A magnetic core of uniform cross-section 2 cm^2 and relative permeability of 10 is connected to a 125 V, 50 Hz generator as shown in the figure. Determine the followings if the core has a magnetic flux density of 2 Tand there is no leakage: V1 N 500 6 сm N2 = 300 V2 12 cm depth is 2 cm The energy stored in the core is:. Single choice. None of these 176.56 J 66.21 J 529.67 J 357.52 J 1.18 KJ

A magnetic core of uniform cross-section 2 cm^2 and relative permeability of 10 is connected to a 125 V, 50 Hz generator as shown in the figure. Determine the followings if the core has a magnetic flux density of 2 Tand there is no leakage: V1 N 500 6 сm N2 = 300 V2 12 cm depth is 2 cm The energy stored in the core is:. Single choice. None of these 176.56 J 66.21 J 529.67 J 357.52 J 1.18 KJ

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.1MCQ: The Ohms law for the magnetic circuit states that the net magnetomotive force (mmf) equals the...

See similar textbooks

Similar questions

A ferromagnetic core in the shape of a doughnut has a cross-sectional area of 0.11 m2 and an average length of 1.4 m. The permeabil ity of the core is 1.206 × 10-3 Wb/A-t. m. Determine the reluctance of the magnetic circuit
B. For the following magnetic circuit, the flux passing through the core is 1.32 mWb, the cross section of the core is 3 cm by 4 cm, the laminated section has a stacking factor of 0.9, and the gap is 1 mm. Determine the flux density in each section. Neglect fringing d N turns Cast iron Air gap Laminated sheet steel
A ferromagnetic core is shown below. The depth of the core is 5 cm. The other dimensions of the core are as shown in the figure. Find the value of the current that will produce a flux of 0.003 Wb. With this current, what is the flux density at the top of the core? What is the flux density at the right side of the core? Assume that the relative permeability of the core is 1000. 1. - 10 cm--- - 20 cm - 15 cm 500 tums 15 cm 15 cm [1.21 A, 0.4 T, 1.2 T]
Question 1 A ferromagnetic core with a relative permeability of 1500 is shown in Figure 2. The dimensions are as shown in the diagram, and the depth of the core is 7 cm. The air gaps on the left and right sides of the core are 0.070 and 0.020 cm, respectively. Because of fringing effects, the effective area of the air gaps is 5 percent larger than their physical size. If there are 400 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A, what is a) the flux in each of the left, center, and right legs of the core? b) the flux density in each air gap? 7 cm ст ст 30 cm 30 cm 7 cm 400 turns 0.05 cm 30 cm 0.07 cm 7 cm Core depth = 7 cm Figure 2
A toroidal core with a mean circumference of 100 cm and a cross-sectional area of 10 cm2 is wound with 500 turns of wire. What current would be required to generate a flux of 1 mWb in the core. Assume the core has a relative permeability of 800
3- A magnetic core with an air gap is shown in below Figure. The depth of the core is 3 cm, the length of the air gap in the core is 4 cm, and the number of turns on the coil is 100. How much current is required to produce total flux of 0.00052 Weber? (H= 2000, Ho=4.n107). 6 cm 20 cm N = 100 4 cm = lg 6 cm 6 cm 18 cm 12 cm 18 cm 6 ст Depth = 3 cm
constant. 15 cm core depth = 15 cm Problem 2 A ferromagnetic core with a relative permeability of 2000 is shown in Figure. The dimensions are as shown in the diagram, and the depth of the core is 7 cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A, what is the flux in each of the left, center, and right legs of the core? What is the flux density in each air gap? |7 cm 30 cm 7 cm 7 cm 30 cm 7 cm 30 cm -0,05 cm 300 turns 0.07 cm 7 cm 1|Page
Question: 01 A two-legged core is shown in figure below. The winding on the left leg of the core (N) has 800 turns. The depth of the core is 15 cm. The small airgap is 0.05 cm and there is no fringing effect. If the dimensions are as shown, then determine the total reluctance of the given core when u, =800 and constant. 15cm 25cm 10cm 10cm 50cm N=800 5cm
A ferromagnetic core is shown in Figure PI-2. The depth of the core is 5 cm. The other dimensions of the core are as shown in the figure. Find the value of the current that will produce a flux of 0.005 Wb. With this current, what is the flux density at the top of the core? What is the flux density at the right side of the core? Assume that the relative permeability of the core is 1000. -10 cm- - 20 cm- 15 cm 400 turns 15 cm 15 cm Core depth 5 cm
A ferromagnetic core is shown in Figure Pl-2. The depth of the core is 5 cm. The other dimensions of the core are as shown in the figure. Find the value of the current that will produce a flux of 0.005 Wb. With this current, what is the flux density at the top of the core? What is the flux density at the right side of the core? Assume that the relative permeability of the core is 800. 1-5. 10 cm- 5em 20 em 15 cm 15 cm 15 cm Coe depth - Scm SOLUTION There are three regions in this core. The top and bottom form one region, the left side forms a second region, and the right side forms a third region. If we assume that the mean path length of the flux is in the center of each leg of the core, and if we ignore spreading at the corners of the core, then the path lengths are I, = 2(27.5 cm) = 55 cm, I, = 30 cm, and /, = 30 cm. The reluctances of these regions are:
A ferromagnetic core with a relative permeability of 1500 is shown in the following figure. The depth of the core is 5 cm. Because of fringing effects, the effective area of the air gaps is 5 percent larger than their physical size. If there are 300 turns in the coil wrapped around the center leg of the core, and if the current in the coil is 1.25 A, find the magnetic flux and the field density in all three legs of the core, as well as the magnetic flux and flux density in the two air gaps.
A ring of ferromagnetic material has a rectangular section. The inner diameter is 15 cm.The outer diameter is 24 cm. And the thickness is 5 cm. There is a coil of 500 turns wound onthe ring. When the coil has a current of 10 A, the flux in the core is 0.0007 Wb. Theaverage length of the ring is Ln=0.66m Determine:a) The magnetomotive force.b) The intensity of the magnetic field and the flux density.c) Reluctance, permeability and relative permeability.