = 50 kg rests on a rough (ji) horizontal surface. When a force F = 300 N is acted on the box as %3D %3D shown in the figure below, the box becomes on the verge of slipping (Y alig de j gainall ). The coefficient of static friction of the rough surface is: F A. 0.92 B. 0.75 40° C. 0.14 D. 0.57 E. 0.34
The base of an automobile jackstand forms an equilateral triangle of side length 12 in. and is centered under the collar A. Model the structure as one with a ball and socket at each joint and determine the force in members BC, BD, and CD. The forces are positive if in tension, negative if in compression. Neglect any horizontal reaction components under the feet B, C, and D. Assume F-700 lb, b-12 in., h-17 in. Answers: BC- i BD= i CD- i lb lb lb
A painter stands on a scaffold hung by its ends from two vertical ropes A and P, 6 m apart. The scaffold weighs 200 N. The tension in A is 750 N and that in Pis 200 N. a) What is the weight of the painter? b) How far from A is he standing?
1. Suppose a block with mass 2.00 kg is resting on a ramp. If the coefficient of static friction between the block and the ramp is 0.370, what maximum angle can the ramp make with the horizontal before the block starts to slip down? UMC T UC KI
A man standing on the ground exerts a horizontal force of 439 N when pushing on his friend standing on the skateboard.If the friend’s mass is 70 kg, the skateboard’s mass is 2 kg, and the coefficient of static friction between the friend’sfeet and the skateboard is 0.8, calculate the magnitude of the force of static friction between the skateboard and thefriend’s feet. You can assume that the wheels on the skateboard are good enough so that you can neglect frictionbetween the wheels and the ground.
Logs weighing 1.3 kg and 2.2 kg lie on a flat surface and are connected by a rope that breaks at a force of 20 N. The coefficient of friction between the lighter log and the base is 0.50, and between the heavier log and the base 0.30. With what maximum force can we pull the lighter log so that the string does not break?