A charged capacitor is connected to a resistor and a switch as in the figure below. The circuit has a time constant of 1.30 s. Soon after the switch is closed, the charge on the capacitor is 69.0% of its initial charg R- (a) Find the time interval required for the capacitor to reach this charge. (b) If R = 220 kn, what is the value of C?

A charged capacitor is connected to a resistor and a switch as in the figure below. The circuit has a time constant of 1.30 s. Soon after the switch is closed, the charge on the capacitor is 69.0% of its initial charg R- (a) Find the time interval required for the capacitor to reach this charge. (b) If R = 220 kn, what is the value of C?

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter26: Current And Resistance

Section: Chapter Questions

Problem 37AP: A charge Q is placed on a capacitor of capacitance C. The capacitor is connected into the circuit...

See similar textbooks

Similar questions

The circuit in Figure P21.59 has been connected for a long time. (a) What is the potential difference across the capacitor? (b) If the battery is disconnected from the circuit, over what time interval does the capacitor discharge to one-tenth its initial voltage?
A charge Q is placed on a capacitor of capacitance C. The capacitor is connected into the circuit shown in Figure P26.37, with an open switch, a resistor, and an initially uncharged capacitor of capacitance 3C. The switch is then closed, and the circuit comes to equilibrium. In terms of Q and C, find (a) the final potential difference between the plates of each capacitor, (b) the charge on each capacitor, and (c) the final energy stored in each capacitor. (d) Find the internal energy appearing in the resistor. Figure P26.37
A Pairs of parallel wires or coaxial cables are two conductors separated by an insulator, so they have a capacitance. For a given cable, the capacitance is independent of the length if the cable is very long. A typical circuit model of a cable is shown in Figure P27.87. It is called a lumped-parameter model and represents how a unit length of the cable behaves. Find the equivalent capacitance of a. one unit length (Fig. P27.87A), b. two unit lengths (Fig. P27.87B), and c. an infinite number of unit lengths (Fig. P27.87C). Hint: For the infinite number of units, adding one more unit at the beginning does not change the equivalent capacitance.
A pair of capacitors with capacitances CA = 3.70 F and CB = 6.40 F are connected in a network. What is the equivalent capacitance of the pair of capacitors if they are connected a. in parallel and b. in series?
(a) What is the average power output of a heart defibrillator that dissipates 400 J of energy in 10.0 ms? (b) Considering the high-power output, why doesn’t the defibrillator produce serious bums?
A capacitor with initial charge Q0 is connected across a resistor R at time t = 0. The separation between the plates of the capacitor changes as d = d0/(1 + t) for 0 t 1 s. Find an expression for the voltage drop across the capacitor as a function of time.
The circuit in Figure P27.85 shows four capacitors connected to a battery. The switch S is initially open, and all capacitors have reached their final charge. The capacitances are C1 = 6.00 F, C2 = 12.00 F, C3 = 8.00 F, and C4 = 4.00 F. a. Find the potential difference across each capacitor and the charge stored in each. b. The switch is now closed. What is the new final potential difference across each capacitor and the new charge stored in each? Figure P27.85
Three capacitors with capacitances C1 = C, C2 = 3C, and C3 = 5C, are in a circuit as shown. The source has potential difference ΔV = 17 V. It is observed that one plate of the capacitor C3 has a charge of q = 5 mC. Write an expression for the capacitance C (that is, the capacitance of the first capacitor), in terms of q and ΔV.
The circuit in the drawing contains two resistors and two capacitors that are connected to a battery via a switch. When the switch is closed, the capacitors begin to charge up. What is the time constant for the charging process?
Three capacitors with capacitances C1 = C, C2 = 3C, and C3 = 5C, are in a circuit as shown. The source has potential difference ΔV = 14 V. It is observed that one plate of the capacitor C3 has a charge of q = 12 mC Part (a) What is the charge on the other plate of the capacitor C3, in coulombs? Part (b) Write an expression for the capacitance C (that is, the capacitance of the first capacitor), in terms of q and ΔV. Part (c) What is this capacitance, in farads?
Consider the circuit shown in (Figure 1). Assume E = 15 V. a)What is the charge on 3.0 μFcapacitor? Express your answer with the appropriate units. b)What is the charge on 4.0 μF capacitor? Express your answer with the appropriate units. c)What is the charge on 6.0 μF capacitor? Express your answer with the appropriate units.
Consider the circuit shown in the figure below. The four capacitors have capacitances C1=19µF, C2=12µF, C3=10µF, C4=12µF and are connected to a battery of voltage V=28Volts. When all capacitors are fully charged, determine the voltage across C2. Express your answer in units of Volts using one decimal place. C2 C3 C1 C4 V