A 25.00-mL sample of La31 was treated with excess Na2C2O4 to precipitate La2(C2O4)3, which was washed to remove excess C2O4 22 and then dissolved in acid. The oxalate from La2(C2O4)3 required 12.34 mL of 0.004 321 M KMnO4 to reach the purple end point of Reaction 6-1. Find the molarity of La31 in the unknown.

Q: A student found that 0.076 g of PbF2 was dissolved in 220 . mL of saturated PbF2. What is the Ksp…

A:

Q: 7. In the standardization of ammonium thiocyanate, 15 mL of 0.1 N silver nitrate VS was measured…

A: Iodometry is the type of titration which uses a standard sodium thiosulfate solution as the titrant.…

Q: [CLO-6] Calculate the pMg in the reaction of 50 mL of 0.1 M Mg2* (buffered to plH 10) with 25.5 ml…

A:

Q: 5. A 0.1093-g sample of impure NażCO3 was analyzed by the Volhard method. After adding 50.00 mL of…

A: Given: Mass of impure sample = 0.1093 g Concentration of  of AgNO3 = 0.06911 M Volume of AgNO3 =…

Q: A carbonate fusion was needed to free the Bi from a 0.6400-g sample containing the mineral eulytite…

A: Given, Bi3+ + H2PO4- →BiPO4(s) + 2H+ mass of eulytite sample = 0.64 g molarity of NaH2PO4 = 0.0340 M…

Q: An unknown solution containing 25.00 mL of Ni2* in dilute HCI is treated with a known excess of…

A: Introduction :  This question is basically based on back titration concept . Given :  Molarity of…

Q: A foot powder sample containing Zn was dissolved on 50.00 mL water and was titrated to the end point…

A:

Q: Which of the following will cause no change in the amount of Fe calculated from the results of an…

A: Iron-phenanthroline complex formation is a spectroscopic method for the determination of iron…

Q: A 150.0 mL sample of 0.080 M Ca2+ is titrated with 0.080 M EDTA at pH 9.00. The value of log Kf for…

A: Given that : The volume of the Ca2+ sample = 150.0 mL Molarity of the Ca2+ sample = 0.080 M Molarity…

Q: 9) Cr³+ reacts slowly with EDTA (Y4-) so it is usually analyzed using back-titration. A 100.0 mL…

A: CaCl2(aq) is a source of Ca2+(aq) that reacts with EDTA(Y4-).  The balanced equations for the…

Q: The Kjedahl procedure was used to analyze 256 µL of a solution containing 37.9 mg protein/mL. The…

A: NH3 +  HCl = NH4Cl HCl + NaOH = H2O  +   NaCl Here, one mole of NH3 reacts with one of  HCl and also…

Q: What is the concentration of SCN" in a solution prepared by adding 5.0 mL of 0.0020M SCN" to a test…

A:

Q: A 0.1093-g sample of impure Na2CO3 was analyzed by the Volhard method. After adding 50.00 mL of…

A:

Q: Which of the following scenario will lead into LOSS of yield? a. Use of a filter paper with a…

A: 1) b) Addition of excess H2SO4 2) c) Potassium hydroxide 3) a) Add acid to revert the color back to…

Q: A 5.00 mL tap water sample was measured out with a volumetric pipette, and added to a 25 mL…

A: Given : volume Na2EDTA.2H2O used = 0.635 mL Concentration of Na2EDTA.2H2O = 0.0100 M And volume of…

Q: A hydrated sample weighing 0.2700 g was shaken with 50.0 mL of anhydrous methanol and titrated with…

A: Solution- Data given-A hydrated sample weighing 0.2700 g, 50.0 mL of anhydrous methanol , 0.0150 M…

Q: A 0.3045 g of CaCO3 primary standard was dissolved using concentrated HCl, evaporated to incipient…

A:

Q: Q2- A 30.0 mL H2C2O4 acidified solution, was treated with 25.0 mL of 0.102 M KMNO4 solution. The…

A:

Q: A 50.00-mL aliquot of solution containing 0.395 of MgSO4 (FM 120.37) in 0.500 L required 39.55 mL of…

A:

Q: Which of the following experiments can be described as a displacement titration?   A.  Calcium in…

A: A displacement titration is a one that involves an analyte displacing a reagent, by forming a…

Q: A 120.0 mL sample of 0.040 M Ca²+ is titrated with 0.040 M EDTA at pH 9.00. The value of log Kf for…

A: COMPEXOMETRIC TITRATION Complexometric titration reactions are those reactions in which coloured…

Q: 8. Magnesium oxide is not very soluble in water, and is dif tult to titrate directly. I ts purity…

A: Reaction with water: Aluminum oxide is insoluble in water and does not react like sodium oxide and…

Q: For the titration of 20.0 mL of 0.0100 M EDTA with 50.0 mL of 0.0200 M MNPO4 at pH = 10.00,…

A: The given information is: Volume of EDTA = 20.0ml Molarity of EDTA= 0.010 M Volume of MnPO4 = 50.0ml…

Q: The Tl in a 9.76-g sample of rodenticide was oxidized to the trivalent state and treated with an…

A: In the reaction, all of the 1 Tl3+(aq) is converted to 1 TlY-(aq) and 1 Mg2+(aq). Hence the moles of…

Q: A 25 ml solution of unkown containing Fe+3 and Ca+2 required 16.06 ml of 0.051 M EDTA for complete…

A: Back titration is a process where the unknown concentration of an analyte is determined by reacting…

Q: A 25.00-mL sample containing Fe31 was treated with 10.00 mL of 0.036 7 M EDTA to complex all the…

A: Given data,Volume of sample=25.0mL=0.025LTotal EDTA added=10.0mL=0.010LMolarity fo…

Q: A sensitive method for 12 in the presence of Cl₂ and Br₂ entails oxidation of the 12 to 103 with…

A: Given,  mass of sample = 1.307 g Volume of thiosulfate = 19.72 mL Concentration of thiosulfate =…

Q: 10 mL of an aqueous solution containing 1 mM Fe(NO3)2 was mixed with 20 ml. of another another…

A: Calculation of no. of moles of ''phen'' M = nVml×10000.3 = n20 ×1000n = 6 ×10-3 Calculation of no.…

Q: 1. The thiourea in a 1.455 g sample of an organic material was extracted into a dilute H2SO,…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A cyanide solution with a volume of 12.99 ml was treated with 30.00 mL. of Ni solution (containing…

A:

Q: The distribution constant, Kp, for compound A between toluene and water is 9.65. What is the…

A:

Q: An acidified and reduced iron sample required 40.2 ml of 0.0206 M KMN04. Find mg Fe (at wt =…

A: Reaction occurred is 8H+  +  5 Fe2+  + MnO4-  ----------------> 5 Fe3+  + Mn2+  + 4 H2O Volume Of…

Q: Chromel is an alloy composed of nickel, iron, and chromium. A 0.6392-g sample was dissolved and…

A:

Q: A foot powder sample containing Zn was dissolved on 50.00 ml water and was titrated to the end point…

A:

Q: A 100.0 mL sample containing Zn2* was treated with 50.0 mL of 0.0500 M EDTA to complex all the Zn2+…

A: The given titration involves the following reactiion: H2Y2-              +                     Zn2+…

Q: A 25.00-mL sample containing Fe3+ was treated with 10.00 mL of 0.036 7 M EDTA to complex all the…

A: In the question Following information given - Volume of Fe3+ Solution = 25 mL Volume of EDTA = 10 mL…

Q: Excess solid Ni(OH)2 was added to water and the resulting solution was allowed to stand for several…

A: In order to find Ksp, we need dissociation equation of Ni(OH)2(s) and equation for reaction with…

Q: 5. 0.1500 g sample of chromium ore was dissolved and the chromium oxidized to chromate ion. The…

A: Answer: This question is based on the stoichiometric calculation where we have to convert the number…

Q: An accurately weighed chelometric standard calcium carbonate of 200 mg was used to standardize…

A: Given, mass of calcium carbonate, M1 = 200×10-3 g molarity of Disodium EDTA = 0.054 M

Q: A foot powder sample containing Zn was dissolved on 200.00 mL water and was titrated to the end…

A:

Q: Precipitation of Ag+ with KOH a) Using the Ksp values provided in Table 2, predict whether it would…

A: Dissociation equilibrium of AgOH: AgOH(s)⇔Ag+(aq)+OH-(aq)

Q: A 5.00 mL tap water sample was measured out with a volumetric pipette, and added to a 25 mL…

A:

Q: *SHOW COMPLETE SOLUTION* A 4.971g sample containing the mineral tellurite was dissolved and then…

A: Solution - According to the question - Given - 3TeO2 + Cr2O72- + 8H+ ---> 3H2TeO4 + 2 Cr3+ + H2O…

Q: Calculate the Mg (OH) 2 content of MOM, 13.2 g of which was dissolved in 55.00 mL of 1.2642 N H2S04…

A: Mg(OH)2 is first reacted with H2SO4. The excess H2SO4 is then reacted with NaH.

Q: Q2- A 30.0 mL H2C2O4 acidified solution, was treated with 25.0 mL of 0.102 M KMNO4 solution. The…

A:

Q: Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. CuSO4 From the stock solution…

A: The amount of a substance that is present in a given volume of the solvent produces a solution. When…

Q: 0.7 g of impure form (sodium carbonate and bicarbonate or sodium carbonate and hydroxide) is…

A: Given: Mass of sample = 0.7 g Sample contains sodium carbonate i.e. Na2CO3 and Sodium bicarbonate…

Q: You are asked to titrate a Mn3+ solution with EDTA at pH 9.00. The overall ionic strength of the…

A: Solution- Log k = 25.2k =1025.2 nowαEDTA4−=5.4 ×10−2×1025.2   at pH=9(a)  k'(conditional formation…

Q: A 15.0 mL sample of 0.0100 M Cu²+ buffered at pH 9.00 is titrated with 0.0300 M EDTA. Calculate…

A: Given: Volume of Cu2+ = 15.00 mL Concentration of Cu2+ = 0.0100 M pH=9.00 To Calculate pCu2+ for…

Q: An unknown solution containing 25.00 mL of Ni2+ in dilute HCl is treated with a known excess of…

A: Given, Ni2+=25.0 mLEDTA= 25.0 mLConcentration of EDTA =0.05382 MZn2+=0.02299 MVolume= 17.0 mL