Answered: A sample containing BTEX What is the…

Science

Chemistry

A sample containing BTEX What is the appropriate quantitative and qualitative analysis method for it in the laboratory?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.4QAP

See similar textbooks

Related questions

Q: Consider thé following statement: Statement I: Matrix is equal to blank plus the analyte. Statement…

A: Matrix: Matrix refers to the components of a sample other than the analyte of interest. Analyte: a…

Q: The chloride in a sample is to be determined gravimetrically by precipitation and weighing AgCl.…

A: The answer is 2.47g. Here in this question 1. First you have to find out moles of AgCl so that you…

Q: After going through the results of your first method validation experiment with your PI, you decide…

A: Titration is the process, through which we determine the concentration of unknown solution by…

Q: Which of the following techniques would NOT result in a titration error? a. Adding 100mL of…

A: Please find your solution below : Titration is a method of quantitative analysis which is used to…

Q: A hydrochloric acid solution is standardized by titrating 0.4541 g of primary standard…

A: Given:The mass of primary standard tris(hydroxymethyl)aminomethane = 0.4541 g. Volume = 35.37 mL =…

Q: A titration requires an indicator molecule or substance. O True O False

A: Given statement is : "A titration requires an indicator molecule or substance". Is the given…

Q: What is a qualitative test and what is a quantitative test?

A: A quantitative analysis where the amount of substance is calculated present in the sample by…

Q: Suppose you are titrating an acid of unknown concentration with a standardized base. At the…

A: The solution is given below -

Q: ered items or incomplete statements is followed by answers or by completions of the statement. ered…

A: Question 27: The Quality coordinating office is the quality control department maintain and store…

Q: Assuming that the uncertainty in the readings does not change, why is it not acceptable to base…

A: Reducing uncertainty in titration is important to determine the desired concentration or the…

Q: definition: __________ __________ is a laboratory method for determining the presence or absence of…

A: Solution- Introduction Qualitative Analysis: It is a branch of chemistry in which deals with…

Q: c. You have titrated the first sample of your unknown sample. Using the average molarity of the…

A: From part-(b), the average molarity of potassium permanganate, KMnO4(aq) is 8.108*10-3 M #Trial-1…

Q: In the experiment, the amount of acetic acid in vinegar was determined by titrating with 0.1 M NaOH…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: he Kjeldahl analysis is used to determine the protein content of foods. The food analyzed is heated…

A: The main element that is present in protein in nitrogen, since proteins are made of amino acid that…

Q: What mass of FeSO4.(NH4)2SO4. 6H2O is present in a sample if it is titrated to its equivalence point…

A: Given: Volume of KMnO4 = 4.100 mL Concentration of KMnO4 = 0.100 N mass of FeSO4.(NH4)2SO4.…

Q: analysis

Q: a) A titration is a method of analysis in which the result is achieved by the measurement of volume.…

A: A titration is a quantitative technique where the concentration of an unknown solution is determined…

Q: What quantity of sample should be taken for the analysis if it contains 16.2% chloride and the…

A: Given that : % of Chloride contained in the sample = 16.2 % Mass of AgCl precipitate to be obtained…

Q: Briefely explain the meaning of the following terms as they relate to this experiment. a) Titration…

A: The brief explanations are given below -

Q: In performing the Alkalinity of Streams and Lakes activity, a student collects the following data.…

Q: A 0.9600 M NaOH solution was diluted with a factor of 4. Then the diluted solution of NaOH was…

A: In order to find whether the given acid is monoprotic, diprotic or triprotic we first write down…

Q: The titration of 25.0 mL of an iron(II) solution required 18.0 mL of a 0.115 M solution of…

A: Net ionic equation for the reaction between iron(II) and dichromate is shown below. Number of moles…

Q: A sample of freshly precipitated and filtered silver chloride weighs 459.0 mg. If 1.00 % of the…

A: The chemical equation representing the decomposition reaction of silver chloride is shown below.

Q: In the experiment conducted to determine the amount of acetic acid in vinegar, 8.2 mL of a 0.098 M…

A: Molarity of a solution is equal to the number of moles of solute present in one liter of solution.…

Q: Titration of Purpose: To find the molarity (M) of acetic acid in vinegar by titration with a…

Q: In the experiment conducted to determine the amount of acetic acid in vinegar, 8.2 mL of NaOH…

Q: What is the purpose of a titration? How is it performed (in general)?

Q: 0.5366 g of an KHP sample of unknown purity was massed. The sample was dissolved in approximately…

A: The reaction between NaOH and KHP can be shown as,

Q: The student weighs out 0.18 g of a diprotic unknown acid and dissolves it in approximately 50 mL of…

A: Since the acid is diprotic hence moles of NaOH required to reach end point = moles of acid X 2…

Q: What is the concentration of the unknown HCl solution given the initial buret reading of the…

A: The solution of the question is given below:

Q: Standardizing the 0.1 M HCI using standardized 0.1M sodium hydroxide solution No. of titration…

Q: You are hired by a company producing vitamins. Knowing that you have background in analytical…

A: We are tasked to analyze vitamin C.

Q: In the course of various qualitative analysis procedures, the following mixtures are encountered:…

A: It is given that in a qualitative analysis procedure, mixtures are there which contain Ag+ and Mn2+…

Q: Q3. There is a mixture including some cations and it is aimed to separate and analyze some of the…

A: Qualitative analysis of cations:

Q: How many moles of hydrochloric acid were there in the volume of acid added in the titration? ii)…

Q: 1. This is the mass of the substance that is chemically equivalent to a cubic centimeter (cc) of the…

A: Interpretation: To write one word for the following given statements.

Q: what is a soluble reactivity shim?

A: Soluble poisons are called chemical shim, produce a spatially uniform neutron absorption when…

Q: Which is NOT TRUE about performing a BLANK titration? Choose the best answer. O It involves…

Q: Volume of sulfuric acid in sample (ml) Initial burette reading (ml) Final burette reading (ml) Total…

A: Using the stoichiometric ratio of KOH and H2SO4 , average volume of KOH, and average volume of H2SO4…

Q: Gravimetric Analysis. Please include complete solution, thank you. In the gravimetric…

Q: give a example of a acid-based titration and give a equation

A: An acid is a substance that can release H+ ions in the solution and a base is substance that…

Q: When a standard solution is brought into a reaction, the point at which the reaction is exactly…

A: Titration is a conventional technique to evaluate the quantity of analytical present in a sample…

Q: A chemist needs to determine the concentration of a sulfuric acid solution by titration with a…

A: Given, Molarity of standard sodium hydroxide (MNaOH) = 0.1834M. Volume of NaOH = 13.96mL. Volume of…

Q: If 18.50 mL of 0.1173 N Sodium Hydroxide and 20 mL of sulfuric acid were utilized to reach the…

Q: A 2.00 L graduated cylinder contains 1.40 L of buffer solution. The density of the buffer solutionis…

A: Density ( d ) :- It is defined as the ratio of mass of a substance to volume occupied by the…

Q: MaVa=MbVb can be used for simple strong acid-strong base titration calculations. Suppose 125 mL of…

A: Given- Mb=1.73M Vb=43mL Va=125mL

Q: A 25.0mL acetic acid sample was titrated using exactly 69.72 mL of a 0.30M sodium hydroxide solution…

A: Given reaction is- CH3COOH(aq) + NaOH(aq) → CH3COONa(aq) + H2O(l) i.e- 1 mole of CH3COOH reacts…

Q: A student performed a titration on a commercial acid certified to be 0.500 M. Using her data from…

A: The percent error is calculated by the formula, Percentage error=Measured balue-True valueTrue…

Q: give a specific example of gravimetry analysis by enumerating the steps of the analysis

Question

100%

A sample containing BTEX What is the appropriate quantitative and qualitative analysis method for it in the laboratory?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
Describe in words the titration of an acid with a base. Be sure to use the terms equivalence point, indicator, and end point correctly.
Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?
A student weighs out a 4.80-g sample of aluminum bromide, transfers it to a 100-mL volumetric flask, adds enough water to dissolve it, and then adds water to the 100-mL mark. What is the molarity of aluminum bromide in the resulting solution?
A student was given a 1.6240-g sample of a mixture of sodium nitrate and sodium chloride and was asked to find the percentage of each compound in the mixture. She dissolved the sample and added a solution that contained an excess of silver nitrate. The silver ion precipitated all of the chloride ion in the mixture as silver chloride. It was filtered, dried, and weighed. Its mass was 2.056g. What was the percentage of each compound in the mixture?
ssume a highly magnified view of a solution of HCI that allows you to “see” the HCl. Draw this magnified view. If you dropped in a piece of magnesium, the magnesium would disappear, and hydrogen gas would he released. Represent this change using symbols for the elements, and write the balanced equation.
In most of its ionic compounds, cobalt is either Co(II) or Co(III). One such compound, containing chloride ion and waters of hydration, was analyzed, and the following results were obtained. A 0.256-g sample of the compound was dissolved in water, and excess silver nitrate was added. The silver chloride was filtered, dried, and weighed, and it bad a mass of 0.308 g. A second sample of 0.416 g of the compound was dissolved in water, and an excess of sodium hydroxide was added. The hydroxide salt was filtered and heated in a flame, forming cobalt(III) oxide. The mass of cobalt(III) oxide formed was 0.145 g. a. What is the percent composition, by mass, of the compound? b. Assuming the compound contains one cobalt ion per formula unit, what is the formula? c. Write balanced equations for the three reactions described.
On the basis of the general solubility rules given in Table 6-1, predict which of the following substances are likely to be soluble in water. a. zinc chloride b. lead(II) nitrate c. lead(II) sulfate d. sodium iodide e. cobalt(III) sulfide f. chromium(III) hydroxide g. magnesium carbonate h. ammonium carbonate
Lead poisoning has been a hazard for centuries. Some scholars believe that the decline of the Roman Empire can be traced, in part, to high levels of lead in water from containers and pipes, and from wine that was stored in leadglazed containers. If we presume that the typical Roman water supply was saturated with lead carbonate, PbCO3 (Ksp = 7.4 1014), how much lead will a Roman ingest in a year if he or she drinks 1 L/day from the container?
The procedures and principles of qualitative analysis are coy cred in many introductory chemistry laboratory courses. In qualitative analysis, students learn to analyze mixtures of the common positive and negative ions, separating and confirming the presence of the particular ions in the mixture. One of the first steps in such an analysis is to treat the mixture with hydrochloric acid, which precipitates and removes silver ion, lead(II) ion, and mercury(I) ion from the aqueous mixture as the insoluble chloride salts. Write balanced net ionic equations for the precipitation reactions of these three cations with chloride ion.
Apply Students conducted a lab to investigate limiting and excess reactants. The students added different volumes of sodium phosphate solution (Na3PO4) to a beaker. They then added a constant volume of cobalt(ll) nitrate solution (CO(NO3)2) stirred the contents, and allowed the beakers to sit overnight. The next day, each beaker had a purple precipitate at the bottom. The students decanted the supernatant from each beaker, divided it into two samples, and added one drop Of sodium phosphate solution to one sample and one drop of cobalt(ll) nitrate solution to the second sample. Their results are shown in Table 11.5. a. Write a balanced chemical equation for the reaction. b. Based on the results, identify the limiting reactant and the excess reactant for each trial.
On the basis of the general solubility rules given in Table 6-1, predict which of the following substances are likely to be soluble in water. a. aluminum nitrate b. magnesium chloride c. rubidium sulfate d. nickel(II) hydroxide e. lead(II) sulfide f. magnesium hydroxide g. iron(III) phosphate