A coil of 50-ohm resistance and of 150-mH inductance is connected in parallel with a 50-µF capacitor. The source voltage is 100 sin (377t +30°). What is the equation of the line current?

Q: 4 Find the F. T. of the following Signals using differentiation prop. X(t) = 2 S (+2) -2 S(t-2)…

A:

Q: A 4-pole generator has a lap-wound armature with 60 slots with 15 conductors per slot. The useful…

A: Given, In a dc generator, Number of poles, P=4 Lap wound so number of parallel path, A=P=4. Slots is…

Q: a. provide smoother output c. convert the AC to DC 8. The voltage applied across the motor armature…

A:

Q: Q5/ A: Draw the block diagram of Pulse Code Modulation (PCM), and what is the disadvantage of it? B:…

A: here we have to draw the block diagrams of pcm and dm.

Q: Determine the value of Voltage V2. 6Ω ww 1.3 A 12 V +1 www + 1 www V₂

A: Given circuit,

Q: Ideal voltage source should have • zero internal resistance O • infinite internal resistance O •…

A:

Q: A 500 : 25, current transformer is used along with an ammeter. If ammeter reading is 5.6 A, estimate…

A: We have an current transformer which is used along with an ammeter means ammeter is connected in…

Q: 9. In cases where huge starting torque is required for accelerating heavy loads, preferred. a.…

A:

Q: Calculate the resistance of 100 m length of a wire having a uniform cross-sectional area of 0.1 mm²…

A:

Q: Calculate the junction capacitance of a silicon pn junction at T = 300 K with doping concentrations…

A:

Q: The diagram shows a simple electric circuit consisting of a power source, a resistor, and an…

A: Given parameters: Voltage supply, E = 24 V Resistor, R = 12 ohm Inductor, L = 4 H And first order…

Q: The impedance of a 50+j100 ohm impedance connected in parallel with a 25 ohm impedance is: O 75+j100…

A: Given, Two impedances are connected in parallel. Z1=50+j100 Ω.Z2=25 Ω.

Q: 23. Determine stability of the following systems. Check for BIBO, symptotic and integral stability.…

A:

Q: In an electrodynamometer instrument the total resistance of the voltage coil circuit is 8 ko and the…

A: Given- Electrodynamometer instrument- Total resistance =8 Ω, mutual inductance changes from- -150 μH…

Q: 12. In FIGURE 7.2.9, two vertices are shown of a rectangular paral- lelepiped having sides parallel…

A:

Q: Q2) Using nodal analysis, find I, in the circuit of Fig. 25 ΤΩ Io 8 Ω 4A ΖΩ Figure 2 210 ww 4Ω -].

A:

Q: A single-phase 111-V, 50-Hz supply is connected to a coil with 200 turns of a coil-core assembly as…

A: Given, Single phase transformer. Single phase supply voltage, e=111 V. Frequency, f=50 Hz. Number…

Q: 1. A supemode is situated between... a) Two essential nodes b) Two reference nodes c) Essential node…

A: Q) 1) A supernode is a concept that can be utilized to solve a circuit in circuit theory.  This is…

Q: Calculate the current flowing in the 5 2 resistor for the network shown below using Thevenin's…

A: Given data: A network of resistors and a DC battery. Resistors in the network, 1 ohm, 2 ohms, 7…

Q: An ideal transformer with a turns ratio of 2:7 is fed from a 240 V supply. Determine its output…

A:

Q: 12- A DVM measure....... a- peak value. b- RMS value. 1 21 Average value. d- peak to peak value.…

A: DVM (Digital Voltmeter):- The unknown input voltage is converted to a digital value using a digital…

Q: Consider the total harmonic distortion of a closed loop system is 5%. Distortion without feedback is…

A:

Q: In the circuit shown in Figure 10.27, find the transfer function H(w) = Vo/Vin 1/(jwC) HH in O +…

A:

Q: Ql/prove that : 72=00 H(el) = Σ 71118 h(n)e-jwn

A: Here the properties of fourier transform is used to solve it.

Q: 4. A PMOS transistor has kp'(W/L) = 80uA/V², V₁ = -1.5V, and 2 = -0.02V¹. The gate is connected to…

A: Kp=80μA/v2,Vt=-1.5v,VGs=5v,λ=-0.02v-1,ID=? For: VD=4V, 1.5V, 0V, -5V.Here ID is given…

Q: In the circuit shown in Figure 10.18, find the mesh current I₂. Zc R₁ 56 20° V Figure 10.18 a. 12 =…

A: This is a problem of circuit. The calculation is shown in the next step

Q: Why do we need to have an Exciter in a complete set-up of an Alternator system operations? Explain…

A: A device known as an exciter or a DC generator relay induces the DC machine-held excitation to…

Q: In a 110-V compound generator, the resistances of the armature, shunt and the series windings are…

A: Given that Compound generator Terminal voltage Vt=110 V Ra=0.06 ohm RSh=25 ohm RSe=0.04 ohm Load:…

Q: Draw a block diagram of a simple amplitude modulation. Explain briefly how amplitude modulation is…

A: Amplitude modulation:- In amplitude modulation carrier wave is varied according to the message…

Q: A battery of unknown e.m.f. is connected across resistances as shown in Fig. 2.26. The voltage drop…

A: We have a circuit as shown in figure .   We have been asked to find the reading of the ammeter means…

Q: Q6. Determine the total amount of power in the series circuit in Fig. 592 50 V 292 I + I 192 292

A: Given data, Circuit diagram is given as,

Q: USEFUL FORMULA 44 AVE

A: FIND: Forward resistance of given graph

Q: Q5: An output pulse of 3 ms duration is to be generated by a 741S122 one-shot. Using a capacitor of…

A:

Q: 13 The study of energy distribution across the frequency spectrum of a given electrical signal is…

A: In this question we need to choose a correct option.

Q: Q5: An output pulse of 3 ms duration is to be generated by a 74LS122 one-shot. Using a capacitor of…

A: Given data Pulse width = 3 msec Capacitor =50000 pF we have to find external resistance value = Rext…

Q: 404. If the output power of a transformer is 600 W whereas the losses are 200 W, the efficiency of…

A: Given: Output power of transformer, Po=600 W. Losses = 200 W.

Q: Let R₁ = 25 2, R₂ = 75 2, L = 69 mH, C = 46 µF, and vs(t) = 155 cos(2 R₁ R₂ HI Figure 9.22 O a.…

A: GIVEN:  R1=25ΩR2=75ΩL=69mHC=46μF VS(t)=155 cos(2π×50t)+60°) FIND: impedance of the capacitor and…

Q: Determine all the output waveforms for the 74HC195 when its input signals are shown below CLK K…

A:

Q: Sketch the root locus of the control system. K(S+4) (S+25+2) ►Y(S)

A:

Q: The no load current components of a current transformer are. magnetizing component = 102A core loss…

A: We have been given an no load current components of a current transformer are as below,…

Q: TAS B Твос Design ac Rollwing sequence. a counter which count 0,1137, 5, То using J-K F.F.? 1

A:

Q: ● How are 500 Q resistors connect so as to give an effecti ?resistance of 750 Three resistors of 500…

A:

Q: 2. Determine the current and voltage through R₁ and the power absorbed by R1 using mesh analysis. V1…

A:

Q: coil has a resistance of 4 and an inductance of 9.55 mH. Calculate (a) the reactance, (b) the…

A:

Q: Find the F. T of the following Signals X(t)=28(t + 2) — 28(t-2)-rect(+¹)+rect(²¹) 2 FOND al 2 -2 cun…

A:

Q: A certain appliance uses 350 W. If it is allowed to run continuously for 24 days, how many…

A: Given data, Power P = 350 W. Time t=24 days = 24×24=576 h.

Q: a) Define the complete response in transient circuits? b) Plot [v(t) = 5u(-t+1) - Su(-t-1)]? c) What…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Q2. A power station is to supply three consumers (A, B & C). The daily demand of two consumers and…

A: Given 3 consumers loading information  Asked to find the following Draw the load curve of C and…

Q: What is the frequency of the forcing function that is in resonance with the system?

A: Forcing term is a parameter of a mechanical system which decides the oscillation of the body and how…

Q: The power delivered by the 3A source is 3A O 20W O 15W O 40W O-20W 5.02 10V

A: Given circuit:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.