Answered: A 50 loss-less transmission line is…

A 50 loss-less transmission line is terminated in a load with impedance 2,- (30-160). The wavelenght is 5 cm. Find the magnitude of the reflection coefficient at the load. 01 0.20

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.35MCQ: The affect of the earth plane is to slightly increase the capacitance, and as the line height...

See similar textbooks

Related questions

Q: 14. If a rotating standard with a basic K, of +% whr per revolution is used on 120-volt and 15-amp…

Q: (b) A three-phase, star connected alternator is rated at 1500kVA, 11kV. The armature effective…

A: Introduction Three-phase alternators: A three-phase alternator is a type of electrical machine used…

Q: the mesh-current method to find the branch currents 11, 12, and 13 he circuit in figure (Figure 1)…

Q: Found Voltage to R1,R2,R3,R4

A: In this question We need to determine the voltage across the resistances. We are solving this…

Q: 2. Referring to Fig. 6, develop a formula that will give the voltage gain, V.V₁ in terms of F and…

Q: Optical fibre cables and coaxial cables do not function in the same way.

A: Introduction: Optical fiber cables are composed of tiny strands of glass or plastic that transfer…

Q: Determine the response of the continuous-time system with impulse response h(t)=4e-10u(t) for the…

A: For the given input we need to find the response of the given system.

Q: b) Figure Q4 shows a three-line network. The load currents and the fault levels at various locations…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In the network shown in Fig. 2.177 find the current that would flow if a 2-12 resistor was connected…

A: Given: A network, To find: The current that would flow if a 2Ω resistor was connected between…

Q: The figure shows a simplified circuit diagram for an automobile. The equivalent resistor R…

A: Given the circuit, R1=94 mΩR2 =41.0 mΩ

Q: termine the value of Ia in the circuit. 21. ΣΩ 4V Ia| {2 Ω ΙΩ ΔΑ

Q: A 2500 V, 50 Hz, 1000 hp 0.85 PF leading four poles Y-connected synchronous motor has a synchronous…

Q: V₁ 12v (+ V 12 ΚΩ www 9 ΚΩ V₂ 12 ΚΩ www 6 ΚΩ V3 1+ 6

A: answer: given that a linear circuit To find all the node voltage and branch currents nodal analysis…

Q: Q1) Find the equivalent resistance at terminals a-b for the following circuits: 00 - Μ 10 Ω 40 Ω Μ…

A: Introduction Equivalent Resistance: The equivalent resistance is the overall resistance that a…

Q: Section 6.4 Operational Amplifiers 6.30 Obtain the transfer function V₂ (s)/V/(s) for the op-amp…

A: Solution (6.30) - The op-amp system is shown below,

Q: looking at the similarities and differences between two transmission methods (twistted piars, coxial…

A: Introduction Transmission: Transmission is a fundamental concept in electronics, as it is essential…

Q: can i get Vc theorticly for both please.

Q: 4. For the circuit shown in Fig. 2.119 find the current in R = 852 resistance in the branch AB using…

Q: 15. A battery having an E.M.F. of 110 V and an internal resistance of 0.2 02 is connected in…

A: In this question We need to determine the current in the each batteries and total current. We are…

Q: Solve for the current flowing through the 8 resistor in the following figure. 2 Ω SV Μ Το Μ 4Ω isa 8…

Q: Bus A CB CT1 200A/1A IDMT Relay 1 Distribution line Bus B CT2 100A/1A IDMT Relay 2 Figure 04…

A: Given the , Pluge setting current = 1 A for both Relay 1 and 2. CB operating time =0.3 sec. TSM for…

Q: Question 41 Employ mesh analysis to obtain values for ix and va in the circuit of Fig. 4.66. ΖΩ Va…

A: In this question We need to determine the unknown current ix and voltage va as shown the circuit.…

Q: Perform the requested analyses: a. Solve for vout (t) if iin (t) = u(t), and vout (0) = 3V. iin(t) 2…

A: We use Laplace transform to solve these questions.

Q: For a linear time-invariant (LTI) system shown below, find the transient and forced response of…

Q: z-transforms of the following function 8³-1 e³s(s+1) Find the (a) E(s) = T = 0.2 s

A: Given: A transfer function, E(s)=ε3-1ε3ss+1, T=0.2 s, To find: Z-transform of the above function.

Q: 8. If you increase the number of foci to improve your lateral resolution, what is the trade off you…

A: Trade off number:

Q: 13.57 The operational amplifier in the circuit in Fig. P13.57 is ideal. a) Find the numerical…

A: 13.57 ) Given an operational amplifier circuit To find the numerical expression for the transfer…

Q: 11. Apply the superposition theorem and find the current through 25 ohm resistance of the circuit…

Q: Three identically shaped segments of different materials have a voltage of 120 mV applied between…

Q: for the R-th part. isn't R3 and R5 in series not parrallel? If not, explain why. If so, fix the…

A: It is given that:

Q: (b) For the circuit in Figure 3.2, convert the current source shown to a voltage source. (1) (ii) I…

A: Dear,as per company guidelines we can answer only one question at a time, kindly post other…

Q: (a) Refer to Figure 3.1. (1) Calculate the Thevenin resistance and voltage external to the load…

Q: 50V 10 www in ww 20 w 15 15 Mo 30 ww Fig. 2.179 11. State and explain Thevenin's theorem. For the…

Q: A star-connected 440V, 50Hz alternators has per phase synchronous reactance of 100. It supplies a…

A: given data:

Q: 12. With R3 fully CW for minimum resistance in the circuit of Figure 2-14, what value of gate…

A: Given the circuit

Q: (d) IL (e) PIV of the diodes (f) fout

Q: (a) Refer to the circuit shown in Figure 4.1. (1) Calculate its Thevenin resistance and voltage…

A: Introduction: Nodal analysis is a method used in electrical circuit analysis to analyze the behavior…

Q: 4 Convolution Determine, analytically, the convolution y(t) = x(t) * h(t), where 1, 0 < t < 1, 0,…

Q: A 3 , 4 pole induction motor is operated from 415v/50Hz supply. Stator voltage control is employed…

Q: 3) Two half-wave dipole antennas, each with impedance of 750, are connected in parallel through a…

A: Given the two half wave dipole antenna with impedance = 75 ohm Pair of T.L characteristic impedance…

Q: 2. Find the current through the 3 2 resistance connected between C and D Fig. 2.117. [1 A from C to…

Q: An op-amp has an open-loop gain of 105 and an open-loop upper cutoff frequency of 10 Hz. If this op-…

A: Given: An operational amplifier with: Open loop gain, Aol=105 Closed loop gain, Acl=100 Upper cutoff…

Q: 1. Given x(t) and h(t), find y(t) = x(t) * h(t) x(t) = 2u(t)- 2u(t-1) h(t) = 3u(t)- 3u(t - 2) * u(t)…

Q: Question 4. In the circuit below I is a DC current, and v, is a sinusoidal signal. Given the diode…

Q: Problem 3.6. Use nodal analysis to determine the node voltages, along with the voltage V₁1 and…

A: The required parameters can be calculated by using the node voltage and the node voltage can be…

Q: 4. In a balance 3-phase system, the load is wye-connected and one of the values given is 10230 2. If…

Q: Find the currem in the 15 £2 resistor

Q: If x(t) is a continuous signal whose Fourier transform is X (w), then energy of the signal is -10 -5…

A: Given- A continuous signal: To find- The energy of the signal.

Q: 24. In Fig. 2.256 derive the expressions to replace a delta connected resistances by an equivalent…

Q: OAP 3 (a) Design a circuit that provides a gain of +10 V/V for an input signal vs. Use 100 kn as the…

Question

A 50 loss-less transmission line is terminated in a load with impedance 2,= (30-160). The
wavelenght is 5 cm. Find the magnitude of the reflection coefficient at the load.
01
0 0.20
00
08

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 502 transmission line is terminated with a 502 resistor on series with a 2 * 10 7H inductor. If the frequency of the operation is 60 * 10° MHz find the reflection coefficient at the load. Select one: O a. 0 O b. 0.45e22 O c. 1 O d. 0.36e56 O e. 0.6e-37
In the figure, a traveling voltage wave of 500 kV proceeds towards point A. Calculate the voltages and currents in the branches after the first reflection and transmission at point A.
c) For a transmission line w/characteristic impedance Z0 = 50 W. At some point of the line, a forward wave has the voltage V+ = 10V and backward wave has the voltage V- = 4V. i) Currents of the forward wave and backward wave at that point. ii) Measured voltage and current at that point. d) A transmission line has the following properties: Length, L = 3 m. Characteristic impedance Z0 = 50 W. The load impedance ZL = 100 W. And phase constant b = p/3. Assume the forward voltage at z = 0 is VA =10ejp/4 At z = 3m, calculate: i) Forward voltage and forward current. ii) Backward voltage and backward current. iii) Measured (total) voltage and current across the load
Give example problems for impedances and admittance.
The 50 ohm transmission line isterminated with an unknown load. The magnitude of the reflection coefficient is R=0.5.Thedistancebetween the voltage maximum and the load is0.15 lambda. What is the imaginary partof the load impedance?
Each phase of a transmission line is a bundle of 4 conductors that form a square with all sides equal to d=33 cm. Each conductor is stranded and has GMR = 0.5 cm. Find GMR of the bundle to be used in inductance calculations. Express your answer in cm with 2 digits after decimal point
Discuss the methods used to minimize inductance in transmission lines and their effects on signal transmission.
A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of position appears as shown below. From this plot, the phase constant B= Voltage 25 20 15 10 -10 -15 -20 -25 10 20 30 40 50 60 70 80 90 100 Meters 0.562 0.314 0.625 0.489
6-A lossless T.L. has Zo = 100 N and is loaded by an unknown impedance Its VSWR is 4 and the first voltage maximum is A/8 from the load . Find the load impedance .
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
please model a transmission line pair with an equivalent circuit model. establish the transmission equations using Kirchhoff's current law and voltage law. solve the equivalent circuit model equations to get wave equation.
2. The reflection coefficient of a load is FL=0.8. Determine: (a) VSWR