A car battery has gone dead and it needs to be replaced with a large capacitor. The old car battery is 12 volts and has a charge capacity of l144000 Coulombs. What should the capacitance of the capacitor be so that a 12-volt difference across the plates will result in the same energy as the battery? O A) 24000 Farads O B) 29100 Farads O C) 31400 Farads D) 23600 Farads O E) 27600 Farads

A car battery has gone dead and it needs to be replaced with a large capacitor. The old car battery is 12 volts and has a charge capacity of l144000 Coulombs. What should the capacitance of the capacitor be so that a 12-volt difference across the plates will result in the same energy as the battery? O A) 24000 Farads O B) 29100 Farads O C) 31400 Farads D) 23600 Farads O E) 27600 Farads

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
How many valence electrons are generally contained in materials used for insulators?
A capacitor of 1µF is charged to 100 volts and then disconnected from the power supply. A second but uncharged capacitor of 3µF is then connected across the first capacitor. What is the voltage across the parallel combination? O a. 110 volts O b. 45 volts O c. 66 volts O d. 25 volts
Calculate t for capacitors in parallel and series for charging and discharging
How does the internal resistance of the multimeter (in voltage setting) affect the charging/discharging rate of the capacitor. Explain.
1. 1-5 K 30v a. what is tue T CTime constant) ? b. How long will it take for the capacutor TO rtach s0% op charge? C. What is tne voltage of capa citor apter 1 seconds? d. How many tíme constants will it take for the soltage to reach 23 v? C. Gweng that the capacitor is fully changed, how will it take por it to be 20% ? long 120v + BF what is the. T ? b. what is the voltage capacitor apter 10 sec? a. C. How many time constants will it take for Tue Vo Itage to reach 80 v.? d. Given that the capaator is Fully charged, how time constants will it be to reau many GOV!
Please solve this question in electric circuits
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
8. Liquids with solid impurities a) Have higher dielectric strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average de voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
17/ The charge across each capacitance when connected in a parallel connected capacitive circuit is ___________________. a. Same charges are observed across each capacitance b. Either same or different charges are observed across each capacitance c. None of the given option d. Different charges are observed across each capacitance
QUESTION 11 The voltage signal coming out of the capacitor is with small ripples compare to the voltage signal out of the diode. O True O False
What is the voltage across the plates of capacitor #1 (C1)? Select one: a. 6.36 volts b. 2.71 volts c. 5.65 volts d. 7.32 volts