Answered: A router receives a packet with…

A router receives a packet with destination address 205.12.48.91 Show how it finds the network and the subnetwork address to route the packet. Assume the number of subnetwork required is four.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 10VE

See similar textbooks

Related questions

Q: router with IP address 125.45.23.12

Q: Consider a two-link network in which Host A has a 1 Mbps connection with a 10 ms propagation delay…

A: Intro The question is about to Consider a two-link network in which Host A has a 1 Mbps connection…

Q: . A router receives a packet with destination address 196.77.26.206 Show how it finds the network…

A: An IPv4 address consists of 32 bits. A unique identifier for computers connecting to a network is an…

Q: n a network using datagrams, a new route is calculated _____.

A: c.for every packet

Q: Suppose two packets arrive to two different input ports of a router at exactly the same time. Also…

A: a.Fabric uses a shared bus: To prevent data collisions and maintain traffic, only one user can…

Q: What is the total delay of the new packet in arriving at Router B, i.e., how long does it take the…

A: Given: Length of packet (L)=15,000 Transmission rate (R)= 0.05 mbps Number of packet per wave (N)=…

Q: For the given network diagram, suppose an application running on Host 1 transmits a packet towards…

A: (A) Process of packet encapsulation and de-capsulation alon tha path from Host 1 to Host 2. host 1…

Q: If delays are recorded as 10 bit numbers in a 50 router network, and delay vectors are exchanged…

A: Given that: If delays are recorded as 10 bit numbers in a 50 router network, and delay vectors are…

Q: A router receives a packet with destination address. IP address (212.5.247.198) Show how it…

A: IPv4 address are consist of 32 bits. A unique identifier for computers connecting to a network is an…

Q: A router receives a packet with destination address Show how it finds the network and the subnetwork…

A: Given information: - IP: - 219.162.105.107

Q: A router receives a packet with destination address Show how it finds the network and the subnetwork…

A: IPv4 address are consist of 32 bits. A unique identifier for computers connecting to a network is an…

Q: P2. Suppose two packets arrive to two different input ports of a router at exactly the same time.…

A: a. Explanation: “No”, it is not possible to forward the packets through the switch at the same time…

Q: Given a TCP host whose MSS and CW values are both set to 1,460 bytes, what will the value of CW be…

Q: Assume that the propagation speed is 2 × 108 meters/sec, and the distance between source and…

A: Answer: Given, Data packet size L = 300Mb(Megabits) = 3*10^6 bits. Transimission rate R = 10 MBps…

Q: What does a router do when it gets a packet with a destination network address that is unknown to…

A: Provided the solution for above given question as shown below.

Q: A router receives a packet with destination address 196.77.26.206 Show how it finds the network and…

Q: nd subnet mask of each subnet. (Choose any class C address)

A: Subnet Mask and IP Address A 32-bit IP address identifies a single device on an IP network. The…

Q: 4. Consider the following two causes of 1-second network delay (assume ACKS return instantaneously):…

A: a. If we send 1 packet, then in either case we see a 1 sec RTT. If we send a burst of 10 packets,…

Q: - Suppose a router has built up the routing table shown in Table 3.19. The router can deliver…

A: Solution::

Q: IP, ARP, IGMP and ICMP all run in network layer. How does a computer know if an arriving frame…

A: The following is the solution

Q: Suppose that between a sending host and a receiving host there is exactly one packet switch. The…

A: At time t0 the sending host begins to transmit. At time t1 = L/R1, the sending host completes…

Q: 10. Suppose a computer sends a frame to another computer on a bus topology LAN. The physical…

A: We need to answer questions related to layers of OSI model or TCP/IP model.

Q: A router receives a packet with destination address (222.186.114.16) Show how it finds the network…

A: IPv4 address are consist of 32 bits. A unique identifier for computers connecting to a network is an…

Q: Consider a computer 1 that communicates with a computer 2 via LAN1, router R1, and LAN2. The sending…

A: Answer :

Q: Given, a network address of 161.0.0.0/10. Using the figure above and by applying VLSM technique,…

A: 161.0.0.0 /10 /10 means number of network bits is 10 and number of host bits is 22. For subnetting…

Q: 1. A router receives a packet with destination address (please refer to the table attached to find…

A: IPv4 address are consist of 32 bits. A unique identifier for computers connecting to a network is an…

Q: A router uses the following routing table- Destination Mask Interface 144.16.0.0 255.255.0.0 etho…

A: the interface on which the destination address with 144.16.68.117 is forwarded is detailed in step…

Q: - Suppose a TCP message that contains 1024 bytes of data and 20 bytes of TCP header is passed to IP…

Q: A network system has 5 protocol layers. Applications generate messages of length M bytes. At each of…

A: Answer: a. 5h/(5h+M)

Q: ssume that 2 packets arrive simultaneously to a switch at which one other packet is halfway done…

A: The value 0.027 seconds is correct but the method is unclear. The other comment provides the correct…

Q: Multi-hop network: Given two hosts A and B, and one router between them. Packet size is L bits…

A: Given Data : Packet Size(k) = L bits Bandwidth(b) = R bps One Router is in between A and B…

Q: A network system has 5 protocol layers. Applications generate messages of length M bytes. At each of…

A: If a netwrok system has ‘n’ protocol layers. Applications generate messages of length ‘M’ bytes. At…

Q: router interconnects a subnet

A: Solution is given below:

Q: Assume a computer transmits a packet to another computer on the Internet at the network layer. The…

A: It tells about a computer transmits a packet to another computer on the Internet at the network…

Q: 1. Consider the network depicted in Figure 1. Here, we have a sender, a receiver, and four routers.…

A: Transport Layer Packets(All are same as the port number does not change) 1. Hop1

Q: 01. Suppose a router has built up the routing table shown below: Subnet Subnet mask Next hop number…

A: The Answer is

Q: QUESTION 5: Assume the hosts and routers use classless IPv4 addressing scheme. Routing Table for…

Q: 1. A router receives a packet with destination address (222.186.114.16) Show how it finds the…

A: The answer is

Q: Suppose a router has built up the routing table shown in Table 3.19. The router can deliver packets…

Q: A router receives a packet with destination address Show how it finds the network and the subnetwork…

A: The computer sends the IP to the nearest router. When router gets the packet, it looks for…

Q: Assuming that all routers and hosts are working properly and that all software in both is free of…

Q: Let's imagine that a computer on the Internet transmits a packet to another computer at the network…

A: Answer:

Q: ppose that Router A and Router B are connected via a 0.05 Mbps link (note, 1 Mbps = 106 bps) and…

Q: Given a link with a maximum transmission rate of 34.1 Mbps. Only two computers, X and Y, wish to…

A: Given, =>Bandwidth(B) = 34.1Mbps =>Transmission start time (t) = 0 =>File X size = 19 MB…

Q: The following describes what a router does when it receives a packet with an unknown destination…

A: Unknown network: If the address in the packet matches one of the entries in the routing table, the…

Q: 1. A router receives a packet with destination address (222.186.114.16) Show how it finds the…

A: Given : router receives a packet with destination address 222.186.114.16 We have to find out the…

Q: Suppose a router has built up the routing table shown in Table 3.19. The router can deliver packets…

Concept explainers

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.

Question

A router receives a packet with destination address 205.12.48.91

Show how it finds the network and the subnetwork address to route the packet. Assume the number of subnetwork required is four.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

A router receives a packet with destination address 196.77.26.206 Show how it finds the network and the subnetwork address to route the packet. Assume the number of subnetworks required is four.
A router interconnects a subnet, where all the interfaces of the subnets must have the prefix 164.132.62/24. suppose that the Subnet is required to support up to 60 interfaces, provide a network address that satisfies the above.
A packet switch receives a packet and determines the outbound link to which the packet should be forwarded. When the packet arrives, one other packet is halfway done being transmitted on this outbound link and four other packets are waiting to be transmitted. Packets are transmitted in order of arrival. Suppose all packets are 1,500 bytes and the link rate is 2 Mbps. What is the queuing delay for the packet? More generally, what is the queuing delay when all packets have length L, the transmission rate is R, x bits of the currently-being-transmitted packet have been transmitted, and n packets are already in the queue?
An IP address can be written as a 32-bit number. For a class B network, the two most significant bits are set to 10. The 16 most signi cant bits are used as a network ID, and the 16 least signi cant bits are used as a host ID. However, the host ID cannot be all 0's or all 1's. How many hosts (i.e., host IDs) can there be on a class B network?
- Suppose a TCP message that contains 1024 bytes of data and 20 bytes of TCP header is passed to IP for delivery across two networks interconnected by a router (i.e., it travels from the source host to a router to the destination host). The first network has an MTU of 1024 bytes; the second has an MTU of 576 bytes. Each network's MTU gives the size of the largest IP datagram that can be carried in a link-layer frame. Give the sizes and offsets of the sequence of fragments delivered to the network layer at the destination host. Assume all IP headers are 20 bytes.
A router receives a packet with destination address IP: 201.10.64.199 (please refer to the table attached to find the IP address) Show how it finds the network and the subnetwork address to route the packet. Assume the number of subnetwork required is four.
Using packet tracer, implement a network that has the following components: 1- At least five routers 2- At least 7 subnets 3- At least 12 PCs 4- At least 4 switches 5- Use RIP routing protocol To assign IP addresses of the routers and PCs, use the IP address from your ID as follows Assume your id is 118zyxw, Consider the numbers z, y, x and w as deciemal You have the subnet 118.0.0.0/24 If your ID is 1181234 then the IP is 118.0.0.0/24 Use this subnet to get at least 7 subnets.
An IP address can be written as a 32-bit number. For a class B network, the two most significant bits are set to 10. The 16 most significant bits are used as a network ID, and the 16 least significant bits are used as a host ID. However, the host ID cannot be all 0's or all 1's. How many hosts (i.e., host IDs) can there be on a class B network?
A workstation uses the HTTP protocol to download a large file from a web server. No proxy server is used. One router's queue is full when one of the web server's packets arrives.Select the four best statements to describe this situationa. The router stores the packet until such time that it can be sent.b. Further packets sent by the server are transmitted at a higher rate to compensate for the lost packet.c. The router sends an ICMP link congested message to the server.d. The packet must be retransmitted.e. Router configuration and network behavior could be improved by configuring FQ or WFQ.f. Further packets sent by the server are transmitted at a lower rate to reduce the load on the congested link.g. Router configuration and network behavior could be improved by configuring RED or WRED.h. A tail drop will happen.
A router receives a packet with destination address. IP address (212.5.247.198) Show how it finds the network and the subnetwork address to route the packet. Assume the number of subnetwork required is four.
4. A router receives a packet with destination address 196.77.26.206 Show how it finds the network and the subnetwork address to route the packet. Assume the number of subnetworks required is four. Please solve it using the keyboard, not using the hand, and quickly, and I hope that the solution is correct.
TCP session sends 50 packets per second over an Ethernet Local Area Network (LAN). Each packet consists 2280B (excluding the preamble and cyclic redundancy check (CRC)). Calculate the size of the headers, and hence the TCP payload data. What therefore is the TCP throughput of the session?