A cylindrical tank with a large diameter is filled with water to a depth D = 0.273 m. A hole of cross-sectional area A = 5.03 cm² in the bottom of the tank allows water to drain out. (a) What is the rate at which water flows out, in cubic meters per second? (a) Number i Units

A cylindrical tank with a large diameter is filled with water to a depth D = 0.273 m. A hole of cross-sectional area A = 5.03 cm² in the bottom of the tank allows water to drain out. (a) What is the rate at which water flows out, in cubic meters per second? (a) Number i Units

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 43P: A commonly used turn of mass in the English system Is the pound-mass, abbreviated Ibm, where 1 Ibm =...

See similar textbooks

Similar questions

A commonly used turn of mass in the English system Is the pound-mass, abbreviated Ibm, where 1 Ibm = 0.454 kg. What is the density of water in pound-mass per cubic foot?
Find the order of magnitude of the number of table-tennis balls that would fit into a typical-size room (without being crushed). 18. (a) Compute the order of magnitude of the mass of a bath-
Assume it takes 7.00 min to fill a 30.0-gal gasoline tank, (a) (Calculate the rate at which the tank is filled in gallons per second. (b) (Calculate the rate at which the tank is filled in cubic meters per second. (c) Determine the time interval, in hours, required to fill a 1.00-m3 volume at the same rate. (1 U.S. gal = 231 in.3)
How many cubic centimeters (cm3) are in one cubic meter (m3)?
Check Your Understanding Figure 1.4 says the mass of the atmosphere is 1019kg . Assuming the density of the atmosphere is 1kg/m3 , estimate the height of Earth’s atmosphere. Do you think your answer is an underestimate or an overestimate? Explain why. How many piano tuners are there in New York City? How many leaves are on that tree? If you are studying photosynthesis or thinking of writing a smartphone app tot piano tuners, then the answers to these questions might be of great interest to you. Otherwise, you probably couldn’t care less what the answers are. However, these are exactly the soils of estimation problems that people in various tech industries have been asking potential employees to evaluate their quantitative reasoning skills. If building physical intuition and evaluating quantitative claims do not seem like sufficient reasons tot you to practice estimation problems, how about the fact that being good at them just might land you a high-paying job? For practice estimating relative lengths, areas, and volumes, check out this PhET (https://openstaxcollege.org/l/21lengthgame) simulation, titled “Estimation.”
A rod extending between x = 0 and x = 14.0 cm has uniform cross-sectional area A = 9.00 cm2. Its density increases steadily between its ends from 2.70 g/cm3 to 19.3 g/cm3. (a) Identify the constants B and C required in the expression = B + Cx to describe the variable density. (b) The mass of the rod is given by m=allmaterialdV=allxAdx=014.0cm(B+Cx)(9.00cm2)dx Carry out the integration to find the mass of the rod.
The volume of liquid flowing per second is called the volume flow rate Q and has the dimensions of [L][T]. The flow rate of a liquid through a hypodermic needle during an injection can be estimated 60. with the following equation: TR"(P2 – P,) 8nL The length and radius of the needle are L and R, respectively, both of which have the dimension [L]. The pressures at opposite ends of the nee- dle are P, and P,, both of which have the dimensions of [M]/{[L][T]*}. The symbol 7 represents the viscosity of the liquid and has the dimen- sions of [M]/{[L][T]}. The symbol 7 stands for pi and, like the number 8 and the exponent n, has no dimensions. Using dimensional analysis, de- lermine the value of n in the expression for Q.
The total length of the blood vessels in the body is roughly 100 000 km. Most of this length is due to the capillaries, which have an average diameter of 6.90 μm. Estimate the total volume of blood in the human body by assuming that all the blood is found in the capillaries and that they are always full of blood. answer in leters please
Hydraulic engineers in the United States often use, as a unit of volume of water, the acre-foot, defined as the volume of water that will cover 1 acre of land to a depth of 1 ft. A severe thunderstorm dumped 2.0 in. of rain in 30 min on a town of area 26 km2.What volume of water, in acre-feet, fell on the town?
Consider a water tank that is being filled with rainfall at the top and is drained through a small hole atthe bottom. The change in volume can be modelled by considering the amount of water entering andleaving the tank (per unit of time) as followsdVdt= fin − fout.Here volume of water in the tank V is in litres, flow rate in fin is in litres per hour, flow rate out fout isin litres per hour and time t is in hours. Initially, the tank contains 50L of water: V (0) = 50.(a) Assume the rainfall throughout the day is getting heavier, such that, fin(t) = 10 + t andthat the tank is losing 10% of its volume of water per hour, such that, fout(V ) = 0.1V . Check bydirect substitution that the functionV (t) = 10(t + 5e−0.1t)satisfies the ODE and the initial condition.Now assume that the hole is slowly growing in size, so that the flow rate out increaseswith time:fout(V, t) = 0.1(1 + 0.1t)V.Solve the ordinary differential equation for V (t) with this flow rate out, using either separation…
Assume it takes 6.95 minutes to fill a 40.0 gal gasoline tank. (1 U.S. gal = 231 in.3) (a) Calculate the rate at which the tank is filled in gallons per second. (b) Calculate the rate at which the tank is filled in cubic meters per second. (c) Determine the time interval, in hours, required to fill a 1.00-m3 volume at the same rate.
The gas tank of a car is filled with a nozzle that discharges gasoline at a constant flow rate. Based on unit considerations of quantities, obtain a relation for the filling time in terms of the volume V of the tank (in L) and the discharge rate of gasoline V (in L/s).