A rectangular plate 3 m x 2 m is immersed horizontal inside a liquid of specific gravity 1.2. Calculate the total pressure on the plate, if it is immersed at a distance of 2 m from fluid surface level.

A rectangular plate 3 m x 2 m is immersed horizontal inside a liquid of specific gravity 1.2. Calculate the total pressure on the plate, if it is immersed at a distance of 2 m from fluid surface level.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

89 ll k ۱۰:۳۷ ص 1,ك.بث 0 An oil of specific gravity 0.78 is flowing through the pipe of diameter 30cm. one end of the simple U tube manometer which contains mercury, is inserted with the center of pipe and other end is open to atmosphere. The level difference in mercury is found in the right limb as 36 cm. The distance between the center of the pipe and the mercury level in right limb is 12 cm. Find the pressure of oil in the pipe in kPa. (Enter only the values in the boxes by referring to the unit given in the bracket. Do not send the hand written answer sheets to my mail) The pressure of oil in the pipe Unit in kPa =
As shown in the figure, an inclined manometer is used to measure the pressure of the gas within the reservoir. The manometer fluid is mercury, which has a density of 845 Ib/ft3. The manometer fluid rises a distance d = 12 inches along the manometer tube, which is inclined e = 20° from the horizontal. The atmospheric pressure is 14.7 Ibf/in? and the acceleration of gravity is 32.2 ft/s?. Patm = 14.7 Ibf/in.? Gas reservoir g = 32.2 ft/s? a 20 in. Mercury (p = 845 Ib/ft³) Determine the gas pressure, in Ibf/in?. Express the pressure as a gage or a vacuum pressure, as appropriate, in Ibf/in2.
多95 6 نقاط Two tank with the same fluid at * their base are separated by piston whose weight is (50 N) and (30 cm) diameter, as shown below. Calculate the gage pressure at point A, B and * .C respectively Piston B Air Air 50 cm 30 cm 25 cm E 30 cm Water 90 cm
Q5 A U-tube manometer similar to that shown below is used to measure the gauge pressure of water (mass density p = 1000 kg /m3). If the density of mercury is 13.6 x 103 kg /m³, what will be the gauge pressure at A if h1 = 0.45 m and D is 0.7 m above BC. Wwater Wmercury
10 نقاط Find the equation that represents the different pressure in this manometer properly PI P2 Fluid 1 Fluid 2 Density P1 d, Density P2 Manometer fluid Density Pr (b) P, – P2 = P2gd, + Prgh – P1gd, خيار 3 P – P2 = P2gd2 +Prgh- P1gd1 II
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 35 cm above the pipe B. The height of oil in right limb is 40 cm. Also, the mercury level difference is found in right limb as 80 cm. Find 1-The difference of pressure between two pipes (PA-PB) (Unit is in kPa) = 2-Equivalent to Water head in mm =
Q2. a. Gauge (G) and mercury manometric (MM) tensiometers was were installed at 30 and 100cm respectively below the soil surface. The distance from the gauge to center of the ceramic cup is 50cm and from the mercury level in the reservoir to soil surface is 30 cm. Reading for the G. tensoimeter was - 61kP(kilopascals) and for the height of the mercury level in the MM tensiometer was -55KP Answer the following: 1. calculate the matric potential of the GT and MMT 2. Find the total potential of GT and MMT 3. indicate the flow direction between the two tensiometer.
I.A U-tube manometer filled with Liquid A is attached to the underside of 4 inch pipe carying water, as shown in Figure 2. At a point directly above the inclined U-tube manometer tap, the upstream tap of an inverted U tube is located. The inverted-U-tube manometer is filled with a Liquid B. If the P:-17 psi, determine; (Note: I in (inch) - 25.4 mn, I atm - 101.325 kNiw - LO1325 har - 101.325 APa - 14.7 poi, g -9.8sims) (a) the differential manometer reading (psig), and (b) the value of X (inch). Liquid , SG-05 12 in. Water Liquid A, SG 16
A U-tube mercury manometer is used to measure the pressure at a pointon the wing of a wind-tunnel model. One side of the manometer isconnected to the model, and the other side is open to the atmosphere.Atmospheric pressure and the density of liquid mercury are1.01 × 105 N/m2 and 1.36 × 104 kg/m3, respectively. When thedisplacement of the two columns of mercury is 20 cm, with the highcolumn on the model side, what is the pressure on the wing?
Figure 1 shows a fairly large U-tube manometer containing water (density p= 1000.0 kg.m³3) and oil (density p=900.0 kg.m³). The left-hand side opening is sealed with a rubber stopper. The height of the oil column is h₂ cm. The height of the water column above the water/oil boundary is h₁ = 20.00 cm. The external pressure is given by Pout = 100.00 kPa. (i) Calculate the absolute pressure at the bottom of the oil column. (ii) Calculate pin, the absolute pressure directly under the rubber stopper. Express your answers to at least 4 significant figures in SI units. Pout Pin h₁ U water oil h₂ Figure 1: Stoppered U-tube manometer containing water & oil
A manometer consists of two tubes A and B, with verticalaxes and uniform cross-sectional areas 500 mm2and 800 mm2respectively, connected by a U-tube C of cross-sectional area70 mm2throughout. Tube A contains a liquid of relative density0.8; tube B contains one of relative density 0.9. The surfaceof separation between the two liquids is in the vertical side of Cconnected to tube A. What additional pressure, applied to thetube B, would cause the surface of separation to rise 60 mm inthe tube C?
A 12.5 kg block of metal measuring 12.0 cm by 10.0 cm by 10.0 cm is suspended from a scale and immersed in 5.60 cm below the surface of the water. Scale a b (a) What are the magnitudes of the forces (in N) acting on the top and on the bottom of the block due to the s significant figures.) Frop N N Fbottom (b) What is the reading of the spring scale (in N)? N (c) Show that the buoyant force equals the difference between the forces at the top and bottom of the block. ( II