A controller is to be designed for the plant for a transportation delay of 0.05 s. Explain briefly why a predictive controller is/isn't required? How do the phase and gain of the system change due to transportation delay?

Q: For the circuit shown, µnCox = 4 µpCox = 400 µA/V², [V¢| = 0.4 V, 2 = 0, L= 0.2 µm %3D and W = 1 µm....

A: The circuit  diagram is shown below, Where,μnCox=4 μpCox=400 μA/V2Vt =0.4Vλ=0L=0.2 μmW=1 μm

Q: 11. For the network of Fig. 9.79: a. Determine the mathematical expression for the magnitude of the ...

A:

Q: a. Prove the scaling property of Fourier transform i.e f(t) →F(w), then for f(at) >(1/|a|)*F(w/a) b....

A: Solve the first question, unless the student has asked for a specific question to be solved, subject...

Q: For the capacitor circuit shown in Figure Q3(a), calculate: (i) (ii) (iii) The equivalent capacitanc...

A:

Q: In the circur

A:

Q: 1-Discuss the operation of the hysteresis of the comparator.

A: Introduction - Comparator - A comparator is a type of electronic circuit used to compare two electri...

Q: Why is the ratio between the average line to line voltage and line to neutral voltage approximately ...

A:

Q: 1. Find v, using Norton's theorem. 2 H ww 32 sin 41 V 12 4 cos 41 A

A: The solution is given below 

Q: TRUE OR FALSE - When different diode models are connected in series in such a way that they are ori...

A: When different diode models are connected in series with similar orientation . Taking example of thr...

Q: 4 HpCox 400 µA/V², VGsı 0.6 V, and For the circuit shown, unCox |Vt = 0.4 V, 2 = 0.01, L = 0.2 um, a...

A:

Q: A very small discrete silicon diode (a “100µA diode”) is found to conduct 100 µA at 0.700 V and 1 mA...

A: This question belongs to analog electronics .  It is based on current equation flowing through diode...

Q: True/False A Latch is a back to back set of two Flops with inverted clock inputs to them. This logi...

A:

Q: 3. For both circuits: Determine the potential difference on and the current through each resistor. S...

A:

Q: 6. A 3-phase star connected AC generator is rated at 2.5 MVA, 11 kV, 60 Hz. The generator has a negl...

A:

Q: In the circuit shown in figure (3) VI =12V,find Vs : 4 kf ww w- 2 kl 1 kl Vs 3 kl Fig. 3 6 kl? 4 k

A: Given V1=12v

Q: Question 7 .1. What the advantages of a closed-loop control system? 7.2. What is the purpose of a s...

A: I am giving the answer of first 3 subparts as per guildlines. - closed loop control system is provid...

Q: Assume you have a 6V battery and a 1.5V flashlight bulb which draws 0.5A when the bulb voltage is 1....

A: V=IR here V= voltage  I=Current R resistor 

Q: 2. Find the voltage at points A and B with respect to ground (Fig. 4-29). Include polarity. 50 V A R...

A:

Q: If R= 44 Q, calculate the power dissipated in the 44 Q resistor and the voltage labeled ve in the ci...

A: Given circuit, R=44 Ω  

Q: :) For the circuit shown, unCox = 4 µpCox = 400 µA/V², and |Vt = 0.4 V, 1 = 0, L= 0.2 %3D um and W =...

A:

Q: The signal input power to a receiver is 47 mW. The noise power is 12 uW. What is the S/N ration? Wha...

A:

Q: etermine RH wrt terminals a-b. 2 A 20Ω 9Ω a 5Ω

A:

Q: Theoretical Calculations: 1. What is the polarity of the input voltage Uin compared with the output ...

A:

Q: . Determine the current through using 3Ω ww the circuit source transformation. ЗА 10 Ω 62 15 V .. Ap...

A:

Q: findthe Efficiency 412 V2 I3 012C i3 e 414

A: Given: Consider the following circuit: To find: String efficiency?

Q: 5. Sketch Vo for the following circuit. 12 V + 0.1 pF R2 56 ka 2V -12 V 1-1 kHz

A:

Q: # 1) Find Io, compute by He elenments the power absorbed or supp 8 V 6 A + 4 A + 24 V 2 10 V Ix = 2 ...

A:

Q: In the circuit given below, R = 16 kN, R2 = 70 kQ, and R3 = 11 MQ. Calculate the gain when the switc...

A:

Q: A 3 phase star-connected alternator is rated at 2,000 kVA, 13.5 kV. The armature effective resistanc...

A: Given,3-ϕ Y-connected alternator2000KVA, 13.5kVArmature Resistance Ra=1.3ΩReactanceXs=20ΩPower Facto...

Q: Q2 : Suppose you have the following modulated signal with the output wave changes of t 5.5 Vp: Vam (...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: 4. Determine the Norton equivalent for the network faced by RL. 5 kΩ 1 kN 300 mA ( ↑ 7 kΩ 6 kΩ RL 2....

A:

Q: D2 o v, 1 kN D (a)

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 10 Ω 8Ω 40/0° V rms j4 Ω -6 Ω

A:

Q: 2) Determine (V,) for the two circuits below using superposition. 2A 42 12V 12A 19V

A:

Q: Find voltage values at points A, B, C, and D shown in the circuit (Fig. 4-28) with respect to ground...

A: In this question we will find voltage at point A,B,C and D with respect to ground...

Q: Explain what the stack pointer register is and what it does in a few words.

A:

Q: Explain the working of a full wave bridge rectifier circuit. What are the disadvantages of center ta...

A: The main difference between full-wave rectifier and center tap full wave rectifier is the number of ...

Q: 15. For the network of Fig. 9.80: a. Determine re- b. Find Ay = Vo/Vi- c. Calculate Zi.

A:

Q: 5. The block diagram of two chemical reactor is shown in the figure below. F CAols) CAIS) CAz(s) F+ ...

A: Types of Damping in control system Critically Damped system Under damped system Overdampade System ...

Q: Is it possible to an element to have zero voltage but a current is not zero? Or an elemer current bu...

A:

Q: 4. Sketch Vo for the following circuit. C 120 V Ideal R E 20 V

A: We need to find output voltage and we need to draw output waveform

Q: t= 0 6Ω 24 V 12 2 4Ω -- 155

A:

Q: A 1200 kVA, 6600 volts, 3-phase Y connected alternator, has an effective resistance of 0.4 ohms and ...

A:

Q: R1 RL R4 330 1.5k 330 Vs R2 R3 R5 470 470 1k. 5V .tran 10ms

A: Circuit diagram is given as,

Q: Given a sequence x[n] for 0 < n < 3, where x[0] = 2, x[1] = 3, x[2] = -3, and x[3] = 5, evaluate its...

A: In question, it is asked to solve only 1st part. Writing the expression of X(k). Xk=∑n=0N-1xne-j2πNk...

Q: What SQL command should you use to obtain specific rows from a database table?

A: In this question, we need to obtain specific rows from a database table.

Q: C

A: The solution is given below

Q: If you mistakenly delete a file and want to recover it, you must do the actions outlined below.

A: Given: Mistakenly deleted file

Q: Consider the WAN, or wide-area network, as your preferred wireless access method. What makes this op...

A: Wide Area Network (WAN) -  it is a big data system that is not limited to a single place. Through a ...

Q: Name three types of semiconductor noise.

A: The question given is related to the types of noise in semiconductors. generally noise in electronic...

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.