A 6-cm-diameter horizontal water pipe expands gradually to a 9-cm-diameter pipe. The walls of the expansion section are angled 30° from the horizontal. The average velocity and pressure of water before the expansion section are 7 m/s and 150 Ka, respectively. Determine the head loss (m) in the expansion section. 6 cm 9 cm Water 7 m/s 150 kPa Gradual Expansion and Contraction (based on the velocity in the smaller-diameter pipe) Expansion: K = 0.02 for 0 = 20° K = 0.04 for 0 = 45° K = 0.07 for 0 = 60° Contraction (for 0 = 20°): K = 0.30 for d/D = 0.2 K = 0.25 for dlD = 0.4 K, = 0.15 for diD = 0.6 K = 0.10 for dlD = 0.8 %3D -v d d %3D

A 6-cm-diameter horizontal water pipe expands gradually to a 9-cm-diameter pipe. The walls of the expansion section are angled 30° from the horizontal. The average velocity and pressure of water before the expansion section are 7 m/s and 150 Ka, respectively. Determine the head loss (m) in the expansion section. 6 cm 9 cm Water 7 m/s 150 kPa Gradual Expansion and Contraction (based on the velocity in the smaller-diameter pipe) Expansion: K = 0.02 for 0 = 20° K = 0.04 for 0 = 45° K = 0.07 for 0 = 60° Contraction (for 0 = 20°): K = 0.30 for d/D = 0.2 K = 0.25 for dlD = 0.4 K, = 0.15 for diD = 0.6 K = 0.10 for dlD = 0.8 %3D -v d d %3D

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water flows in a 15-cm-diameter pipe at a velocity of 1.8 m/s. If the head loss along the pipe is estimated to be 19 m, the required pumping power (in kW) to overcome this head loss is ?"
A fluid flows at 455 cubic meters per minute inside a rectangular duct, whose cross-section has a length of 150 cm and width of 85 cm. Determine the average velocity of the flow in m/s.
Water at 20°C is flowing through a horizontal nozzle at a flow rate of 0.005 m3/s. At the nozzle inlet, the diameter is 5 cm and the pressure is 200 kPag. The nozzle discharges freely to outside air. Determine the velocity of the water (in m/s) as it exits the nozzle. Assume negligible head losses through the nozzle. Round your answer to 2 decimal places.
A closed vessel contains water up to a height of 2 m and over the water surface there is air having pressure 8.829 N/cm^2 above atmospher. At the bottom of the vessel there is an orifice of diameter of 15 cm. Find the rate of flow of water from orifice. Take Cd=0.60. 125.75 L/s 135.75 L/s 115.75 L/s 155.75 L/s
A closed vessel contains water up to a height of 2 m and over the water surface there is air having pressure 8.829 N/cm^2 above atmospher. At the bottom of the vessel there is an orifice of diameter of 15 cm. Find the rate of flow of water from orifice. Take Cd=0.60. answer (155.75 L/s)
The tank below is cylindrical and has a vertical axis. Its horizontal cross-sectional area is 10 m2. The tank has a layer of water under a layer of gasoline (S.G= 0.72). Three holes were drilled in the tank, one at the bottom of the tank, the second hole is in the water layer, 2 m from the bottom. The third hole was drilled 1S 11 in the gasoline layer 5 m from the bottom. The initial discharge velocities from the bottom and the third holes were also recorded as shown in the table below.
Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the pipe with diameters 10 cm and 7 cm and the two sections are connected by a smooth reducing section as shown in the schematic. We use a manometer with glycerin as the manometer fluid (with glycerin density of Pglycerin 1,260 kg/m³) to measure the pressure difference between the two pipe sections. Assume that frictional effects are negligible and consider specific gravity of oil as SGoil = 0.76. What is the manometer reading, h (i.e. differential height of glycerin between the two arms of the manometer)? 10 cm I h 7 cm-
Water at 15 degrees Celsius is flowing through a 2-in ID smooth pipe. The friction loss for a 100-ft section of the pipe amounts to 4.8 lbf/lbm. Determine the velocity of the flow.
4m A 4-meter-diameter cylindrical tank contains oil and water as shown in the figure. At the bottom of the tank is an orifice having a diameter of 0.1 meter with coefficient of contraction and coefficient of velocity equal to 0.62 and 0.98, respectively. Determine the following: 6m Oil, SG = 0.9 a. The rate of flow on the orifice (L/s). b. The time to remove water only at the tank (s). c. The time to drain all the liquids (s). 4m Water
The air velocity in the duct of a heating system is to be measured by a Pitot-static probe inserted into the duct parallel to flow. If the differential height between the water columns connected to the two outlets of the probe is 2.4 cm, determine the flow velocity at the center of the duct in m/s. R of air is 287 J/Kg-K.
A 6-cm-diameter horizontal water pipe expands gradually to a 9-cm-diameter pipe. The walls of the expansion section are angled 10° from the axis. The average velocity and pressure of water before the expansion section are 7 m/s and 150 kPa, respectively. Determine the head loss in the expansion section and the pressure in the larger-diameter pipe.
The water flowing through a pipe having a diameter 300 mm and 200 mm at the bottom and upper end respectively. The intensity of pressure at the bottom end is 24.525 x 104 N/m2 and the pressure at the upper end is 9.81 x 104 N/m2. Determine the difference in datum head if the rate of flow through pipe is 40 liters/s. Answer: z2z1 = 13.70 m