A constant-pressure R-134a vapor separation unit separates the liquid and vapor portions of a saturated mixture into two separate outlet streams. Determine the flow power needed to pass 6 L/s of R-134a at 320 kPa and 55 percent quality through this unit. What is the mass flow rate, in kg/s, of the two outlet streams? Liquid-vapor mix ture Saturated vapor Vapor seригation unit Saturated liquid The mass flow rate of the outlet stream m2 is 0.0934 | kg/s. The mass flow rate of the outlet stream m3 is 0.0764 kg/s. The flow power is kW.

A constant-pressure R-134a vapor separation unit separates the liquid and vapor portions of a saturated mixture into two separate outlet streams. Determine the flow power needed to pass 6 L/s of R-134a at 320 kPa and 55 percent quality through this unit. What is the mass flow rate, in kg/s, of the two outlet streams? Liquid-vapor mix ture Saturated vapor Vapor seригation unit Saturated liquid The mass flow rate of the outlet stream m2 is 0.0934 | kg/s. The mass flow rate of the outlet stream m3 is 0.0764 kg/s. The flow power is kW.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Calculate the specific volume of air-vapor mixture (m3/kgda) when the following conditions prevail: t=30°C, W=0.015kg/kgda, Pt=90kPa.
15 kg of air at 2bar and 25oC mixed adiabatically in steady flow mixing chamber with 1kg air at 0oC, the temperature of new air is about:
2) In a well-insulated fixed-volume closed vessel, there is initially 5 kg of saturated liquid-vapour mixture water at 100 kPa pressure. In this state, one quarter of the total mass is in the vapor phase. Then, the electric heater in the container operates and a current of 8 A flows through the heater plugged into a 110 V outlet. How long will it take to evaporate all the liquid in the container? Plot the phase change in the T-v diagram showing the saturation curves.
Q3: The enthalpy of vaporization for water is: H,O H,0 AH +44.0 kJ/mole
Moist air at 21 C° DBT and 15 C° WBT and standard atmospheric pressure is humid by water spray. If for each one kg of dry air passing through the duct 0.002 kg of wa 100 C° is injected and totally evaporated. Draw the psychometric and schematic figu process and calculate for the air leaving the a- The moisture content. spray chamber: b- The enthalpy c- Dry bulb temperature.
Not Ai generated, please show all steps The volumetric analysis of a mixture of gases is 30 percent oxygen, 40 percent nitrogen, 10 percent carbon diox-ide, and 20 percent methane. This mixture flows through a 1-in-diameter pipe at 1500 psia and 70°F with a velocity of 10 ft/s. Determine the volumetric and mass flow rates of this mixture (a) treating it as an ideal-gas mixture, (b) using a compressibility factor based on Amagat's law of additive volumes, and (c) using Kay's pseudocritical pressure and temperature.
An air conditioning plant supplies air to a room at a rate of 1.26 kg/s, the supply air being made up of equal parts by weight of outdoor and recirculated air. The mixed air passes through a cooler coil fitted with a by-pass duct, face-and-by-pass dampers being used for humidity control. The air then passes through an after-heater and supply fan. In a test on the plant, the following conditions were measured: a. Make neat sketches showing the plant arrangement and the psychrometric cycle and identify corresponding points on both diagrams. b. Show on the plant arrangement diagram the controls required to maintain the desired room condition. c. Ignoring any temperature rise through the supply fan calculate the mass flowrate of air through the cooler coil, and the cooler coil and heater battery loads, in kW.
Consider a short time span just before and afterthe spark plug in a gasoline engine ignites the fuel-air mixture andreleases 1970 J of thermal energy into a volume of 47.6 cm3thatis at a gas pressure of 1.17 * 106 Pa. In this short period of timethe volume of the gas can be considered constant. (a) Treating thefuel-air mixture as a monatomic ideal gas at an initial temperatureof 325 K, what is its temperature after ignition? (b) What is thepressure in the gas after ignition?
For a liquid-vapour mixture, which of the following can give us all the properties of the mixture?
I do not understand the derribation on the right.
What is the average internal energy,Uavg for a mixture of saturated liquid and vapor at 9MPa with a quality,X=0.35
sessfen O attempy 2. 6.1 Dry saturated steam is expanded in a steam nozzle from 1 MPa to 0.01 MPa. Calculate dryness fraction of steam at the exit and the heat drop. (0.79, 686 kJ/kg)