A resistor, R= 452, and an inductor, L = 1.3 H, are connected in a circuit to a voltage source as shownin Figure (a) (an RL circuit). i() v (V) A 12 0.5 I (s) (b) When the voltage source applies a rectangular voltage pulse with an amplitude of V= 12 V and a durationof 0.5 s, as shown in Figure (b), the current i(t) in the circuit as a function of time is given by: (t) = (V/R)(1-e(-RO/L) for 0

A resistor, R= 452, and an inductor, L = 1.3 H, are connected in a circuit to a voltage source as shownin Figure (a) (an RL circuit). i() v (V) A 12 0.5 I (s) (b) When the voltage source applies a rectangular voltage pulse with an amplitude of V= 12 V and a durationof 0.5 s, as shown in Figure (b), the current i(t) in the circuit as a function of time is given by: (t) = (V/R)(1-e(-RO/L) for 0

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
1)The value of the capacitance reactive power in VAR is? /2) The value of the capacitor in micro farad is?
A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.
A capacitor in series with a 20-KO resistance across a 10 V ac source. What size C is needed for equal voltage across R and Xc at frequency of 100 Hz and 100 KHz.
A resistor and a capacitor are connected in series across a supply of 250 V. When the supply frequency is 50 Hz the current in the circuit is 5 A. When the supply frequency is 60 Hz, the current is 5.8 A. Find the value of the resistance.
Describe the behavior of the voltage across the resistor with time as thecapacitor charges. Explain the reason for this behavior.
low voltage systems What is the general reason for selecting the capacitor voltage with a value greater than 400 V (such as 415,445 V) in Reactive Power Compensation? a) Reduce losses b) Harmonics C)Current decrease d) Voltage drop
A capacitor C is connected in parallel with a resistance R across a 60-V, 100 Hzsupply. The supply current is 0.6 A at a power factor of 0.8 leading. Calculatethe value of R and C.
In a series circuit with the following devices to a 230volts 60Hz supply with a resistor in the range of 300 ohms and 990 ohms. What are the steps in calculating the impedance ...
Using the series circuit in Figure 3 consisting of a voltage source V, the resistor R and the fully uncharged capacitor C, how to find the value of the capacitance C considering as known data the time constant of the circuit T and the value of the resistor R? V ww R