A landfill cell is open for 5 years, receiving solid waste of 250,000 tonnes/year. Calculate the methane gas production for each year during the first five years of the landfill life. The landfill gas emission constant is 0.0307 per year and methane generation potential is 140 m³/tonne. Estimate the peak gas production within the 5 years. The following formula may be applicable: QT- 2 k L, M, e-ki Where От n k Lo M₁ total gas emission rate from landfill, volume/time total time period of waste placement landfill gas emission constant, time-1 methane generation potential, volume/mass of waste age of ith section of waste, time mass of wet waste, placed at time i

Q: A stream of air is compressed in an adiabatic, steady-state flow process at 50 mol/s. The inlet is…

A:

Q: One mole/hr of the gas mixture containing 90mole%N₂ and 10mol%CO₂ is passed through an absorber, in…

A: There is absorption of CO2 from a gas mixture (N2 and CO2) into liquid solvent (water).Inlet gas…

Q: saturated steam at 0.8 kg/cm² gage. Assuming that no sensible heat us recovered in the evaporator,…

A:

Q: 2. Cengel and Ghajar-2-52 2-52 A spherical metal ball of radius r, is heated in an oven to a…

A:

Q: The work of adhesion (W) is the energy per unit area associated with bringing two immiscible liquids…

A:

Q: Problem 3) -TA (mol/dm³ s): . T(K): 0.012 300 A + 2B→ 3C mol dm³ XA = 4.00 0.064 327 , XB = 6.00…

A:

Q: A liquid has a molar volume of 0.2 L/mol at 400 K and 4 bar. This liquid is compressed with a pump…

A: A. Work done by the pumpThe work done by the pump is given by the following formula:wheren is the…

Q: The reaction A → Bis carried out isothermally on a porous catalyst. The intrinsic reaction rate is…

A: The question revolves around a chemical reaction A→B taking place on a porous catalyst.Two critical…

Q: During annealing copper is heated to 120°C. The copper atoms move around the lattice by diffusion.…

A:

Q: Derive parameters of the critical point for the Dieterici equation of state:

A: We need to derive parameters(a,b) of the critical point (Pc , Tc , Vc)

Q: . CO₂ entering from a combustion (T= 500°C) process is mixed stoichiometrically with H₂ at (T=…

A:

Q: Given an open tank filled with 10m of water, what is the pressure at the bottom? 199.425 kPa 4 atm…

A:

Q: 1. The activation energy for diffusing copper in nickel is 2.7 x 10-5 m²/s and the activation energy…

A: Note: Since you have posted multiple questions, we will provide the solution only for the first…

Q: Vapor pressure of benzene can be calculated using the Antoine's Equation: InP= 6.9057- 1211 T+220.8…

A: Please select text to grab.

Q: Q2/ Determine the maximum possible C.O.P for acyclic heat pump that is to pump heat / from an…

A: Initial ambient temperature, TL1 = -15°CTemperature of interior of house, TH = 25°C

Q: Evaporation Losses of Water in Irrigation Ditch. Water at 25°C is flowing in a covered irrigation…

A: The evaporation loss of water is to be determined.

Q: For the following reaction, 3.59 grams of hydrochloric acid are mixed with excess oxygen gas. The…

A:

Q: 6.92. The derivative (@U/V)T is sometimes called the internal pressure and the product T(@P/T)v the…

A:

Q: Q2. The free energy of vacancy formation in aluminum is 0.76eV per vacancy. Estimate the vacancy…

A: To enter the reactive state all the elements need minimum amount of thermal energy to overcome the…

Q: If a startup has to make a product for a facial serum that has both herbal and chemical ingredients,…

A: Facial serum - Face serum is a highly concentrated emulsion made up of tiny molecules that can more…

Q: t = 2π F m where t = period, 1 = length of strength where: n frequency of vibration, 1= length of…

A: To check whether the given relations are true using the method of dimensional analysis, we'll…

Q: B) The gas stream shown in Table below is fed to an isothermal absorber operating at 90°F and 75…

A:

Q: What Volume (PFR) is required to obtain 96% for the single reactor process. this is what i have…

A:

Q: what should the simple and fractional distillations graphs should look like for cyclohexane ( BP:…

A: Distillation is a method for separating two or more miscible liquids with different boiling points.…

Q: RELATIONSHIP WHAT IS THE between the the and t?

A:

Q: Problem 3 Helium gas at 25 °C and 4 bars is contained in a spherical glass container of 200 mm…

A:

Q: What is the vapor density of this mixture at the following compositions at 405 kPa and 67 degrees…

A: Given the following composition:- Pentane: (0.349)- Butane: - Hexane: The molecular weights (molar…

Q: A PM10 sampler was operated for a 24 hour period at a flowrate of 1.7 cubic meter/min. At the end of…

A:

Q: 02: How much thermal energy must be supplied by an electric immersion heater if you wish to raise…

A:

Q: 1- Evaporation differs from distillation: a- The vapor rarely is a single component; b- The vapor…

A: According to company guidelines, I can only solve the first three MCQs. please upload the remaining…

Q: Find the volume of the plug flow reactor needed for 95% conversion of reactant A CAO Aqueous Feed…

A:

Q: 2.10 The separation of isopentane from n-pentane by distillation is difficult (approximately 100…

A: Seperation of isopentene from n-pentane is done by distillation.Extended Antoine vapor pressure…

Q: X₁0 mol -TA dm³-min 1.0 (dm³-min) mol -TA FAO (dm³-min) -TA mol 0.2 1.67 0.4 5.0 0.45 5.0 0.5 5.0…

A: Given, feed flow rate of ANow we tabulate data of conversion of A (XA) versus  using the table…

Q: Consider a continuous stirred-tank reactor (CSTR) used for a first-order exothermic reaction. The…

A: A Continuous Stirred-Tank Reactor (CSTR) is commonly used in chemical engineering for carrying out…

Q: A- A thickener is designed to separate suspension containing 15 Kg of water/Kg of solid is to be…

A:

Q: The reaction A + B → Products is 1st order in A and ½ order in B,  and the activation energy for the…

A: Given reaction is: Reaction is 1st order in A and (1/2) order in BActivation energy of the given…

Q: The first order series reaction ABC is conducted in a Batch reactor. The initial concentrations of…

A: First order reaction is,Reaction occurs in batch reactor.Initial concentration of A = CAoInitial…

Q: A 10-minute experimental run shows that 75% of liquid reactant is converted to product by a 1/2…

A: The amount of time it takes for the concentration of a particular reactant to reach 50% of its…

Q: A 'long' steel shaft of 10 cm diameter is austenised at 870°C and then quenched in a liquid at 30°C.…

A:

Q: 1) 1 Psi 2) 1Psi - C la g म.52 P a

A: 1) Converting from pounds-force per square inch (Psi) to kilograms per meter per second squared…

Q: Benzene (A) diffuses into N2 (B) in a stable state in a pipe. Total pressure is 1 atm, temperature…

A: Given that:Benzene (A) diffuses into N2 (B) in a stable state in a pipe.Total pressure P=1…

Q: 100 kg Benzene/hr 200 kg Toluene/hr 75 kg Xylene/hr 30 kg Benzene/hr 100 kg Toluene/hr 10 kg…

A: Distillation- it is the procedure for removing certain elements or chemicals from a liquid…

Q: At room T, sucrose is hydrolyzed by the catalytic action of the enzyme, sucrase. Starting with the…

A:

Q: Draw a mass-balance diagram and estimate the monthly mass emission percentage to the atmosphere.

A:

Q: Q: List all of the possible forms of energy occurring while this reactor is operating (essentially…

A: Based on the provided information, here's a list of the possible forms of energy occurring while the…

Q: Calculate the surface / volume of a sphere, a cube, and a right cylinder of height equal to…

A: Surface area to volume ratio of a cylinder, a sphere and a cube is to be calculated and compared.It…

Q: A heat transfer oil (specific heat -0.454 kcal/kg °C) leaving a hydraulic system at a rate of 10,000…

A:

Q: How many independent equations can be derived by applying balances to the nonreactive process…

A: A process can be solved for its variables if the degree of freedom of that process is zero.Degree of…

Q: XA 0.0 mol m³.sec. 1 m³-sec -TA -TA mol FAO (m³.sec -TA mol 0.49 0.1 0.41 0.2 0.34 0.4 0.199…

A: Given, feed flow rateTabulating the data of  and XA…

Q: Q2) A mixture of 40% propane (C3Hs) and butane (C4H10) by moles is burned with 35% excess air.…

A: Composition of the feed is,'Propane = 40 %Butane = 60 %Flow rate of air = 45 SCMH% excess air = 35 %