Answered: A) calculate the magnitude of the…

A) calculate the magnitude of the voltage across the 24 ohm resistor B) calculate the magnitude of the current through the 8 ohm resistor.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter2: Basic Electricity

Section: Chapter Questions

Problem 30RQ: True or False: Ohms law applies to all types of electrical circuits.

See similar textbooks

Related questions

Q: Two batteries, 10.5 volts with internal resistance of 1.5 ohm and 9 volts with internal resistance…

Q: Q4) Find the value of (Ix) for this circuit and power supply by (21x) volt and 42.

A: Given:-

Q: Four identical dry cells with an emf of 1.4 volts and internal resistance of 0.06 ohm each, are…

Q: 13. Refer to the graphic D. What is the resistance seen by the power supply?

A: The given circuit is shown below:

Q: A transmission line is being built to bring power to a remote community, which is 40 miles from the…

A: We need to find the sending end line voltage of the system. The solution is provided in the next…

Q: A 12 ampere electric fan and blower with a power factor of 0.90 was connected to 240 volts…

A: The question is about circuit current and power in the circuit.

Q: Question 1 In the given circuit, if Vdb is 12 volts, what is the value of E in volts? 82 多309 多122…

A: We will apply KVL in outer loop to find battery voltage Vcd. Now we will find current in 30 ohms…

Q: what is the computed load for an electric range with a nameplate rating of 12kW

A: => Article 220 (Table 220.55) NEC mentioned the loads and demand factor for various household…

Q: Determine the amount of each current for the followingnetworks:

A: Calculate equivalent resistance,

Q: What is the minimum size generator (in Watts) that would be capable of running a refrigerator, large…

A: There are various appliances is available in the market of their different-different rating. And…

Q: Loads A, B, and C are connected in series. Given the following measurements; load A consumes 50…

A: Given 3 resistors are connected in series and named as Ra, Rb, Rc Power of Ra is 50 watts Current…

Q: What is the voltage drop across the 5 ohm resistance in the given circuit below? 20 12 v(+ 10 (A)…

A: Given The circuit find the average drop across 5 ohm

Q: If the length of the conductor is increasing ,then the resistance will

A: We know that Resistance R=ρlAρ- resistivityl= length of conductorA= Area of conductor

Q: The voltage supplied to a water heater was reduces to 75%.The power consumed by the heater will be…

Q: Calculate the current flowing through the 15 kOhm resistor and the power drawn through the 4.7 kOhm…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

Q: 5. Disconnect the DC power supply, and then measured the equivalent resistance by using the AVO…

A: As you have not posted the question with a circuit diagram for which I am Considering the following…

Q: building load consists of fifty 60 – watt, twenty 90 – watt and fifteen 55 – watt incandescent lamps…

A: Given Load consists of Fifty 60 watt lamps twenty 90 watt lamps fifteen 55 watt lamps The load…

Q: What type of measurement is being performed in the image provided? 12.57 v Voltage drop across the…

A: When we need to measure the voltage across any device or load we need to place multimeter across the…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

A: Voltage across all resistor is same so all resistors are in parallel. Current=Voltage across…

Q: 1. Determine the maximum voltage that can be applied across the series combination of a 150 ohm, 2…

A: Given, Series combination of 150 ohms and 100 ohms with respective watts of 2 and 1 watts. Please…

Q: If the current in the 6-ohm resistor is 18 amperes, determine the voltage E and the following…

Q: a 1.5 volt cell delivers 600 mA to a residtive load. if the internal resistance is 0.09 ohms, what…

A: The solution can be achieved as follows.

Q: 3. A 3phase 4 wire system is used for lighting. Compare the amount of copper required with that…

A: Let Pl2 be the power loss in the two-wire DC system. V be the voltage between the lines, R1 be the…

Q: What is the total applied voltage in a circuit if the voltage drop across three loads connected in…

A: VOTAGE: To move the electron in a particular direction requires some work or energy transfer. This…

Q: 1. There are 8 identical cells with same generated voltage E of 1.5 volts and common current…

A: 1) we know, voltage souces are in series, then their voltage is adding And current is same for…

Q: 17. A 5000-ohm 20-W resistor and a 1000-ohm 5-W resistor are in series. What is the maximum voltage…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

A: All elements are in parallel and voltage across theme is same so total resistance is equal to…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

Q: Calculate the current in the 2-ohm resistor of the network shown below.

A: The solution can be achieved as follows.

Q: What is the voltage drop across the 5 ohm resistance in the given circuit below? 20 40 12 V 10 (A)…

Q: An ammeter is connected to the circuit (see the figure) for measuring the current passing through…

A: Error =measured value - True valueTrue value True value of Current = current without meter IT…

Q: Ib $402 130V 120V

Q: 2. Given the cireuit below with 3A of current running through the 40 resistor an indicated in the…

Q: 2. In Figure, the battery voltage is V= 65 volts, and the values of the resistances, in ohms, are…

Q: 14. The voltage that is applied to a load is equal to

Q: What is the current through an 8-ohm toaster when it is operating in 120V? *

Q: Two lamps 40 watt 230 volt and 60 watt 230 volt are connected to 230 volt a.c. If the supply is…

Q: I (a) Calculate the total resistance between terminals A and B. (b) Calculate the voltage at point…

A: The required parameters can be calculated by using the ohms law and voltage divider rule.

Q: Which one of the following is the main Function of wind vane in a Wind energy conversion system? a.…

A: Wind vanes are used in wind plants so that by measuring wind direction more power can be obtained.

Q: Determine the amount of each current for the followingnetworks:

A: Find equivalent resistance: Req=4+2||2Req=4+1Req=5 Ω

Q: 2. In Figure, the battery voltage is V= 65 volts, and the values of the resistances, in ohms, are…

A: 3 Branch are in parallel. Find the equivalent resistance R ? Current in ammeter branch?

Q: In the circuit, determine ix, iy, and the power dissipated (absorbed) by the 3Ω resistor

Q: Find out the current flowing through 1k ohms resistor using Nodal method.

Q: Using 3 band color coding method, evaluate the following resistor: Color bands: Red Brown Yellow

A: For a 3 band color coded resistor, the color codes of the three bands are given as 1st Band: Red 2nd…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

Q: Calculate The power dissipated in the 6 ohm resistor, in watts

A: In this question, Calculate The power dissipated in the 6 ohm resistor, in watts. Power P= I2 R

Q: What is the voltage drop across the 5 ohm resistance in the given circuit below? 20 40 12 V 50 10…

A: Option A. 2.86 volts Using KCL will give results fast and easy

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

A) calculate the magnitude of the voltage across the 24 ohm resistor

B) calculate the magnitude of the current through the 8 ohm resistor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

PLEASE SHOW COMPLETE SOLUTIONA. What is the current in the 20-ohm resistor? B. What is the voltage drop accross the 16-ohm resistor? C. What is the power rating of the 8-ohm resistor?
Calculate the current and voltage values for the circuit components from the Kirchhoff's Current Law (KCL) and Kirchhoff's Voltage Law (KVL).
What is the relationship between the Arc Resistance and the Area of the Cross-Section of the Arc? A. Inversely Proportional B. Does not affect each other C. Proportional D. Equal
Which of the following statements is false? O The current in a series de circuit is divided up among the resistances. O In a series dc circuit, the sum of voltages across all the components, going once around a complete circle, is zero. O In a parallel dc circuit, the voltage is the same across each components O The total power consumed in a series circuit is the sum of the wattages consumed by each of the components.
three type of electric device A, B, and C are connected in series across a 115 volt AC source, and the voltage drops across the individual units are equal. if EB leads EA by 90 elec deg and EC lags behind EA by 90 elec deg, what are the emfs across A, B. and C? 1 KB
Assigning R3 as the load, find the following: R₁ 4 Ω VS1 = 28V R₂ 2Ω C R₂ (Load) 102 7V VS2 THEVENIN'S EQUIVALENT CIRCUIT (TEC) RTH + VTH R3 (Load)
How does the magnitude of the voltage across the power supply compare to the voltage across the bulb with the switch open? How do they compare with the switch closed?
two-24 volt battery supply power to a 10 ohm load. one battery has 0.2 ohm internal resistance while the other has 0.4 ohm. what is the load voltage? a. 23.84 v b. 24 v c. 23.68 v d. 23.24 v
Question: A battery is charged from a constant dc source of 220 V through a chopper. The dc battery is to be charged from its internal emf of 90 V to 122 v. The battery has an internal resistance of 1 ohm for a constant charging current of 10 A. What is the range of duty сycle? Option 1: 0.55 to 0.7 Option 2: 0.2 to 0.4 Option 3: 0.45 to 0.6 Option 4: 0.3 to 0.5
7- when the temperature of PV module increases a- The short circuit current and open circuit voltage increase. b- The short circuit current and open circuit voltage decrease. c- The short circuit current increases and open circuit volage decreases. d- The short circuit current decreases and open circuit voltage increases
In electrodynamometer type wattmeter, to.............. in moving coil, a high resistance R is connected in series with it.
What is the greatest voltage that can be applied across a -W, 2.7-MQ resistor without causing it to overheat?