A resistor of 42 ohm is connected in series with a capacitor of 50 micro farad. If a supply of 240 V, 60 Hz is connected across the arrangement then the current flowing in the capacitor is O a. 3.14 A O b. 35.4 A O c. 31.4 A O d. 3.54 A
Q: (c.) Determine the core loss when the transformer is connected to a 4700 (primary) volt 60 cycle…
A: Given: A 60 kVA 4800/460 volt, 60 cycles, distribution transformer has the following resistance and…
Q: V₁=+1.5 V 200 ΚΩ + 0.1 μF HH - Vo
A: Op-Amp: The is a three-terminal device. this is used to amplify the gain of the circuit.
Q: Q3: Draw the sequence networks for the system shown in Figure below. What are sequence impedances?…
A: There are 3 types of sequence impedances which are positive sequence, negative sequence and zero…
Q: 12 V 6Ω 8V 4Ω
A:
Q: EX: 0 at what temperature will be The Fermi distribution of electron with energy K₁₂ = 8.6x₁0² cv at…
A:
Q: find the total kW power consumed by the load
A:
Q: Two wattmeters are used to measure the total kW power drawn by a balanced three- phase load.…
A:
Q: C- Put TRUE or FALSE for only TWO of the following and say why: ! 1. PCM modulation is very complex…
A:
Q: I need answer ASAP. Thank you! Given: RD = 2kohm , Rs = 0.51kohm , RG = 1Mohm and VDD = 18V…
A: The required parameters can be calculated by using the DC analysis of the amplifier circuit.
Q: RE ww Living R www -OVO Figure P15.30 *15.31 Consider the phase-shift oscillator in Figure P15.30.…
A:
Q: A uniform line charge of 16 nC/m is located along the line defined by y = -2, z = 5. (a) Find E at…
A: In uniform line charges, charges are uniform along the line axis, they are placed parallel and equal…
Q: 1. Two infinitely long coaxial cylindrical sheets, p= a and p= b (b> a), carry surface charge…
A: Given data, Consider gaussian cylindrical surface S of radius ρ
Q: Given for Problem 1: Iç । [+ L₁ L4 Load 1: 200 W, unity power factor Load 2: 1200 W at 0.85 power…
A: As per our policy, we are allowed to attempt only first three part of question remaining post…
Q: Find the value of i1. 12 and 13.
A:
Q: A 0.4-mF capacitor has a charge of 20 mC. How much is the voltage across it?
A:
Q: A factory is supplied by a three-phase, 3-wire system with the following characteristics: = 23020⁰…
A: Two wattmeter method is used in three phase three wire system. Three wattmeter method is used in…
Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…
A:
Q: A potential energy function for a system in which a two-dimensional force acts is of the form…
A: force is given as-
Q: Simplify the following expression 1 jo+2 2) 8 (0 + 3)
A: In the above given question we need to simplify the given fourier transform by the help of…
Q: C- Put TRUE or FALSE for.. of the following and say why: ! 1. PCM modulation is very complex…
A: Statement 1) TRUE Reason - S.NO Parameter of Comparison Pulse Code Modulation (PCM) Delta…
Q: 1-43. At node 1 in the circuit, applying KCL gives: 2Α 8 Ω 3 Ω Τ 12 V 6Ω 6Ω 4Ω LM 12-V₁ V1 = + (A) 2…
A:
Q: Q3: The matrix differential equation of the state variable model of a system has 0 1 ^-[- -8-12 8 -8…
A: Given matrix differential equation of state variable model of a system. Matrix be A.
Q: Given the electric field intensity, E = 400 yax + 400xay V/m, find (a) the equation of the…
A: It is given that: E=400yax+400xay Vma)A=2,1,-2b) E=800 V
Q: Steady-state condition exist in the circuit shown in Fig.3 at t < 0.The switch is closed at t=0.…
A:
Q: Q3/A/ A3-phase, 5.5kW, 440V, 501 Iz, cylindrical rotor S.M has synchronous reactance of (0+j2)…
A: Given data : Output power Pout=5.5 kW=5500W Synchronous reactance,Xs=j2Ω/ph Full-load…
Q: 15 Ω 3) For the circuit given, obtain vi and v2. 4.5 Ω 3 A Μ 2/2 1.5 A www Μ ΖΩ ΤΩ www
A: As per our guidelines we are supposed to answer only one question at a time. Please repost the…
Q: Q3/A) A 1000-VA 230/115-V transformer has been tested to determine its equivalent circunt. The…
A: given that VOC=230VIOC=0.45APOC=30WPOC =VOCIOCcosϕ∘cosϕ∘=POC VOCIOC=30230×0.45=0.289POC =VOC2RC⇒…
Q: 2) Determine the Thevenin voltage and resistance at terminals and b. 2.5 Ω www 25 V 15 Ω b ww
A:
Q: Q.1 For the following block diagram find C(s) D(s) R(1) E(s) G₁(s) Gy(s) C(s)
A:
Q: 6.6. In the power system network shown in Figure 51, bus 1 is a slack bus with V₁ = 1.0/0° per unit…
A: Given that, V1=1.0∠0°S2=280MW Line impedance Z=0.02+j0.04 per unit
Q: A 1-MHz carrier with an amplitude of 1 volt peak is modulated by a 1-kHz signal with m=0.5. Sketch…
A:
Q: 15) A 100 HP motor operates at 95% of its load capacity. The motors efficiency is 88% and the power…
A:
Q: The following circuit contains two op-amp stages. a) Name the basic circuit structures and draw a…
A: 1) The circuit is given as It is a cascading of the two amplifiers to achieve high gain. A Block…
Q: what is the norton currents at terminal a and b Choices 1. 0 A 2. 2 A 3. 10 A 4. 2.5 A
A: Norton theorem states that a two terminal network containing linear and bidirectional elements and…
Q: A potential energy function for a system in which a two-dimensional force acts is of the form…
A: Given, Potential energy, U=6x3y-3xy3 Point, x,y⇒(3,4)
Q: An enhancement type N-MOSFET with VT = 2 V that conducts a current ID = 5 mA for VGS = 4 V and VDS =…
A:
Q: 5) Calculate the complex number and express the result in rectangular form
A:
Q: Given v₁ = 20sin(wt +60-) and v2 = 60cos(wt -10-), determine the phase angle between the two…
A: Given data, V1=20sinωt+60° VV2=60cosωt-10° V
Q: A spherical charge of radius 3 cm and a volume charge density given below. How much is the D-field…
A:
Q: 8. A factory is supplied by a three-phase, 3-wire system with the following characteristics: Vab=…
A:
Q: A capacitor with a capacitance of 3.6360426666667E-10 pF is a parallel plate capacitor. Each plate…
A:
Q: Two point charges of 318 statcoulomb and 414 statcoulomb are 6.8 cm apart. A point between the…
A:
Q: A 250 kVA,480 V,3-phase,4 pole, 60Hz synchronous generator with a synchronous reactance of 099…
A: The per-phase equivalent voltage of the synchronous generator is, Vt=E3E=480 VVt=4803Vt=277.13 V…
Q: Input voltage is 120 v, solve the output current
A:
Q: Let the periodic function be f(t) = |t| , -π < t < π . Solve the following points: a) Draw the graph…
A:
Q: 4 A capacitor has 0.035 * 0.035 m parallel plates. The distance between the plates is 0.092 m in…
A:
Q: (ii) An overhead line has a span of 160 m of copper conductor between level supports. The conductor…
A: Defination: The lowest point of conductor when it is hang between two support is called as sag.…
Q: Enumerate the steps in making a power supply
A: Assuming that you are asking for the design of laboratory DC power supplies.
Q: A SINGLE-PHASE STEP-DOWN TRANSFORMER 1320/220 VAC 60HZ. IT SUPPLIES A LOAD 1 FORMED BY A 18 Ω…
A: Capacitor deliver reactive into the system, inductor absorb reactive power Resistance absorb active…
Q: A) Let x[n]=d[n]+[n-1]. Find the D.F.T of the signal g[n]=x[2n] B) Determine the I.D.F.T of the…
A: As per the guidelines of bartleyby I need to answer first question only so kindly repost other…
Step by step
Solved in 2 steps
- You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
- A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
- You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?A 100uf capacitor and a3.6kohm are connected in series. How long will it take for the capacitor to change its charge completely?
- An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coilStep 1 : Show that the voltage division rule for two capacitors in series as in the figure Step 2: For two capacitors in parallel as in the second figure, show that the current division rule is:An inductor of 230 milli Henry, a capacitor of 15 micro farad and a 200 ohm resistor are in series across a 36 V and 60 Hz voltage source. Find the total current a. 150 mA b. 0.164 A c. 0.2 A d. 170 mA